Gloucestershire · England
Bath Re-enamelling in Ganborough
We travel to Ganborough for full bath re-enamelling and resurfacing. Everything is done in place, and the work is guaranteed.
- Resurfacing from £350
- Thin, worn enamel in places
- A coloured bath you want in white
About our bath re-enamelling in Ganborough
Cast iron and steel baths are ideal for re-enamelling, and we can resurface acrylic baths as well. The result is a smooth, even, glossy finish. If you’re dealing with stains that won’t shift and worn patches where water runs and sits, we can normally put it right, whatever the material.
You’re covered after we leave: each job carries a one-year guarantee, and we will explain exactly what it covers when we quote.
- Area
- Ganborough (GL56)
- Region
- Gloucestershire
- Warranty
- One year on every repair
- Quote
- From £350. Fixed and free, based on pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Should I try a DIY kit first?
The difference between a kit and a professional repair is mostly in the preparation and colour. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
You can buy a DIY kit for most repairs, and they can make a small mark look better. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
Places near Ganborough
Also in Ganborough
Looking after it afterwards
Once the work has cured, treat it gently:
- Rinse off hair dye, oils and bath bombs right away
- Respect the curing time we give you
- Fix dripping taps quickly
- Stick to gentle, non-abrasive cleaners
The first few days matter most: let it cure fully, then use mild cleaners only. After that, no abrasives and no suction mats.
The longer worn enamel is left, the rougher it gets, and any rust spreads underneath. Acting earlier keeps the preparation simpler.
How it works
We turn up when we said we would and checks the damage against your pictures first. Dust sheets and masking tape go down before we open a single tin. The work itself takes the best part of a day, and we leave the room as we found it.
- First we look the bath over and confirm the finish.
- Everything around the bath is masked and covered.
- The bath is degreased, repaired and keyed.
- We apply the primer and then the finish coats.
- We remove the masking, tidy up and give you the curing time.
Preparing for the visit
- Let us know which floor the room is on
- Let the surface dry out before the visit
- Keep children and pets away from the room on the day
Ask for a price
Pricing is simple: snap the damage close up and then the entire item, send them over with your postcode, and we will reply with a fixed quote. There is no charge for the quote and no obligation.
Advice
Different materials, different repairs
Pressed steel
Steel baths and trays have a thin metal body under the enamel. Once a chip exposes it, rust follows quickly, so the metal is treated and sealed before the repair.
Cast iron
Cast iron baths are the classic candidate for re-enamelling. The body lasts for generations; only the enamel wears, so a new finish makes them look new again.
Ganborough questions
How soon can you come?
We will give you dates with your quote. Tell us if you need it done quickly.
Does the bath have to be removed?
No. It’s re-enamelled where it stands, so nothing else is disturbed.
Is there a call-out fee?
There’s no separate call-out charge. Your fixed quote includes everything.
Is there a smell?
Yes, while we are applying the finish. Ventilation keeps it down, and it fades as the finish cures.
What areas do you cover?
The entire UK, including all of Gloucestershire. Just include your postcode and we will confirm dates.
I’m a tenant. Can you help?
Yes. Check with your landlord; we can send the quote to them too.
Can I get a quote without a visit?
Yes, almost always. A close-up and a wider photo are enough to give a fixed quote.
Are you accredited?
We’re accredited with CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile.
What bath re-enamelling costs
Resurfacing from £350. You won’t pay by the hour. The price is based on:
- Whether we combine several jobs
- How many areas need work
- The type of damage
- Whether old repairs or coatings need taking off
A repair is priced on what needs doing, not your postcode. You will see the full price before you book, with no extras added later.
Send pictures for a quote
We price nearly every job from photos. This is what we need:
- A coin beside the damage so we can judge size
- Your postcode, so we can check dates
- Good light, ideally daylight, without flash glare
- A wider photo showing the whole bath
Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, include your postcode and send them over. You will get a fixed price, not an estimate.
Landlord and trade work in Ganborough
We regularly work with letting and managing agents. Just send photos, the address and how to get access and we’ll handle the rest.
Builders use us to fix snagging damage before handover. We can visit several plots in one trip.
Signs you need bath re-enamelling in Ganborough
Often the bath has just had decades of use, with nothing wrong except the surface. The body of the bath is usually perfectly sound.
The things customers normally mention when they call are:
- Wear marks under the taps
- An old resurfacing that’s failing
- A bath in a colour that no longer suits
- A period or roll-top bath worth keeping
Questions to ask before booking
- How the colour is matched
- How changes to the job are handled
- Whether the price is fixed and includes VAT
- How to look after the finish
About Ganborough
Ganborough is about 12 miles south-east of Evesham, in Gloucestershire. We agree a date that works for you, and we’ll give you an arrival time in advance, so there is no waiting around. Ganborough is one of 470 places in Gloucestershire where we work. You can also see our page for Birmingham, about 36 miles away.
All of GL56 is within our area, from the main roads to the quietest streets. From High Street, Banks Fee Lane and Ganborough Road or a nearby road, a technician can come to you. We also cover the places around Ganborough: Longborough (1 mile north-east), Bourton-on-the-Hill (2 miles north), Broadwell (2 miles south-east), Lower Swell (2 miles south) and Stow-on-the-Wold (2 miles south-east). Larger places within reach include Cheltenham (15 miles west), St Paul's (15 miles west), Lansdown (15 miles west), Bishop's Cleeve (13 miles west), Fairview (14 miles west) and Alstone (15 miles west).
Around Ganborough
We visit homes around Coach & Horses pub, St James' Church and Longborough Church of England Primary School, among other places. For rail, the closest station is Moreton-In-Marsh station, about 3 miles north-east. A little further out are Cotswold Cricket Museum (2.5 miles south-east) and Moore Cottage Hospital (5 miles south).
Repairing versus replacing in Ganborough
A replacement frequently means several trades over several days. Re-enamelling is one technician, usually one day. Prices start from £350. Every job is a little different, so each one is priced on its own. What’s damaged, how badly and how easy it is to reach all make a difference, and doing several things on one visit costs less than separate visits.
Why book with us
- Same prices wherever you are
- Dust sheets down, tidy finish
- Work done at your home or business
- Everything repaired in place
Read our full price list or resurfacing vs replacement cost guide.
About our accreditations · Every repair comes with a one-year guarantee.
