Birmingham · England
Bath re-enamelling & resurfacing in Bearwood, Birmingham
Bath re-enamelling in Bearwood without the cost of replacing. Get a fixed price from your pictures, then we come to you.
- Resurfacing from £350
- Wear marks under the taps
- An outdated colour you’d like to change
How we price bath re-enamelling
Resurfacing from £350. There are no hourly rates or hidden extras. The price depends on:
- Whether we combine several jobs
- Where the damage is and how we get to it
- How hard the colour is to match
- The type of damage
It helps to know what pushes a price up or down: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Photos let us give you a fixed figure.
Quotes from your photos
A couple of clear pictures is all it takes. It helps if you send:
- A coin beside the damage so we can judge size
- Good light, ideally daylight, without flash glare
- A close-up of the damage, in focus
- A photo taken from further back
You don’t need a survey visit. Photos are enough for us to price nearly every job: send a close-up, a wider shot and your postcode, and we will reply with a fixed price.
Bath re-enamelling in Bearwood without replacing anything
Most baths are re-enamelled in a day, with the bath ready to use the following day. Nothing is disconnected or removed. We work on pressed steel baths, cast iron baths and acrylic baths, and common reasons people contact us are staining under the taps and around the waste and an original cast iron bath that needs restoring.
A one-year guarantee comes as standard.
- Area
- Bearwood (B67, B17, B66)
- Region
- Birmingham
- Guarantee
- A year, on every repair
- Quotes
- From £350. Fixed and free, based on photos
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Places near Bearwood
Other services in Bearwood
How to care for the repair
Looking after the surface is easy:
- Keep toiletries on a shelf rather than in the bath
- Fix dripping taps quickly
- Rinse off hair dye, oils and bath bombs immediately
- Use washing-up liquid and a soft cloth
Give the finish its full curing time before using the bath. Then, gentle cleaning with a soft cloth is enough.
If a previous coating is starting to peel, do not pick at it. Moisture gets underneath and makes it worse, so have it stripped and resurfaced.
Work for landlords and builders
Letting agents frequently send us photos straight from the inventory. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.
Builders use us to fix snagging damage before handover. Several plots can be done in one visit.
FAQs for Bearwood
Can you price it without visiting?
Usually, yes. Clear pictures let us give you a fixed price without visiting.
Is there a smell?
Some odour is normal while we spray, so we ventilate the room. It fades as the coating cures.
What information do you need?
Photos of the damage, a picture of the whole bath and your postcode. After that, we just agree a date.
Does the bath have to be removed?
No. It’s re-enamelled where it stands, so the tiles and taps stay put.
Can you make a coloured bath white?
Yes, most people go for white. Tell us what you’d like when you ask for a quote.
Will the price change on the day?
We’ll show you and explain before doing anything extra. You will not be charged for anything you haven’t agreed.
Can landlords book you?
Yes, frequently. We quote for multiple addresses and fit around tenancy changeovers.
Will there be a smell?
A little, depending on the job. Ventilation keeps it to a minimum, and it soon fades.
How the visit works
Visits start with a quick look at the job together, so there are no surprises. Then the area is sheeted and masked and the work begins. It normally takes a full day, and we’ll tell you if anything changes.
- The room is masked, protected and ventilated.
- The bath is cleaned, degreased and any chips or rust repaired.
- We prepare the surface and apply a bonding primer.
- We spray several coats of new enamel finish.
- Once cured, normally by the day after, the bath is ready.
Before we arrive
- Clear the area around the damage
- Open a window if you can
- Plan for the room to be out of bounds to pets and children
Ask for a price
Send us a picture of the damage and a wider shot of the whole item, with your B67 postcode, and we will come back with a fixed quote.
Advice
Honest limits
In fairness, some problems need a different fix:
- Plumbing leaks, which need a plumber
- A bath that’s rusted through
- Problems we cannot see until an old finish comes off
Send us pictures and we will tell you honestly.
What we work on
- Victorian roll-tops
- Basins & shower trays
- Acrylic baths
- Cast iron baths
- Pressed steel baths
Can I fix it myself?
If you do try a kit, read the instructions carefully, and don’t use it until it has fully cured. If it fails, we can still put it right.
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
Covering Bearwood
Bearwood is about 1 mile south of Smethwick, in Birmingham. Wherever you are in the B67 postcode area, we come to you. We work in all 140 towns and villages in Birmingham.
We work across the B67, B17 and B66 postcode area. Whether you live on Pale Lane, Park Road and Abbey Road or a nearby road, a technician can come to you. Being close to the A4030, Bearwood is easy for our repair technicians to reach. We also travel to Beech Lanes (1 mile south), Cape Hill (1 mile north-east), Smethwick (1 mile north), Londonderry (1 mile north-west) and Summerfield (1 mile north-east). Further out, we also cover Birmingham (3 miles east), Royal Sutton Coldfield (8 miles north-east), Erdington (6 miles north-east), Lee Bank (3 miles east), Streetly (8 miles north-east) and Paradise (3 miles east).
Near you in Bearwood
Our customers here include homes close to St Faith and St Laurence's Church, Bearwood Primary School and Lordswood Boys' School, among other places. You’ll also find Lightwoods Park (under half a mile south-west), Church of St Mary (within half a mile south-west), The Abbey Public House (under half a mile north-west) and Lordswood Boys' School (within half a mile south-east). The closest station to Bearwood is Smethwick Rolfe Street station, about 1.4 miles north. Well-known places in the area include Avery Historical Museum (1.7 miles north-east) and City Hospital (1.8 miles north-east). Green spaces nearby include Deer's Leap Wood and Portway Hill.
- Other local spots include Weoley (2.7 miles south)
Different materials, different repairs
Cast iron
Cast iron baths are so heavy that repairing in place makes obvious sense. The enamel is the part that wears or chips, and that’s what we repair.
Roll-top and period baths
Freestanding roll-tops can be done inside and out, and the outside can be refinished too.
Repair or replace in Bearwood?
A refit takes several trades and several days. Resurfacing is one technician, normally in a day, with the bath ready the day after. Resurfacing from £350, with every job priced individually. A repair usually costs much less than people expect, particularly next to the cost of replacement. Send photos and we will give you the exact figure.
What you get with us
- Accredited with CHAS, Constructionline and SafeContractor
- One price list for the whole UK
- Technicians who travel to you, UK-wide
- Rooms protected and left tidy
Take a look at our pricing or bath cost comparison.
About our accreditations · Every repair comes with a one-year guarantee.
