Salford · England

Bath re-enamelling & resurfacing in Worsley, Salford

Bath re-enamelling for Worsley, without a refit. Get a fixed price from your pictures, then book a visit.

  • Resurfacing from £350
  • A bath that stays dull however much you clean it
  • A period or roll-top bath worth keeping
Surface Doctor technician refinishing the outside of a roll-top bath

Bath re-enamelling near Worsley

For landlords and businesses

We also carry out snagging repairs for builders and developers, fixing chips and scratches before handover. We hold CHAS, Constructionline and SafeContractor accreditations.

Letting agents frequently send us pictures straight from the inventory. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.

About our bath re-enamelling in Worsley

We resurface cast iron, steel and acrylic baths, including roll-tops and period baths. Several coats of finish go on over a bonding primer, after the bath has been cleaned, repaired and keyed. If you are dealing with worn patches where water runs and sits and chips and rust in more than one place, we can help, on basins & shower trays, cast iron baths and Victorian roll-tops alike.

Peace of mind is built in: each job carries a one-year guarantee, and we explain what it covers before you book.

Area
Worsley (M28)
Region
Salford
Warranty
12 months on all our work
Quote
From £350. Free and fixed, from your pictures
Phone
0345 017 0787
Page updated
23 October 2026
Before and after: an old basin refinished to bright white

When we’d advise against a repair

A repair isn’t always the answer, and we will tell you before we start. We cannot fix:

  • A cast iron or steel bath that is cracked right through
  • Steel that has corroded right through
  • Problems we cannot see until an old finish comes off

Send us pictures and we will tell you honestly before you book.

Materials we work on in Worsley

  • Cast iron baths
  • Victorian roll-tops
  • Pressed steel baths
  • Acrylic baths
  • Basins & shower trays

Worsley and nearby

Worsley is about 3 miles north-west of Eccles, in Salford. Clients in Worsley get the same service as everywhere else we cover: a fixed quote from pictures, then a visit to do the work. We work in all 21 towns and villages across Salford, from the larger towns to small villages. Our nearest city page is Manchester, about 8 miles away.

Every address in M28 is covered. From Hilton Crescent, Haydock Drive and Rands Clough Drive or anywhere nearby, a technician can come to you. You’ll find Worsley on the A575 and A577, so it’s easy for us to reach. Neighbouring places we cover include New Manchester (1 mile north-west), Mosley Common (1 mile north-west), Little Hulton (2 miles north), Tyldesley (2 miles west) and Hindsford (3 miles west). Further out, we also cover Salford (5 miles east), Eccles (3 miles south-east), Swinton (3 miles east), Irlam (4 miles south), Cadishead (5 miles south) and Patricroft (3 miles south-east).

Around Worsley

Typical jobs here are in homes near St Andrew's CofE Primary School, St Mary the Virgin's Church and Worsley Old Hall pub and the streets around them. For rail, the closest station is Walkden station, about 1.3 miles north-east of the centre. A little further out are Royal Bolton Hospital (3.6 miles north) and Swinton Shopping Centre (3 miles east). For a walk, there’s Cadishead and Little Woolden Moss.

  • Other local spots include Astley Mosley Common (2.2 miles south-west)
Map of Worsley © OpenStreetMap contributors

How to look after the repair

Looking after the surface is easy:

  • Clean with a soft cloth and mild detergent
  • Don’t leave a chip unrepaired
  • Don’t let dyes or oils sit on the finish
  • Keep suction mats out of the bath

Rinse away dyes, oils and bath bombs straight after use, as they can stain. Fix dripping taps quickly.

Do not try to scrub a worn bath back to shine. It removes more of the surface.

Can I fix it myself?

Kits are cheap and easy to find, but many of the jobs we do start with putting right a DIY repair. Getting it right first time is normally cheaper.

DIY kits are sold for most surfaces, and they can tidy up a tiny mark. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.

Common problems we fix in Worsley

A dull surface stains and holds dirt, and cleaning harder only makes it worse. At that stage, resurfacing is the fix.

People typically call us after spotting something like this:

  • Staining under the taps and around the waste
  • A dull, rough surface that will not come clean
  • A coating lifting around the plughole
  • A bath in a colour that no longer suits

What your quote should include

  • If travel is included in the price
  • What happens if they find more damage
  • What preparation is included
  • When it can be used again

Choosing a repair company

What happens on the day

A typical visit goes like this: we arrive on time, sheet and mask the area around the job, carry out the work and tidy away. Plan for most of the day. Before leaving, we tell you how long to leave it and what to avoid for the first few days.

  1. The bathroom is protected and ventilation set up.
  2. Old sealant is cut out and the bath is deep cleaned.
  3. We repair chips, rust spots and pitting.
  4. We key the bath and apply a bonding primer.
  5. Several coats of finish are sprayed on, then it cures until the day after.

Before we arrive

  • Mention if the room is upstairs or in a flat
  • Open a window if you can
  • Let us know about parking or access

Ask for a price

Upload photos of the damage and one of the whole item, and tell us you are in Worsley, and we’ll come back with a fixed quote.

Get a free quote

Related advice

What bath re-enamelling costs

Resurfacing from £350. We don’t charge extra for travel to Worsley. The price comes down to:

  • How easy the damage is to reach
  • What kind of damage it is
  • How many areas need work
  • Whether old repairs or coatings need taking off

No two jobs are quite the same, so we price each one individually. What’s damaged, how badly and how easy it is to reach all make a difference, and doing several things on one visit costs less than separate visits.

Quotes from your photos

Almost every job we do is priced from pictures. This is what we need:

  • A clear, close picture of the problem area
  • The material, if you know it
  • A photo taken from further back
  • Daylight if possible, and no flash reflection

There’s no need for us to visit first. Photos are enough for us to price nearly every job: send a close-up, a wider shot and your postcode, and we will come back to you with a fixed figure.

Repair or replace: which is better?

Replacement only makes sense in a few cases: a cracked-through bath, a change of size or shape, or a full refit. In most other cases, resurfacing is the better choice. Our bath re-enamelling starts from £350. A repair is priced on what needs doing, not where you live. The full price is agreed before booking.

Why book with us

  • Colour-matched on site
  • One price list for the entire UK
  • We’ll tell you if it’s not worth repairing
  • Dust sheets down, tidy finish

Read our pricing or resurfacing vs replacement cost guide.

Common questions in Worsley

What happens after I send pictures?

We look at the pictures and reply with a fixed price and some dates. If we need another angle, we will ask.

Do you come to Worsley?

Yes. We work across the UK and come to Worsley and the rest of Salford. Send pictures and we’ll quote, or call 0345 017 0787.

What areas do you cover?

The entire UK, including all of Salford. Just include your postcode and we’ll confirm dates.

Will you leave a mess?

Very little mess: we sheet and mask everything nearby, and we take our waste away with us.

Can you price it without visiting?

Nearly always. If photos do not show enough, we will ask for another angle.

Are you accredited?

We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.

Is there a smell?

There is some smell while the coating is applied, which is why we ventilate the bathroom. It clears as the finish cures.

Do I have to be there?

Yes. The technician needs access to the room for the visit, at a time that suits you.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.