Lincolnshire · England
Bath Re-enamelling for Whisby homes
Our technicians come to Whisby for full bath re-enamelling and resurfacing. Everything is done in place, and the work is guaranteed.
- Resurfacing from £350
- Worn patches where water runs and sits
- A roll-top that’s seen better days
Prices and what affects them
Prices start from £350. A fixed quote means you know the cost before booking. We look at:
- The material and finish
- Unusual colours or finishes
- Whether old repairs or coatings need taking off
- Where the damage is and how we get to it
Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Photos let us give you the exact figure.
How to get a fixed quote
Good pictures mean an accurate price. Here’s what helps:
- Where you are, by postcode
- Natural light rather than flash
- Something in shot to show the size
- Any earlier repairs or coatings
Call 0345 017 0787 or use the quote form. With a clear picture of the damage and one of the whole bath, we can price the job.
Bath re-enamelling in Whisby, done in place
We re-enamel a lot of period and roll-top baths, which are heavy, hard to move and costly to replace. Resurfacing them in place keeps the original bath. We regularly repair Victorian roll-tops, pressed steel baths and cast iron baths, and people most often call us about a bath that stays dull however much you clean it and thin, worn enamel in places.
The work is covered for a year after we finish. If anything isn’t right, ring us and we’ll sort it.
- Location
- Whisby (LN6)
- Area hub
- Lincolnshire
- Guarantee
- 12 months on all our work
- Quote
- From £350. Fixed and free, based on photos
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Repair or replace in Whisby?
A refit takes several trades and several days. Resurfacing is one technician, normally in a day, with the bath ready the next day. Our bath re-enamelling starts from £350. Compared with replacing, a repair is generally a fraction of the price, because nothing has to be taken out, refitted or made good. Your fixed quote shows exactly what’s included.
Why book with us
- Straight answers about what a repair can do
- Free fixed quotes from pictures
- CHAS, Constructionline and SafeContractor accredited
- Rooms protected and left tidy
Read our prices page or guide to resurfacing and replacement costs.
Covering Whisby
Whisby is about 2 miles west of North Hykeham, in Lincolnshire. Whether you are in the middle of Whisby or on the outskirts, we offer exactly the same service: a fixed quote, a tidy visit and a guarantee. Whisby is one of 732 places in Lincolnshire where we work. Our nearest city page is Leeds, about 56 miles away.
Here we cover the LN6 postcode area. If you’re just outside Whisby, we cover Thorpe on the Hill (1 mile south), Eagle Moor (1 mile west), Eagle (2 miles west), South Hykeham (2 miles south-east) and Morton Hall (2 miles south-west). Larger places within reach include Lincoln (5 miles north-east), Gainsborough (15 miles north), Hykeham (3 miles east), Ermine (6 miles north-east), Waddington (5 miles east) and Bracebridge Heath (5 miles east).
What’s near Whisby
We visit homes around North Kesteven School and the streets around them. The closest station to Whisby is Hykeham station, roughly 2 miles east. Further afield, we also cover the area around 50 and 61 Squadron Museum (2.4 miles north-east) and St John's Hospital (4.8 miles east). Not far away are Brayford Pool and Tunman Wood.
What happens on the day
On the day itself, there is little for you to do. Show us the job, point us to the room, and we’ll get on with it. The job generally runs to most of the day, including clearing up.
- The room is masked, protected and ventilated.
- We clean and degrease the bath and repair any chips or rust.
- We key the surface and put on a bonding primer.
- Several coats of new finish are sprayed on.
- Once cured, normally by the next day, the bath is ready.
How to prepare
- Tell us about parking, stairs or access
- Clear the area around the damage
- Mention any earlier repairs or resurfacing
Ask for a price
To get a price, send a couple of photos through our quote form or call us. We’ll say immediately if a repair is the right fix.
Read more
How to look after the repair
Nothing complicated is needed:
- Fix dripping taps quickly
- A quick wipe after use keeps limescale away
- Do not leave a chip unrepaired
- Don’t use the bath until it has fully cured
Give the finish its full curing time before using the bath. Then, gentle cleaning with a soft cloth is enough.
Leave a peeling coating alone. Moisture gets underneath and makes it worse, so it’s better to have it stripped and redone.
Also in Whisby
Materials and what they mean for the repair
Pressed steel
Steel baths and trays have a thin metal body under the enamel. Exposed steel rusts quickly, so we treat and seal the metal before filling.
Acrylic
Acrylic baths can be resurfaced too, using a system that bonds to acrylic. The bath needs to be firm and well supported.
When a repair is not the answer
Not everything can be repaired, and we’d rather say so up front. Repairs won’t solve:
- Plumbing leaks, which need a plumber
- Damage hidden under a previous coating, until it’s stripped back
- Acrylic that moves when you stand in it
If in doubt, send pictures and we’ll say what we think before booking.
Materials we repair
- Victorian roll-tops
- Acrylic baths
- Pressed steel baths
- Cast iron baths
- Basins & shower trays
Your questions about bath re-enamelling in Whisby
Can you change the colour of my bath?
Yes, most people go for white. Mention the colour you want when you send pictures.
What if the damage is worse than the photos show?
The price is fixed for what the photos show. If there’s more, we will tell you before starting.
Do you come to Whisby?
Yes, we do. Repair technicians travel to Whisby from across the region, with no extra charge for travel.
Can I get a quote without a visit?
Nearly always. If pictures do not show enough, we’ll ask for another angle.
Do you do work for letting agents?
Yes, frequently. We can quote for several properties together and work between tenancies.
Can you fix a peeling bath coating?
Normally, yes. We strip the failing coating and resurface it properly. Tell us about it when you ask for a quote.
Are you accredited?
We are accredited with CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile.
Can you redo someone else’s repair?
Yes, regularly. It can add a little time, which we include in the quote.
Landlord and trade work in Whisby
We regularly price jobs from inventory or check-out pictures. That means we can quote before you even visit the property, and we can arrange access with the tenant directly if that helps.
We regularly work with letting and managing agents. Send the address, photos and access details and we’ll handle the rest.
What we’re called out for in Whisby
Sometimes it’s an earlier resurfacing that has failed, peeling around the waste or bubbling. We strip what’s failing and start again.
Common reasons people in Whisby contact us include:
- Lots of chips and rust spots
- Worn patches where water runs and sits
- A peeling or bubbling previous coating
- A period or roll-top bath worth keeping
Comparing quotes
- How changes to the job are handled
- Aftercare advice
- What protection goes down before work starts
- Whether there are any call-out or travel charges
About our accreditations · Every repair comes with a one-year guarantee.
