Buckinghamshire · England
Bath Re-enamelling for Holmer Green homes
Full bath re-enamelling and resurfacing for homes and businesses in Holmer Green and across Buckinghamshire. Free, fixed quotes from your pictures.
- Resurfacing from £350
- Several chips and rust patches
- A roll-top that is seen better days
Bath re-enamelling at your home in Holmer Green
We clean, repair and prime the bath before spraying the new finish. The preparation is what makes it last, and we take our time over it. Whether it’s a dull, rough surface that won’t come clean and an original cast iron bath that needs restoring, we can help, whatever the material.
Every repair is covered by a one-year guarantee, wherever you are in Buckinghamshire.
- Location
- Holmer Green (HP15)
- County
- Buckinghamshire
- Guarantee
- One year on every repair
- Price
- From £350. Fixed and free, based on photos
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
How to look after the repair
A little care keeps the finish looking good. We recommend:
- Don’t leave a chip unrepaired
- Stick to gentle, non-abrasive cleaners
- Avoid suction-cup mats
- Repair dripping taps early
Give the finish its full curing time before using the bath. Then, gentle cleaning with a soft cloth is enough.
The longer worn enamel is left, the rougher it gets, and rust spots spread under the surface. Acting earlier keeps the preparation simpler.
Signs you need bath re-enamelling in Holmer Green
Enamel’s shine is only skin deep, and every scrub with an abrasive cleaner takes a little away. After years of use, the surface becomes porous and stains easily.
Common reasons people in Holmer Green contact us include:
- Stains that won’t shift
- A bath in a colour that no longer suits
- Several chips and rust patches
- A bath that stays dull however much you clean it
What your quote should include
- Is the price fixed, and does it include VAT?
- How long the guarantee is and what it covers
- How your room will be protected
- If travel is included in the price
What we can’t put right
Some problems need a builder, plumber or fitter rather than us:
- An acrylic bath that flexes badly underfoot
- Damage hidden under a previous coating, until it’s stripped back
- A bath split right through the body
Send us pictures and we’ll tell you honestly.
Materials we repair
- Cast iron baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
- Acrylic baths
Prices and what affects them
Resurfacing from £350. We don’t charge extra for travel to Holmer Green. The price depends on:
- Any earlier repairs that need removing first
- What the surface is made of
- Access to the area
- How many items we do on one visit
A repair is priced on what needs doing, not where you live. You’ll see the full price before booking, with no extras added later.
How to get a fixed quote
We price nearly every job from photos. This is what we need:
- Something in shot to show the size
- Daylight if possible, and no flash reflection
- The material, if you know it
- Details of any past repairs
For most jobs, photos are all we need to give you a price. Add a line about what happened and your postcode, and we’ll reply with a fixed quote and the earliest dates we have.
Holmer Green: your questions answered
Do you cover Holmer Green?
Yes, we do. We send a technician to Holmer Green for every job, with no extra charge for travel.
Will the bath be moved?
Not at all. We work on the bath in place, with the room masked and ventilated.
Can you fix a peeling bath coating?
In most cases. The old coating comes off before we resurface it. Mention it when you send pictures.
Can you price it without visiting?
Typically, yes. Clear photos let us give you a fixed price without visiting.
Can you repair something that is been repaired before?
Yes, we frequently do. It can add a little time, which we include in the quote.
Do you hold any accreditations?
Yes. Our accreditations include CHAS, Constructionline and SafeContractor. The full list is on our accreditations page.
What does bath re-enamelling cost?
Prices start from £350. The exact price depends on the damage, so we quote from photos. You know the full cost before anything is booked.
How long will the bath be out of use?
Typically a day, then it’s ready to use the following day. A badly pitted bath can need a second day.
Different materials, different repairs
Pressed steel
Steel baths re-enamel well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we pay close attention there.
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
What happens on the day
We agree an arrival time beforehand, so you know when to expect us. Once we are there, the work takes a full day. We leave the room clean.
- We mask and protect the room and ventilate it.
- The bath is cleaned, degreased and any chips or rust repaired.
- We key the surface and put on a bonding primer.
- We spray several coats of new enamel finish.
- We leave it to cure, and it’s normally ready the following day.
Preparing for the visit
- Have somewhere for us to park nearby if possible
- Make sure the room can be ventilated
- Avoid using the area for a few hours before we arrive
Ask for a price
There’s no need for us to visit first. Nearly every job can be priced from photos: we need a close-up, a wider picture and your postcode, and we’ll reply with a fixed price.
Related advice
Should I try a DIY kit first?
You can buy a DIY kit for most repairs, and they can make a small mark look better. Where they fall down is colour and preparation: they come in a handful of shades, and if the surface is not prepared the repair won’t last.
It’s natural to want to try a repair yourself. The trouble is that kit repairs frequently look fine at first and then fail, and the old filler has to come out before a proper repair.
Holmer Green and nearby
Holmer Green is about 3 miles north-east of High Wycombe, in Buckinghamshire. From the centre of Holmer Green to the outlying streets, we offer exactly the same service: fixed prices, tidy work and a one-year guarantee. We work in 263 places in Buckinghamshire. Our nearest city page is London, about 28 miles away.
Postcode districts we cover here: HP15. We regularly work on streets such as Holmer Place, Parish Piece and Pond Approach and the roads around them. We also cover the places around Holmer Green: Beamond End (1 mile east), Mop End (1 mile east), Penn Street (2 miles east), Woodrow (2 miles east) and Penn (2 miles south). We also work in nearby towns such as Aylesbury (12 miles north-west), High Wycombe (3 miles south-west), Chesham (5 miles north-east), Marlow (7 miles south-west), Amersham (4 miles east) and Beaconsfield (4 miles south-east).
Landmarks near Holmer Green
Locally, our jobs take us to homes close to Holmer Green Junior School, Holmer Green Senior School and Christ Church, among other places. Holmer Green’s nearest station is Great Missenden station, roughly 2.7 miles north of the centre. Well-known places in the area include Eden (3.5 miles south-west) and Chiltern Hospital (1.8 miles north). Not far away are Gomm's Wood.
For landlords and businesses
Rented homes see more wear and tear, and replacing things at every changeover adds up. A repair between tenancies is a cheaper way to keep the property in good order.
We work for landlords, letting agents and housing providers in Holmer Green as well as householders. Repairing between tenancies keeps void periods short, and it costs much less than replacing.
Places near Holmer Green
What else we do in Holmer Green
About our accreditations · Every repair comes with a one-year guarantee.
