Cheshire East · England

Bath Resealing in Marthall

Bath resealing in Marthall without the cost of replacing. Get a fixed price from your photos, then book a visit.

  • Mould you cannot clean out
  • Gaps in the seal
  • Old sealant that looks dirty
Surface Doctor technician refinishing the outside of a roll-top bath

Trusted bath resealing in Marthall

Bath resealing at your home in Marthall

A good reseal is all about preparation: every bit of old silicone out, mould treated, the joint clean and dry. Then the fresh sealant goes on, as one neat, continuous bead. If you are dealing with mould you can’t clean out and discoloured, yellow sealant, we can generally put it right, whatever the material.

Whatever the size of the job, you get the same one-year guarantee.

Where
Marthall (WA16)
Area hub
Cheshire East
Warranty
One year on every repair
Quote
Fixed and free, based on pictures
Call
0345 017 0787
Updated
23 October 2026
Technician in a mask working on a freestanding roll-top bath

Common problems we fix in Marthall

Sealant doesn’t last forever. Each shower leaves moisture and soap behind, which mould feeds on, and the joint flexes each time the bath fills.

Most people contact us after spotting one of these:

  • Water getting behind the bath or tray
  • Stained silicone
  • Gaps by the taps
  • An untidy old seal

Comparing quotes

  • How the room is protected while they work
  • How the colour is matched
  • What happens if the damage is worse than the photos show
  • What prep work is covered

Our hiring checklist

Landlord and trade work in Marthall

For developers and builders, we fix damage before handover, saving last-minute replacements. We can visit several plots in one trip to keep costs down.

For anyone letting property in or around Marthall, we can repair and quote for several addresses together. Just send pictures for each address and we will price them together.

How to look after the repair

Most damage we see is avoidable. These habits help:

  • Let steam out after showers
  • Reseal when black spots will not clean off
  • Run the extractor fan during and after showers
  • Wipe the joints dry after use

Run the extractor fan, dry the joints after bathing, and clean them regularly with a mild cleaner to slow mould growth.

If you notice damp, stains on the ceiling below or loose tiles, act quickly. There may be more going on, so we’ll tell you if it needs a builder or plumber.

About Marthall

Marthall is about 3 miles south-east of Knutsford, in Cheshire East. Whether you are in the middle of Marthall or on the outskirts, the service is the same: fixed prices, tidy work and a one-year guarantee. Marthall is one of 254 places in Cheshire East where we work. Our nearest city page is Manchester, about 14 miles away.

Every address in WA16 is within our area, from the main roads to the quietest streets. That includes homes on Chelford Road, Snelson Lane and Sandle Bridge Lane. Nearby, we also work in Peover Heath (1 mile south), Over Peover (1 mile south-west), Ollerton (2 miles north-west), Over Knutsford (3 miles north-west) and Blackden Heath (3 miles south). Larger places within reach include Crewe (14 miles south-west), Macclesfield (7 miles east), Congleton (9 miles south-east), Wilmslow (5 miles north-east), Knutsford (3 miles north-west) and Middlewich (9 miles south-west).

Local landmarks in Marthall

Typical jobs here are in homes near Chelford CofE Primary School, All Saints Church and The Egerton Arms. For rail, the closest station is Chelford station, about 1 mile south-east of the centre. Other landmarks nearby include Knutsford War Memorial Cottage Hospital (3.4 miles north-west) and Peover Superior (2 miles south-west). For a walk, there’s Lindow Common.

Map of Marthall © OpenStreetMap contributors

Different materials, different repairs

Sinks and worktops

Basins, vanity units and kitchen worktops are resealed too, with the joint fully dried first.

Baths

We fill the bath before sealing, so the joint is at its widest.

The process

When we visit, the technician arrives at the agreed time, protects the room with dust sheets and masking and gets started. Expect it to take about two hours for a bath. We tidy up before we leave and let you know when you can use it again.

  1. The surrounding area is protected and the joints masked.
  2. Old sealant and residue are removed.
  3. The joint is cleaned, treated and dried.
  4. Fresh silicone is applied in a continuous bead.
  5. We smooth the bead, remove the tape and leave it to cure.

Getting ready for the visit

  • Let us know if it has been repaired before
  • Avoid using the area for a few hours before we arrive
  • Keep children and pets away from the room on the day

Ask for a price

Send us pictures of the damage and one of the entire item, and tell us you are in Marthall, and we will come back with a fixed quote.

Get a free quote

Advice

Should I try a DIY kit first?

It’s tempting to reach for a kit, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Doing it properly first is typically the cheaper route.

What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, then guarantee it for a year.

Is resealing worth it?

Resealing costs very little, and it protects everything around the bath. Failed sealant can lead to water damage that is much more expensive. Most people are surprised how affordable a repair is, particularly next to the cost of replacement. Send photos and we’ll give you the exact figure.

What you get with us

  • CHAS, Constructionline and SafeContractor accredited
  • Nothing taken out or refitted
  • Same prices wherever you are
  • We’ll tell you if it’s not worth repairing

Take a look at our prices page.

What affects the price in Marthall

We price every job individually, from your pictures. What matters most is:

  • Access to the area
  • The colour and finish to match
  • Whether old repairs or coatings need taking off
  • What the surface is made of

What it costs depends on the type and amount of damage, what it’s made of and how many items we do on one visit. We give a fixed price from your pictures, so you know the cost before you book.

Send pictures for a quote

Two or three clear pictures are typically enough. Try to include:

  • Daylight if possible, and no flash reflection
  • A coin beside the damage so we can judge size
  • The material, if you know it
  • One sharp close-up of the damage

We price from pictures so you do not have to wait in for a survey. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and you’ll get a fixed figure back.

Common questions in Marthall

Is it worth repairing rather than replacing?

Normally, if the item is otherwise sound. Repairing avoids the cost and disruption of replacing. We will tell you honestly if replacement makes more sense.

Why does my sealant keep splitting?

Movement is the usual cause, or it was sealed with the bath empty. We fill the bath before sealing it.

How long before I can shower?

Normally about a day later. We will tell you the exact time.

What areas do you cover?

We cover the whole UK, including Marthall and the rest of Cheshire East. Send your postcode with your pictures and we will offer you dates.

Do you do work for letting agents?

Yes. We work for landlords, agents, builders and businesses as well as householders.

Why does mould come back so fast?

Mostly moisture and poor ventilation. We use mould-resistant silicone, and ventilation helps it last.

How long does a reseal take?

Typically a couple of hours, then it needs to cure.

How do I get a price for bath resealing in Marthall?

Every job gets a fixed quote based on photos of the damage. Send a close-up of the damage and a wider photo and your postcode.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.