Somerset · England
Shower tray repair & resurfacing in Monksilver, Somerset
Shower tray chip, crack and scratch repairs and resurfacing at your home in Monksilver, with a one-year guarantee on every repair.
- Repairs from £95
- Damage around the waste
- Scratches in the surface
Shower tray repair in Monksilver, done in place
In most cases, a damaged tray can be repaired where it is, from a chip by the waste to a crack across the base. The colour and finish are matched. Typical jobs include a dull, stained or worn surface and damage from a refit or building work, on acrylic, enamelled steel and cast iron.
Peace of mind is built in: our one-year guarantee applies to every job, and we explain what it covers before you book.
- Where
- Monksilver (TA4)
- Area hub
- Somerset
- Warranty
- One year on every repair
- Price
- From £95. Fixed and free, based on pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Monksilver: your questions answered
Can pets and children be at home?
Yes, as long as they stay out of the room we’re working in. We’ll tell you when the room can be used again.
How much does shower tray repair cost in Monksilver?
Prices start from £95. Every job gets a fixed quote based on pictures of the damage. Send a close-up of the damage and a wider photo and your postcode.
How do I book?
Send pictures through the quote form or call 0345 017 0787.
Can you fix a cracked tray?
Typically, if the tray is firmly supported. The crack is reinforced, filled and refinished.
Do you come to Monksilver?
We do. Repair technicians travel to Monksilver from across the region, and the price is the same as everywhere else.
Can I add another job to the visit?
Yes. Combining jobs on one visit brings the cost down. Include photos of each item.
Do you cover the whole of Somerset?
We cover the whole UK, including Monksilver and the rest of Somerset. Just include your postcode and we will confirm dates.
Can I keep using a cracked tray?
It’s best to stop using it until it’s checked, in case water is getting through.
What we do, step by step
We begin by going over the job with you, so there are no surprises. Next, we cover and mask everything nearby and we start. Allow a few hours for a repair, longer for a full resurface, and we will keep you posted as we go.
- First we check the tray is solid and work out why any crack happened.
- The damaged area, or the entire tray, is cleaned and prepared.
- We fill and reinforce chips and cracks, then sand them flush.
- The repair is colour matched, or the whole tray gets a new finish.
- We leave it to cure; the shower is generally usable the day after.
Preparing for the visit
- Tell us about any previous repairs or coatings
- Keep pets and children out of the room while we work
- Clear toiletries, mats and anything else from around the area
Ask for a price
No survey visit is needed: we price from pictures. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and we’ll come back with a fixed figure.
Read more
Repair or replace: which is better?
Trays sit under the screen and tiles, so taking one out disturbs a lot. Repairing it avoids that disruption. Repairs from £95, with every job priced individually. A repair generally costs much less than people expect, particularly next to the cost of replacement. Photos let us give you the exact figure.
Why book with us
- Normally one visit, start to finish
- No need to remove anything
- A year’s guarantee on all work
- Fixed prices from your photos
Read our prices page.
What shower tray repair costs
Repairs from £95. There are no hourly rates or hidden extras. The price is based on:
- What the surface is made of
- Unusual colours or finishes
- The type of damage
- Doing more than one item at once
It helps to know what pushes a price up or down: access, material, the extent of the damage and whether we can do several items together. Photos let us give you a fixed figure.
Quotes from your pictures
It only takes a minute to photograph the damage, and it saves a visit. Please include:
- The material, if you know it
- Good light, ideally daylight, without flash glare
- A coin beside the damage so we can judge size
- A photo taken from further back
There’s no need for us to visit first. Photos are enough for us to price nearly every job: we need a close-up, a wider picture and your postcode, and we’ll reply with a fixed quote.
Our work in Monksilver
Monksilver is about 8 miles south-east of Minehead, in Somerset. From the centre of Monksilver to the outlying streets, the service is the same: fixed prices, tidy work and a one-year guarantee. We cover 640 places across Somerset, from the larger towns to small villages.
Our visits in TA4 work the same way as everywhere else we cover. That includes homes on Back Way, Front Street and Sunny Bank and the roads around them. Neighbouring places we cover include Nettlecombe (1 mile west), Escott (1 mile east), Sampford Brett (2 miles north-east), Torre (2 miles north-west) and Williton (2 miles north). Within a short drive, we also cover Taunton (13 miles south-east), Bridgwater (14 miles east), Minehead (8 miles north-west), Wellington (11 miles south), Sydenham (15 miles east) and Wilton (13 miles south-east).
What’s near Monksilver
In Monksilver, that means homes near The Notley Arms and Church of All Saints and the streets around them. Further afield, we also cover the area around Bakelite Museum (1.9 miles north).
Keeping it looking good
So the finish stays in good condition for years:
- Replace failing sealant promptly
- Rinse the tray after each shower
- Avoid strong descalers and bleach
- Ventilate the room after showers
Wait the full curing time before you shower. After that, mild cleaners and good ventilation are all it needs.
If the tray creaks or moves, get it checked, before it cracks or gets worse.
DIY kit or professional repair?
The difference between a kit and a professional repair is mostly in the preparation and colour. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
Kits are cheap and easy to find, but the repairs we redo most often are DIY ones that have discoloured or lifted. Getting it right first time is normally cheaper.
Also near Monksilver
Other services in Monksilver
When a repair isn’t the answer
A few problems are outside what a surface repair can do:
- Multiple cracks across the tray
- Damage below the tray that needs a builder
- A tray that moves underfoot
Send us photos and we will tell you honestly before booking.
Materials we work on in Monksilver
- Enamelled steel
- Acrylic
- Cast iron
- Ceramic
- Stone resin
For landlords and businesses
Landlords, letting agents and housing providers in Monksilver use us as well as homeowners. A repair between tenants keeps the property empty for less time, and it normally costs far less than a refit.
We regularly work with letting and managing agents. Send the address, pictures and access details.
Signs you need shower tray repair in Monksilver
Dull and stained trays are usually down to cleaning: limescale, harsh chemicals and abrasive pads wear the finish away.
People usually call us after spotting something like this:
- A tray that flexes
- Cracks running from the waste
- Scratches in the surface
- A dull, stained or worn surface
What to look for in a quote
- Whether the price covers travel
- Is the price fixed, and does it include VAT?
- Whether the colour is mixed to match
- Who will actually do the work
About our accreditations · Every repair comes with a one-year guarantee.
