Hertfordshire · England
Bath Re-enamelling in Boxmoor
Full bath re-enamelling and resurfacing in Boxmoor, carried out at your home and guaranteed for a year.
- Resurfacing from £350
- A dull, rough surface that will not come clean
- Lots of chips and rust spots
Different materials, different repairs
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Steel often rusts by the plughole, so we check it carefully.
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
How we handle bath re-enamelling in Boxmoor
The bath stays where it is, so your taps, tiles and plumbing are left alone. It typically takes one visit, with the bath ready to use the following day. We work on Victorian roll-tops, pressed steel baths and basins & shower trays, and people most often call us about an original cast iron bath that needs restoring and a dull, rough surface that won’t come clean.
You get a one-year guarantee, the same in Boxmoor as everywhere else we work.
- Area
- Boxmoor (HP1, HP3, HP2)
- County
- Hertfordshire
- Warranty
- A year, on every repair
- Quotes
- From £350. Fixed and free, based on pictures
- Phone
- 0345 017 0787
- Last updated
- 23 October 2026
Looking after it afterwards
Nothing complicated is needed, just a few sensible habits:
- Have chips seen to early
- Clean with a soft cloth and mild detergent
- Do not leave bottles, razors or sponges standing on the surface
- Leave the bath for the full curing time before using it
Give the finish its full curing time before using the bath. Then, gentle cleaning with a soft cloth is enough.
Rust spots on a worn bath get worse with time, and each one adds to the preparation. Resurfacing before they spread keeps it simpler.
Can I fix it myself?
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is usually the cheaper route.
If you’re set on a kit, follow its instructions closely and work on a clean, dry surface, and do not use it until it has fully cured. If it doesn’t work out, we can still repair it properly.
Boxmoor questions
Will the new finish last?
It depends on preparation, use and care. With good preparation and gentle cleaning it lasts a long time, and it’s guaranteed for a year.
Do you come to Boxmoor?
Yes, we do. Technicians travel to Boxmoor from across the region, with no extra charge for travel.
What happens next?
You get a fixed price and available dates. If anything’s unclear, we’ll ask for another photo.
What information do you need?
A close-up, a wider photo and your postcode. After that, we just agree a date.
Can I get a quote without a visit?
Usually, yes. Clear photos let us give you a fixed quote without visiting.
Is it safe with children and pets around?
On the day, the room should be kept clear of pets and children, so the repair isn’t disturbed while it cures.
Is there a guarantee?
Every repair comes with a one-year guarantee. Ask us what it covers when you get your quote.
Can you do the outside of a roll-top?
Yes, roll-tops are a big part of our work. The inside is resurfaced, and we can refinish the outside as well.
About Boxmoor
Boxmoor is about 1 mile south-west of Hemel Hempstead, in Hertfordshire. Our work suits any type of property, from flats and terraces to detached houses and new builds, plus businesses and rented homes. Our technicians cover 381 places in Hertfordshire, from the larger towns to small villages. Our jobs stretch from Boxmoor to London (about 24 miles away).
Our technicians cover all of HP1, HP3 and HP2. From Cardy Road, Heath Lane and London Road or a nearby road, a technician can come to you. You will find Boxmoor on the A4251, so it’s easy for us to reach. Neighbouring places we cover include Warner's End (1 mile north), Grovehill (1 mile north-east), Woodhall Farm (1 mile north-east), Apsley (1 mile south-east) and Hemel Hempstead (1 mile north-east). Within a short drive, we also cover Watford (7 miles south-east), St Albans (7 miles east), Welwyn Garden City (13 miles east), Harpenden (8 miles north-east), Hatfield (11 miles east) and Borehamwood (11 miles south-east).
Local landmarks in Boxmoor
In Boxmoor, that means homes near Church of St John the Evangelist and Attached Church Hall, Boxmoor Primary School and The Hemel Hempstead School. You will also find Gadebridge Park (1.1 miles north) and Fishery Inn (under half a mile south-west). Boxmoor has its own railway station: Hemel Hempstead station. Nearby you will also find Hemel Hempstead Hospital (0.7 miles north-east). For a walk, there is Long Deans.
What we do, step by step
Here’s how a visit usually runs: we arrive on time, sheet and mask the area around the job, do the job and clear up. Plan for the best part of a day from start to finish. Before leaving, we tell you how long to leave it and how to care for it.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- Several coats of finish are sprayed on, then it cures.
Getting ready for the visit
- Let us know if it has been repaired before
- Point us to the nearest place to park
- Plan for the room to be out of bounds to pets and children
How to get a price
Email us a photo of the damage and a wider shot of the whole item, with your HP1 postcode, and we’ll come back with a fixed quote.
Related advice
Work for landlords and builders
For anyone letting property in or around Boxmoor, we’ll quote for several properties at once. Send pictures for each one and we’ll price them together.
Housing associations and facilities teams use us for planned and reactive repairs. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
Prices and what affects them
Resurfacing from £350. We give every job a fixed quote from photos. These are the things that affect it:
- Previous DIY repairs that have to come out
- Access to the area
- The type of damage
- The colour and finish to match
No two jobs are quite the same, so each one is priced on its own. What’s damaged, how badly and how easy it is to reach all make a difference, and combining jobs on one visit brings the cost down.
Getting a price from photos
Photographing the damage takes a minute. Try to send:
- The postcode, so we can plan the visit
- A wider photo showing the entire bath
- Daylight if possible, and no flash reflection
- One sharp close-up of the damage
Call 0345 017 0787 or use the quote form. With a clear picture of the damage and one of the entire bath, we can price the job the same day in most cases.
Places near Boxmoor
More services for Boxmoor
Honest limits
It helps to know what we can’t do too:
- A bath split right through the body
- A bath that’s rusted through
- Leaks from fittings rather than the bath
Send us photos and we’ll tell you honestly before booking.
Surfaces we repair
- Acrylic baths
- Cast iron baths
- Pressed steel baths
- Victorian roll-tops
- Basins & shower trays
Should you replace it?
A refit takes several trades and several days. Re-enamelling takes one technician and typically one day, and the bath can be used the day after. Prices start from £350. We charge the same wherever you are, so there is no premium for Boxmoor. The job itself decides the price: the material, the amount of damage and how many items.
Why book with us
- No need to remove anything
- A year’s guarantee on all work
- Technicians who travel to you, UK-wide
- Most jobs done in one visit
Take a look at our pricing or bath cost comparison.
About our accreditations · Every repair comes with a one-year guarantee.
