Coventry · England
Bath Re-enamelling in Hawkesbury
Bath re-enamelling across Hawkesbury and nearby, usually in one visit and guaranteed for a year.
- Resurfacing from £350
- A coating lifting around the plughole
- Worn patches where water runs and sits
What your bath is made of matters
Roll-top and period baths
Freestanding roll-tops can be done inside and out, and the outside can be refinished too.
Acrylic
Acrylic baths can be resurfaced too, with a coating system suited to acrylic. It must be solid and not flex underfoot for the finish to last.
Bath re-enamelling in Hawkesbury, done in place
Cast iron and steel baths are ideal for re-enamelling, and we can resurface acrylic baths as well. You end up with a smooth, glossy surface. Whether it’s an outdated colour you’d like to change and an original cast iron bath that needs restoring, we can help.
Big or small, you get the same one-year guarantee in Hawkesbury and across Coventry.
- Location
- Hawkesbury (CV6)
- Region
- Coventry
- Guarantee
- One year on every repair
- Quotes
- From £350. Free, fixed quote from pictures
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Repair or replace: which is better?
When the bathroom is fine apart from the bath’s finish, resurfacing is the simplest answer. Tiles, panels and taps stay put. Prices start from £350. There are no surprise extras on the day. What we quote from your pictures is what you pay, unless the damage turns out to be different, in which case we talk to you first.
Why book with us
- Everything repaired in place
- CHAS, Constructionline and SafeContractor accredited
- One-year guarantee on every repair
- Dust sheets down, tidy finish
Take a look at our pricing and resurfacing vs replacement cost guide.
What a repair cannot fix
A few problems are outside what a surface repair can do:
- A bath that’s rusted through
- A metal bath with a through crack
- An acrylic bath that flexes badly underfoot
Not sure? Send photos and we will give you a straight answer before you book.
Surfaces we repair
- Victorian roll-tops
- Cast iron baths
- Pressed steel baths
- Basins & shower trays
- Acrylic baths
What happens on the day
We begin by going over the job with you, so there are no surprises. After that, protection goes down around the work area and the work begins. You can expect it to take most of the day.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- The new finish is sprayed on in several coats and left to cure until the day after.
Preparing for the visit
- Keep a parking space free if you can
- Make sure the area is dry
- Let us know if it has been repaired before
How to get a price
Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, include your postcode and send them over. What comes back is a fixed price, not a guess.
Advice
Also near Hawkesbury
More services for Hawkesbury
What bath re-enamelling costs
Resurfacing from £350. A fixed quote means you know the cost before booking. We take into account:
- How hard the colour is to match
- Where the damage is and how we get to it
- What the surface is made of
- What kind of damage it is
We charge the same wherever you are, so there is no premium for Hawkesbury. The job itself decides the price: the material, the amount of damage and how many items.
Getting a price from photos
Before you send pictures, a few simple things make all the difference:
- Details of any past repairs
- A coin or ruler next to the damage for scale
- Natural light rather than flash
- One sharp close-up of the damage
We price from pictures so you don’t have to wait in for a survey. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through.
Covering Hawkesbury
Hawkesbury is about 1 mile south of Bedworth, in Coventry. Our work suits any type of property, from flats and terraces to detached houses and new builds, plus businesses and rented homes. Hawkesbury is one of 88 towns and villages in Coventry we cover. Our jobs stretch from Hawkesbury to Birmingham (18 miles away).
Our visits in CV6 are booked in the same way as anywhere else. Jobs here include addresses on Stockley Road, Alwoodley Road and Hindhead Drive and the roads around them. We also travel to Exhall (1 mile north-west), Longford (1 mile south-west), Bedworth (1 mile north), Alderman's Green (1 mile south) and Wood End (1 mile south). Further out, we also cover Coventry (3 miles south), Hillfields (3 miles south), Bishopsgate Green (3 miles south-west), Radford (3 miles south-west), Ernesford Grange (5 miles south) and Cheylesmore (5 miles south).
Local landmarks in Hawkesbury
Around Hawkesbury, we work in homes near Foxford School and Community Arts College, Church of St Thomas and Grangehurst Primary School. Hawkesbury’s nearest station is Coventry Arena station, roughly 1.3 miles south-west of the centre. Other landmarks nearby include Caludon Castle (3 miles south) and University Hospital Coventry (3 miles south-east).
Should I try a DIY kit first?
A kit can be fine for a tiny mark out of sight. For damage in plain view, cracks, holes or rust, or coloured finishes, a professional repair is worth it.
Kits are cheap and easy to find, but the repairs we redo most often are DIY ones that have discoloured or lifted. Doing it properly first is usually the cheaper route.
Common problems we fix in Hawkesbury
A dull surface stains and holds dirt, and cleaning harder only makes it worse. That’s the point where re-enamelling makes sense.
It’s worth getting a quote if you see:
- An original cast iron bath that needs restoring
- A bath in a colour that no longer suits
- Worn patches where water runs and sits
- Lots of chips and rust spots
What to look for in a quote
- Whether there are any call-out or travel charges
- Who turns up on the day
- Aftercare advice
- How long the guarantee is and what it covers
How to care for the repair
It’s all simple stuff:
- Clean with a soft cloth and mild detergent
- Don’t leave a chip unrepaired
- Leave the bath for the full curing time before using it
- Wipe the bath dry after use in hard water areas
Treat the new finish gently at first: give it the full curing time, then clean it gently. After that, no abrasives and no suction mats.
Leave a peeling coating alone. Moisture gets underneath and makes it worse, so have it stripped and resurfaced.
FAQs for Hawkesbury
Do you cover Hawkesbury?
Yes. We work across the UK and come to Hawkesbury. Send us photos for a fixed quote, or call 0345 017 0787.
How soon can you come?
That depends on our diary for your area. We’ll offer you dates when we send your quote.
What happens once I’ve sent photos?
You’ll get a fixed quote back. You are under no obligation.
Can I get a quote without a visit?
Yes, almost always. A close-up and a wider photo are enough to give a fixed price.
Will there be a smell?
It depends on the job, but frequently a little. Open windows and an extractor fan help, and it soon fades.
Do you hold any accreditations?
Yes, including CHAS, Constructionline and SafeContractor. The full list is on our accreditations page.
What information do you need?
Use the quote form or ring 0345 017 0787, and we will take it from there.
Is it worth repairing rather than replacing?
Usually, when the rest is in good condition. Repairing avoids the cost and disruption of replacing. If replacing would be better, we will say so.
About our accreditations · Every repair comes with a one-year guarantee.
