Cornwall · England
Bath Resealing in St Mawes
Bath resealing in St Mawes without the cost of replacing. Send us pictures for a fixed price, then we come to you.
- Sealant that’s split or lifting
- Old sealant that looks dirty
- Damp near the bath
Bath resealing in St Mawes, done in place
A good reseal is all about preparation: old silicone removed, mould treated, the joint cleaned and dried. Then the fresh sealant goes on, as one neat, continuous bead. We work on basins & vanity units, baths and wet rooms, and common reasons people get in touch are stained silicone and gaps by the taps.
You’re covered after we leave: our one-year guarantee applies to every job, and we’ll explain exactly what it covers when we quote.
- Area
- St Mawes (TR2)
- County
- Cornwall
- Warranty
- One year on every repair
- Price
- Free, fixed quote from pictures
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
What we can’t put right
We’ll always be straight with you, so here’s what a repair can’t fix:
- Tiles that move, until they’re refixed
- Water damage behind the bath that needs a builder
- A bath or tray that moves, until its support is fixed
Send us pictures and we’ll tell you honestly.
Surfaces we repair
- Wet rooms
- Baths
- Kitchen worktops & sinks
- Basins & vanity units
- Shower trays & enclosures
What bath resealing costs
Every quote is fixed and free. What we take into account:
- Where the damage is and how we get to it
- The colour and finish to match
- Whether it’s a chip, crack, burn or wear
- The material
Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Photos let us give you the exact figure.
Quotes from your photos
Phone photos are fine, there’s no need for anything special. Make sure they show:
- Your postcode, so we can check dates
- Natural light rather than flash
- A coin beside the damage so we can judge size
- A close-up of the damage, in focus
A quote takes minutes to ask for: take one close-up and one wider shot of the bath or shower, add your postcode and send them to us. You’ll get a fixed quote, not an estimate.
What we do, step by step
Visits start with a quick look at the job together, so there are no surprises. After that, protection goes down around the work area and the work begins. Allow about two hours for a bath, and we will keep you posted as we go.
- The old silicone is cut out completely.
- We remove the residue and clean the joint.
- We treat mould and dry the joint thoroughly.
- We fill the bath, or weight the tray, to open the joint.
- New mould-resistant silicone is applied and tooled neatly.
Preparing for the visit
- Let the surface dry out before the visit
- Clear toiletries, mats and anything else from around the area
- Mention any earlier repairs or resurfacing
Get a quote
For a price in St Mawes, the easiest route is photos: one close up, one from further back, plus your postcode. We reply with a fixed quote and our next available dates.
Advice
St Mawes and nearby
St Mawes is about 3 miles east of Falmouth, in Cornwall. Our work suits any type of property, from flats and terraces to detached houses and new builds, plus businesses and rented homes. Our technicians cover 644 places in Cornwall.
All of TR2 is within our area, from the main roads to the quietest streets. Streets in the area include The Rope Walk, Bohella Road and Kings Road. We also travel to St Anthony in Roseland (1 mile south-east), St Just in Roseland (2 miles north), Mylor Churchtown (2 miles north-west), Flushing (2 miles west) and Trelew (3 miles north-west). Within a short drive, we also cover Truro (7 miles north), Falmouth (3 miles west), Camborne (13 miles west), Redruth (11 miles north-west), Helston (12 miles west) and Rosewarne (13 miles west).
Landmarks near St Mawes
In St Mawes, that means homes near Rising Sun pub, St Mawes' Church and St Mawes School, among other places. St Mawes’s nearest station is Falmouth Docks station, about 1.9 miles west of the centre. A little further out are St Mawes Castle (0.5 miles south-west) and Falmouth Community Hospital (3.2 miles west).
Nearby places to St Mawes
Other services in St Mawes
Signs you need bath resealing in St Mawes
Sealant splits when the bath or tray moves, frequently because it was sealed with the bath empty.
Common reasons people in St Mawes contact us include:
- Silicone smeared on tiles
- Old sealant that looks dirty
- Gaps in the seal
- Black mould in the sealant
Comparing quotes
- What happens if they find more damage
- What the guarantee covers, and for how long
- How soon you can use it again
- Aftercare advice
Work for landlords and builders
We regularly price jobs from inventory or check-out pictures. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.
For anyone letting property in or around St Mawes, we can repair and quote for several addresses together. Send pictures for each one and we will come back with a combined price.
Should I try a DIY kit first?
You can buy a DIY kit for most repairs, and they can tidy up a tiny mark. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
It’s natural to want to try a repair yourself. The trouble is that kit repairs frequently look fine at first and then fail, and then the old filler has to be removed first.
Why reseal now?
Resealing is routine maintenance. Leaving split or mouldy sealant can let water reach the walls and floor, which costs far more to put right. It helps to know what pushes a price up or down: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Send photos and you will get a fixed figure.
Why book with us
- CHAS, Constructionline and SafeContractor accredited
- One-year guarantee on every repair
- We leave the room as we found it
- Straight answers about what a repair can do
Read our full price list.
St Mawes questions
What information do you need?
Send pictures through the quote form or call 0345 017 0787, and we’ll take it from there.
Do you hold any accreditations?
Yes. Our accreditations include CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.
How soon can you come?
We will give you dates with your quote. Tell us if you need it done quickly.
Is it messy?
No. The work area is masked and covered, and we take our waste away with us.
Why does my sealant keep going mouldy?
Mould needs moisture. Ventilation and drying keep it clean longer.
Does someone need to be in?
Yes. We need access to the room while we work, at a time we agree with you.
Can new silicone go over old?
All the old sealant comes out. New silicone won’t bond to old.
Do you work for landlords and businesses?
We do, regularly. We quote for multiple addresses and fit around tenancy changeovers.
Aftercare tips
Aftercare is simple, and it makes a real difference:
- Wipe the joints dry after use
- Ventilate the bathroom well
- Reseal at the first sign of lifting
- Clean the sealant gently and regularly
Use the extractor fan, wipe the joints dry after use, and give them a regular clean with a mild cleaner to slow mould growth.
Black mould in sealant isn’t just unsightly, it’s a sign moisture is sitting in the joint. An early reseal keeps water where it belongs.
About our accreditations · Every repair comes with a one-year guarantee.
