Hampshire · England
Shower Tray Repair for Hollywater homes
We travel to Hollywater for shower tray chip, crack and scratch repairs and resurfacing. Nothing is taken out, with a one-year guarantee.
- Repairs from £95
- Scratches from cleaning or grit
- Damage from a refit or building work
What we are called out for in Hollywater
Cracks often start at the waste, where the tray is cut and the fitting is tightened.
Common reasons people in Hollywater contact us include:
- Chips or cracks by the plughole
- Chipped corners or rims
- Scratches in the surface
- Cracks running from the waste
What to look for in a quote
- If travel is included in the price
- How long it needs to cure
- Whether the price is fixed and includes VAT
- What protection goes down before work starts
Shower tray repair in Hollywater, done in place
A cracked or chipped shower tray does not always need replacing. If it’s firmly supported, we can repair it where it is, saving you the cost and mess of a new one. Our repair technicians work on stone resin, cast iron and ceramic, and common reasons people get in touch are damage from a refit or building work and a dull, stained or worn surface.
You’re covered after we leave: our one-year guarantee applies to every job, and we’ll explain exactly what it covers when we quote.
- Location
- Hollywater (GU35)
- County
- Hampshire
- Cover
- A year, on every repair
- Quote
- From £95. Free and fixed, from your photos
- Call
- 0345 017 0787
- Page updated
- 23 October 2026
When a repair isn’t the answer
It helps to know what we cannot do too:
- A tray broken in more than one place
- Plumbing leaks under the tray
- Water damage to the floor beneath the tray
If in doubt, send photos and we’ll say what we think before booking.
Surfaces we repair
- Acrylic
- Stone resin
- Cast iron
- Ceramic
- Enamelled steel
What shower tray repair costs
Prices start from £95. There’s no charge for travel to Hollywater. The price depends on:
- What the surface is made of
- How much damage there is
- Previous DIY repairs that have to come out
- The colour and finish to match
Rather than charging by the hour, we price the entire job up front. It depends on the damage, the material and access, and doing several items at once reduces it.
How to get a fixed price
You can generally get a fixed price without us visiting. To make it quick:
- One sharp close-up of the damage
- A picture taken from further back
- A coin beside the damage so we can judge size
- Any earlier repairs or coatings
A quote takes minutes to ask for: photograph the damage, then the whole shower tray, include your postcode and send them over. What comes back is a fixed price, not a guess.
How to care for the repair
Looking after the surface is easy, and it makes a real difference:
- Get a moving tray checked
- Keep heavy bottles on a shelf
- Avoid strong descalers and bleach
- Rinse the tray after each shower
Avoid abrasive pads and strong descalers. A soft cloth and washing-up liquid do the job.
Stop using the shower if the tray is cracked. Water may be getting under the tray, where it causes damage you cannot see.
What else we do in Hollywater
How the visit works
Visits start with a quick look at the job together. After that, protection goes down around the work area and the work begins. Allow a few hours, or most of the day to resurface the whole tray, and we’ll keep you posted as we go.
- We ensure the tray doesn’t flex and look for the cause of any crack.
- Next we clean and prepare the tray.
- We fill and reinforce chips and cracks, then sand them flush.
- We match the colour, or refinish the full tray.
- We leave it to cure; the shower is generally usable the next day.
Preparing for the visit
- Have a window or extractor fan available
- Point us to the nearest place to park
- Mention if the room is upstairs or in a flat
How to get a price
For a price in Hollywater, the easiest route is photos: a close-up, a wider shot and your postcode. You’ll get a fixed quote with dates to choose from.
Advice
DIY kit or professional repair?
DIY kits are sold for most surfaces, and they can tidy up a tiny mark. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
If you’re set on a kit, follow its instructions closely, and do not use it until it has fully cured. If it fails, we can still put it right.
Repairing versus replacing in Hollywater
Replacing a tray normally involves removing the screen and tiling, relaying the base and tiling again. A repair or resurface leaves all of that alone. Repairs from £95, with every job priced individually. The price reflects the work involved, not where you live. You will see the full price before booking, with nothing added on the day.
Why us?
- Repair technicians who travel to you, UK-wide
- We leave the room as we found it
- Colour mixed on the day to match
- Nothing taken out or refitted
Read our full price list.
Common questions in Hollywater
Is a cracked shower tray safe to use?
We would stop using it until it’s repaired, in case water is getting through.
Do you hold any accreditations?
We’re accredited with CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile.
How long before I can shower?
We’ll give you the curing time on the day, generally the following day.
It’s been repaired before. Can you still fix it?
Most of the time. Tell us what was done before.
Will it make a mess?
We protect the room with dust sheets and masking first, and tidy up before we leave.
Can you quote from pictures?
Usually, yes. Clear photos let us give you a fixed quote without visiting.
Is repairing better than replacing?
Generally, yes. Replacement brings removal, refitting and making good, which a repair avoids. If it isn’t worth repairing, we’ll tell you.
Can you do more than one item on the same visit?
Yes. Combining jobs on one visit brings the cost down. Include pictures of each item.
Our work in Hollywater
Hollywater is about 6 miles south-east of Alton, in Hampshire. Anywhere in GU35, we carry out the work at your property. Hollywater is one of 683 towns and villages in Hampshire we cover. We work right across the region, from Hollywater to London (43 miles away).
Every address in GU35 is within our area. From Hollywater Road and Liphook Road or anywhere nearby, we can come to you. Neighbouring places we cover include Standford (1 mile north-east), Whitehill (1 mile west), Deadwater (1 mile north), Bordon (1 mile north-west) and Lindford (1 mile north). Further out, we also cover Farnborough (14 miles north), Fleet (12 miles north), Horndean (15 miles south-west), Aldershot (11 miles north), Alton (6 miles north-west) and Petersfield (8 miles south-west).
Around Hollywater
Our customers here include homes close to Mill Chase Academy, Woodlea Primary School and St Mark's Sacred Church, among other places. For rail, the closest station is Liphook station, roughly 3.1 miles south-east. Other landmarks nearby include The Romany Museum (3.9 miles west) and Chase Community Hospital (0.6 miles north-west). Not far away are Wheeler's Down and Deadwater Valley.
Landlords, agents and businesses in Hollywater
We also carry out snagging repairs for builders and developers, putting right damage done during fitting so nothing needs replacing. We’re CHAS, Constructionline and SafeContractor accredited.
For anyone letting property in or around Hollywater, we can repair and quote for several addresses together. Just send pictures for each address and we will price them together.
About our accreditations · Every repair comes with a one-year guarantee.
