South Lanarkshire · Scotland
Bath re-enamelling & resurfacing in Allanton, South Lanarkshire
We travel to Allanton for full bath re-enamelling and resurfacing. Everything is done in place, with a one-year guarantee.
- Resurfacing from £350
- Lots of chips and rust spots
- Worn patches where water runs and sits
How we handle bath re-enamelling in Allanton
We resurface cast iron, steel and acrylic baths, including roll-tops and period baths. Several coats of finish go on over a bonding primer, once the bath has been cleaned, repaired and prepared. We’re often asked to fix lots of chips and rust spots and a dull, rough surface that won’t come clean, on basins & shower trays, acrylic baths and Victorian roll-tops.
Every job is backed for twelve months. We return to put right any problem with the work.
- Where
- Allanton (ML3)
- Region
- South Lanarkshire
- Guarantee
- A year, on every repair
- Quote
- From £350. Free, fixed price from pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
What a repair can’t fix
In fairness, some problems need a different fix:
- A cast iron or steel bath that is cracked right through
- Plumbing leaks, which need a plumber
- Acrylic that moves when you stand in it
Not sure? Send photos and we will give you a straight answer.
What we work on
- Basins & shower trays
- Victorian roll-tops
- Acrylic baths
- Cast iron baths
- Pressed steel baths
How to look after the repair
After the repair has cured, a few habits help it last:
- Do not leave a chip unrepaired
- Wash away dyes and oils after use
- Wipe the bath dry after use in hard water areas
- Avoid suction-cup mats
Avoid hair dye, bath bombs and oils sitting on the surface, because they can mark the finish. Repair dripping taps promptly.
Do not try to scrub a worn bath back to shine. It removes more of the surface.
Do you need bath re-enamelling in Allanton?
The gloss on enamel is thin, and abrasive cleaning slowly wears it away. Eventually the surface turns porous and stains.
Keep an eye out for any of the following:
- Enamel that is lost its shine and feels rough
- Lots of chips and rust spots
- A coating lifting around the plughole
- Staining under the taps and around the waste
Comparing quotes
- Who turns up on the day
- When it can be used again
- If travel is included in the price
- What aftercare is recommended
What we do, step by step
We agree an arrival time beforehand, so you know when to expect us. Once we are there, the work takes a full day. The room is left tidy and ready to use once it has cured.
- The bathroom is protected and ventilation set up.
- Old sealant is cut out and the bath is deep cleaned.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- Several coats of finish are sprayed on, then it cures until the following day.
How to prepare
- Make sure the room can be ventilated
- Ensure the area is dry
- Tell us about any previous repairs or coatings
Getting a price
For most jobs, pictures are all we need to give you a price. Add a line about what happened and your postcode, and we will send back a fixed quote and some dates.
Advice
Your questions about bath re-enamelling in Allanton
Can you do the outside of a roll-top?
Yes, frequently. The inside is resurfaced, and we can refinish the outside as well.
Is my repair covered?
Every repair comes with a one-year guarantee. We’ll explain what it covers when we quote.
Can you resurface a pink bath in white?
Yes, white is the usual choice. Mention the colour you want when you send pictures.
Is it safe with children and pets around?
Keep pets and children away from the work area on the day.
How do I book?
Some pictures, your postcode and how to reach you. On the day, we only need access to the room.
Is it messy?
Very little mess: we sheet and mask everything nearby, and we take our waste away with us.
Do you hold any accreditations?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
Are there extra charges for Allanton?
Travel is included in the price, and we charge the same wherever you are.
Landlords, agents and businesses in Allanton
Hotels, guest houses and holiday lets need rooms back in use quickly, so most of our work is done in a single visit. We will fit around changeovers where we can.
We also carry out snagging repairs for builders and developers, putting right damage done during fitting. We are CHAS, Constructionline and SafeContractor accredited.
Repair or replace in Allanton?
When the bathroom is fine apart from the bath’s finish, resurfacing is the simplest answer. Nothing else is disturbed. Our bath re-enamelling starts from £350. The price reflects the work involved, not where you live. You will see the full price before booking, with no extras added later.
Why book with us
- We leave the room as we found it
- Colour-matched on site
- We come to you, anywhere in the UK
- No need to remove anything
Take a look at our pricing and resurfacing vs replacement cost guide.
Allanton and nearby
Allanton is about 2 miles north-west of Larkhall, in South Lanarkshire. Customers in Allanton get the same service as everywhere else we cover: a fixed price from your pictures, then a visit to do the work. Allanton is one of 139 towns and villages in South Lanarkshire where we work. Our nearest city page is Glasgow, about 12 miles away.
Here we cover the ML3 postcode area. From Osprey Lane, Allanton Gardens and Kingfisher Avenue or a nearby road, we can come to you. Other places close to Allanton include Ferniegair (1 mile north-west), Barncluith (1 mile west), Earnock (2 miles south-west), Quarter (2 miles south-west) and Avongrove (2 miles south-west). We also work in nearby towns such as East Kilbride (7 miles west), Cambuslang (7 miles north-west), Uddingston (5 miles north-west), Blantyre (4 miles north-west), Carluke (7 miles east) and Rutherglen (9 miles north-west).
What’s near Allanton
In Allanton, that means homes near Our Lady's High School, Ferniegair Mission Church and Duchess of Hamilton Park and the streets around them. Allanton has its own railway station: Chatelherault station. Nearby you will also find University Hospital Wishaw (2.4 miles east) and Regent Shopping Centre (1.4 miles north-west). For a walk, there is Strathclyde Loch and Baron's Haugh RSPB Reserve.
What bath re-enamelling costs
Resurfacing from £350. We price every job individually. What matters most is:
- The material and finish
- Any earlier repairs that need removing first
- Access to the area
- Whether it’s a chip, crack, burn or wear
A repair generally costs much less than people expect, particularly next to the cost of replacement. Photos let us give you the exact figure.
Getting a price from pictures
You can take the pictures on your phone, there is no need for anything special. Just ensure we can see:
- The postcode, so we can plan the visit
- One sharp close-up of the damage
- A coin or ruler next to the damage for scale
- One picture of the whole bath
No survey visit is needed: we price from photos. Use the quote form, or ring 0345 017 0787 to talk it through, and we will come back with a fixed figure.
Nearby places to Allanton
Also in Allanton
Materials and what they mean for the repair
Acrylic
Acrylic is light and warm to the touch, but it needs firm support underneath. Cracks are strengthened from behind before the front is finished.
Pressed steel
Steel baths and trays have a thin metal body under the enamel. Once a chip exposes it, rust follows quickly, so the metal is treated and sealed before the repair.
About our accreditations · Every repair comes with a one-year guarantee.
