Craigavon · Northern Ireland
Bath Re-enamelling in Portadown
Full bath re-enamelling and resurfacing for homes and businesses in Portadown and across Craigavon. Send photos for a free, fixed quote.
- Resurfacing from £350
- A roll-top that is seen better days
- Lots of chips and rust spots
Bath re-enamelling at your home in Portadown
We resurface cast iron, steel and acrylic baths, including roll-tops and period baths. The finish is sprayed on in several coats over a bonding primer, after the bath has been cleaned, repaired and keyed. Whether it’s an outdated colour you’d like to change and an original cast iron bath that needs restoring, we can normally put it right.
Peace of mind is built in: our one-year guarantee applies to every job, and we explain what it covers before booking.
- Where
- Portadown (BT62)
- County
- Craigavon
- Warranty
- 12 months on all our work
- Quote
- From £350. Free, fixed quote from pictures
- Phone
- 0345 017 0787
- Last updated
- 23 October 2026
Repairs by material
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
Acrylic
Acrylic is light and warm to the touch, but it needs firm support underneath. Cracks are strengthened from behind before the front is finished.
Portadown: your questions answered
Will the price change on the day?
The price is fixed for what the pictures show. If there is more, we’ll tell you before starting.
How quickly can you book me in?
It depends on the time of year and where you are. We will offer you dates when we send your quote.
How long will the bath be out of use?
Most baths are done in a day, ready the following day. We give you timings with the quote.
Does re-enamelling smell?
There is some smell while the coating is applied, which is why we ventilate the bathroom. It clears as the finish cures.
Do you charge for travel?
Travel is included in the price, and we charge the same wherever you are.
Can pets and children be at home?
We ask you to keep children and pets out of the room while we work. The rest of the house is unaffected.
Can you do the outside of a roll-top?
Yes, frequently. We resurface the inside, and the outside can be refinished too.
Do I need to be at home?
Yes. We need access to the room while we work, at a time we agree with you.
What happens on the day
A typical visit goes like this: we arrive on time, sheet and mask the area around the job, do the job and tidy away. Plan for a full day from start to finish. Before leaving, we tell you when it can be used and how to look after it.
- The room is masked, protected and ventilated.
- We clean and degrease the bath and repair any chips or rust.
- The surface is prepared and a bonding primer applied.
- We spray several coats of new enamel finish.
- We leave it to cure, and it’s typically ready the following day.
Before we arrive
- Make sure the room can be ventilated
- Mention if the room is upstairs or in a flat
- Let us know about parking or access
Getting a price
Call 0345 017 0787 or use the quote form. With one close-up and one wider picture, we can give you a fixed quote without visiting.
Related advice
Prices and what affects them
Prices start from £350. We don’t charge extra for travel to Portadown. The price comes down to:
- The material and finish
- Where the damage is and how we get to it
- Whether old repairs or coatings need taking off
- How much damage there is
What it costs depends on how much damage there is and what kind, what it’s made of and how many jobs we combine into one visit. You get a fixed price from your photos, so you know the cost before booking.
Send pictures for a quote
It only takes a minute to photograph the damage, and it saves a visit. Please include:
- Good light, ideally daylight, without flash glare
- Any earlier repairs or coatings
- The material, if you know it
- One sharp close-up of the damage
A quote takes minutes to ask for: take one close-up and one wider shot of the bath, add your postcode and send them over. What comes back is a fixed price, not a guess.
What else we do in Portadown
Should I try a DIY kit first?
You can buy a DIY kit for most repairs, and they can make a small mark look better. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.
What we can’t put right
Some jobs are not right for a repair, including:
- A poorly supported acrylic bath, until it’s firmed up
- Problems we cannot see until an old finish comes off
- A bath split right through the body
If in doubt, send photos and we will say what we think.
Surfaces we repair
- Basins & shower trays
- Cast iron baths
- Acrylic baths
- Pressed steel baths
- Victorian roll-tops
Our work in Portadown
Portadown is about 4 miles south-west of Craigavon, in Craigavon. We visit clients in Portadown and the surrounding area, so you do not need to take anything anywhere.
Our technicians cover all of BT62 and the streets around it. Neighbouring places we cover include Craigavon (4 miles north-east), Lurgan (6 miles north-east), Armagh (7 miles south-west), Banbridge (10 miles south-east) and Dungannon (12 miles north-west). Remote and island addresses take a little more planning, so it’s best to call first.
Local landmarks in Portadown
Locally, our jobs take us to homes close to Armagh Road Presbyterian Church, Clounagh Junior High School and Millington Primary School. Nearby you’ll also find Castleraw (4.4 miles west) and Craigavon Area Hospital (2.7 miles north-east).
Landlord and trade work in Portadown
If you manage property in Portadown, we’ll quote for several properties at once. Send pictures for each one and we’ll come back with a combined price.
For developers and builders, we fix damage before handover, saving last-minute replacements. Several plots can be done in one visit to keep costs down.
Do you need bath re-enamelling in Portadown?
Enamel doesn’t fail overnight. Abrasive cleaners, limescale and years of use wear the gloss away, normally first under the taps and around the waste.
The most common problems we’re called about are:
- A coating lifting around the plughole
- Stains that will not shift
- Lots of chips and rust spots
- A period or roll-top bath worth keeping
Before you book anyone
- How the room is protected while they work
- Whether cleaning and preparation are in the price
- The length of the guarantee and what it covers
- How long it needs to cure
Keeping it looking good
Nothing complicated is needed:
- Don’t let dyes or oils sit on the finish
- A quick wipe after use keeps limescale away
- Clean with a soft cloth and mild detergent
- Don’t leave a chip unrepaired
Avoid hair dye, bath bombs and oils sitting on the surface, as they can stain. Repair dripping taps promptly.
Worn enamel only gets rougher with time, and any rust spreads underneath. Acting earlier keeps the preparation simpler.
About our accreditations · Every repair comes with a one-year guarantee.
