Essex · England
Bath Re-enamelling in Holton St Mary
Bath re-enamelling in Holton St Mary without the cost of replacing. Send us photos for a fixed price, then book a visit.
- Resurfacing from £350
- A bath in a colour that no longer suits
- Staining under the taps and around the waste
Bath re-enamelling at your home in Holton St Mary
If your bath is sound but looks tired, resurfacing is normally the best value. There’s no removal, plumbing or tiling involved. If you’re dealing with a dull, rough surface that won’t come clean and chips and rust in more than one place, we can usually put it right, on Victorian roll-tops, cast iron baths and pressed steel baths alike.
We stand behind the work with a one-year guarantee.
- Location
- Holton St Mary (CO7)
- Region
- Essex
- Guarantee
- A year, on every repair
- Price
- From £350. Fixed and free, based on photos
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Signs you need bath re-enamelling in Holton St Mary
Once enamel loses its gloss, it stains more easily, and cleaning harder only makes it worse. At that stage, resurfacing is the fix.
People typically call us when they notice something like this:
- A bath that stays dull however much you clean it
- Worn patches where water runs and sits
- Staining under the taps and around the waste
- A roll-top that’s seen better days
Questions to ask before you book
- What protection goes down before work starts
- Aftercare advice
- What the guarantee covers, and for how long
- Whether the price covers travel
Questions from Holton St Mary
What if the damage is worse than the pictures show?
Your quote covers the damage in the pictures. Anything extra is discussed before we begin.
Do you cover Holton St Mary?
We do. Technicians travel to Holton St Mary from across the region, and the price is the same as everywhere else.
Will there be fumes?
A little, during the work. Ventilation keeps it down, and it fades as the finish cures.
How long does re-enamelling take?
Typically a day, then it’s ready to use the following day. A badly pitted bath can need a second day.
Can you repair something that’s been repaired before?
Normally, yes. The old repair comes out first.
What happens once I’ve sent photos?
We check the damage, the material and your postcode, then reply with a quote with dates.
Will it make a mess?
Dust sheets and masking go down before we start, and tidy up before we leave.
Can you quote from pictures?
Yes, almost always. Clear photos let us give you a fixed quote without visiting.
Keeping it looking good
Aftercare is simple:
- Repair dripping taps early
- Get any chip repaired quickly
- Avoid suction-cup mats
- Keep toiletries on a shelf rather than in the bath
Stick to mild, non-abrasive cleaners, avoid suction bath mats, and keep bottles and razors off the surface.
Leave a peeling coating alone. Water gets under it and the damage spreads, so have it stripped and resurfaced.
Should you replace it?
Getting a cast iron bath out is hard work: it’s very heavy, may need breaking up, and the replacement can be costly. Resurfacing in place avoids that entirely. Prices start from £350. Rather than charging by the hour, we price the whole job up front. It depends on the damage, the material and access, and combining items on one visit brings it down.
Why choose Surface Doctor in Holton St Mary
- Same prices wherever you are
- Colours mixed by hand to suit your surface
- We come to you, anywhere in the UK
- Every repair guaranteed for a year
See our prices page and resurfacing vs replacement cost guide.
Nearby places to Holton St Mary
Other services in Holton St Mary
Prices and what affects them
Prices start from £350. There are no hourly rates or hidden extras. The price is based on:
- Previous DIY repairs that have to come out
- Whether we combine several jobs
- How hard the colour is to match
- Whether it’s a chip, crack, burn or wear
A repair generally costs much less than people expect, especially compared with replacing and refitting. Photos let us give you the exact figure.
Quotes from your pictures
When you take your photos, these tips help us give you a firm price:
- Daylight if possible, and no flash reflection
- Details of any past repairs
- The material, if you know it
- A photo taken from further back
Ring 0345 017 0787, or send us photos through the quote form. With one close-up and one wider picture, we can price the job.
For landlords and businesses
For developers and builders, we fix damage before handover, saving last-minute replacements. Several plots can be done in one visit.
Landlords, letting agents and housing providers in Holton St Mary use us as well as homeowners. Repairing between tenancies keeps void periods short, and it costs much less than replacing.
The process
When we visit, the technician arrives at the agreed time, protects the room with dust sheets and masking and gets started. The job normally takes most of the day. We tidy up before we leave and let you know when you can use it again.
- We sheet, mask and ventilate the room.
- Old sealant is cut out and the bath is deep cleaned.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- Several coats of finish are sprayed on, then it cures.
Preparing for the visit
- Clear toiletries, mats and anything else from around the area
- Have somewhere for us to park nearby if possible
- Let us know about parking or access
How to get a price
Pricing is simple: take a close-up of the damage and a picture from further back, send them over with your postcode, and we will reply with a fixed price. Quotes are free and you’re under no obligation.
Related advice
Repairs by material
Pressed steel
Steel baths re-enamel well, once any rust has been treated. Rust around the waste is common on steel, so we check it carefully.
Cast iron
Cast iron baths are the classic candidate for re-enamelling. The body lasts for generations; only the enamel wears, so resurfacing gives them a new life.
When a repair isn’t the answer
Not everything can be repaired, and we’ll tell you before we start. Repairs will not solve:
- Leaking taps or wastes (a plumber’s job)
- A bath that’s rusted through
- Anything hidden under an old coating, until we remove it
If in doubt, send photos and we’ll say what we think before you book.
Materials we work on in Holton St Mary
- Pressed steel baths
- Victorian roll-tops
- Cast iron baths
- Basins & shower trays
- Acrylic baths
About Holton St Mary
Holton St Mary is about 8 miles south-west of Ipswich, in Essex. We visit homes and businesses in Holton St Mary and the surrounding area, so you don’t need to take anything anywhere. Our repair technicians cover 644 places in Essex, from the larger towns to small villages. Our jobs stretch from Holton St Mary to London (58 miles away).
Our visits in CO7 work the same way as everywhere else we cover. Streets in the area include Hadleigh Road and Rose Acre. Neighbouring places we cover include Higham (2 miles south-west), Stratford St Mary (2 miles south-west), Dedham (3 miles south), Withermarsh Green (3 miles west) and Thorington Street (3 miles west). Within a short drive, we also cover Colchester (8 miles south-west), Clacton-on-Sea (15 miles south-east), Harwich (12 miles east), Camulodunum (9 miles south-west), Greenstead (8 miles south) and Wivenhoe (9 miles south).
Landmarks near Holton St Mary
Locally, our jobs take us to homes close to East Bergholt High School and Church of St Mary. The closest station to Holton St Mary is Manningtree station, roughly 3.6 miles south-east. Well-known places in the area include The Munnings Museum (2.9 miles south) and Little Wenham Castle (1.9 miles north-east). For a walk, there’s Cattawade Marshes.
About our accreditations · Every repair comes with a one-year guarantee.
