Bath and North East Somerset · England

Bath Re-enamelling for Keynsham homes

We travel to Keynsham for full bath re-enamelling and resurfacing. Nothing is taken out, with a one-year guarantee.

  • Resurfacing from £350
  • A bath that stays dull however much you clean it
  • Wear marks under the taps
Surface Doctor technician refinishing the outside of a roll-top bath

Bath re-enamelling in Keynsham

How we handle bath re-enamelling in Keynsham

Re-enamelling gives a worn bath a new glossy surface without taking anything out. It’s the answer when the whole bath is tired rather than one spot. Our technicians work on cast iron baths, pressed steel baths and Victorian roll-tops, and people most often call us about wear marks under the taps and a bath in a colour that no longer suits.

All our work comes with our one-year guarantee, wherever you are in Bath and North East Somerset.

Surface Doctor technician refinishing the outside of a roll-top bath
Area
Keynsham (BS31)
Area hub
Bath and North East Somerset
Guarantee
A year, on every repair
Price
From £350. Free and fixed, from your pictures
Call
0345 017 0787
Page updated
23 October 2026

How the visit works

Your technician turns up at the time we agreed with you and looks over the damage before anything else. The floor and nearby surfaces are covered before any work starts. Most visits take most of the day, and we leave the room as we found it.

  1. The bathroom is protected and ventilation set up.
  2. We remove the old silicone and deep clean the bath.
  3. We repair chips, rust spots and pitting.
  4. We key the bath and apply a bonding primer.
  5. Several coats of finish are sprayed on, then it cures until the following day.

How to prepare

  • Move bottles, mats and clutter away from the area
  • Let the surface dry out before the visit
  • Keep pets and children out of the room while we work

How to get a price

Getting a quote takes a couple of minutes: photograph the damage, then the whole bath, add your postcode and send them over. You’ll get a fixed quote, not an estimate.

Get a free quote

Advice

Prices and what affects them

Resurfacing from £350. Quotes are free and the price is fixed. What we look at:

  • How many items we do on one visit
  • The material and finish
  • How much damage there is
  • How easy the damage is to reach

What it costs depends on the type and amount of damage, the material and how many items we do on one visit. We give a fixed quote from your pictures, so you know the cost before you book.

How to get a fixed price

Before you send photos, a few simple things make all the difference:

  • Daylight if possible, and no flash reflection
  • The postcode, so we can plan the visit
  • A photo taken from further back
  • Details of any past repairs

If you’re in Keynsham and want a price, the easiest route is photos: a close-up, a wider shot and your postcode. You’ll get a fixed quote with dates to choose from.

Repair or replace in Keynsham?

Replacement only makes sense in a few cases: if the bath is cracked through, if you want a different size or shape, or if you are refitting the whole room anyway. In most other cases, resurfacing is the better choice. Resurfacing from £350, with every job priced individually. A few things move the price: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Photos let us give you a fixed figure.

Why Keynsham clients choose us

  • Free fixed quotes from pictures
  • Colour mixed on the day to match
  • Honest advice, even when it means no job
  • Work done at your home or business

Read our prices page or resurfacing vs replacement cost guide.

Keynsham and nearby

Keynsham is about 3 miles south of Kingswood, in Bath and North East Somerset. We work in every kind of home, old or new, large or small, plus businesses and rented homes. Keynsham is one of 136 places in Bath and North East Somerset we cover. We work right across the region, from Keynsham to Birmingham (about 78 miles away).

All of BS31 is covered. From High Street, Station Road and Corfe Crescent or a nearby road, a technician can come to you. Main roads around Keynsham include the A4 and A4175, so getting to you is simple. We also cover the places around Keynsham: Willsbridge (2 miles north-east), Saltford (2 miles east), Longwell Green (2 miles north), Bitton (2 miles north-east) and Cadbury Heath (2 miles north). Within a short drive, we also cover Bath (6 miles east), Bathwick (6 miles east), Walcot (6 miles east), Westmoreland (5 miles south-east), Kingsmead (6 miles east) and Bear Flat (6 miles south-east). As one of the bigger places in Bath and North East Somerset, Keynsham is somewhere we visit often.

Local landmarks in Keynsham

In Keynsham, that means homes near St Francis Church, Wellsway School and Wellsway School and the streets around them. Other local landmarks include St John's Church of England Primary School (within half a mile north-west), Avon Valley Country Park (1.1 miles north-east) and The Trout Tavern (less than half a mile north). For rail, the closest station is Keynsham station, roughly 0.6 miles north of the centre. Further afield, we also cover the area around Kingswood Heritage Museum (3.1 miles north) and South Bristol Community Hospital (3.8 miles west). The countryside around Keynsham includes Hunstrete Lake and Lodge Hill.

Map of Keynsham © OpenStreetMap contributors

Looking after it afterwards

Aftercare is simple, and it makes a real difference:

  • Have chips seen to early
  • Fix dripping taps quickly
  • Do not use the bath until it has fully cured
  • Avoid suction-cup mats

Rinse the bath and wipe it over after use, especially in hard water areas, so limescale cannot build up.

Don’t try to scrub a worn bath back to shine. It just wears the enamel further and makes resurfacing more work.

DIY kit or professional repair?

What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.

It’s natural to want to try a repair yourself. The trouble is that kit repairs frequently look fine at first and then fail, and then the old filler has to be removed first.

When a repair is not the answer

Some problems need a builder, plumber or fitter rather than us:

  • A metal bath with a through crack
  • Damage hidden under a previous coating, until it’s stripped back
  • Steel that has corroded right through

If in doubt, send photos and we’ll say what we think.

Materials we repair

  • Basins & shower trays
  • Cast iron baths
  • Victorian roll-tops
  • Pressed steel baths
  • Acrylic baths

Common questions in Keynsham

Can you resurface a pink bath in white?

Yes. Coloured baths can be resurfaced in white, and we can do the rest of the suite as well.

What if the damage is worse than the pictures show?

If we find something the photos didn’t show, we explain it first. You decide whether to go ahead.

How do I get a price for bath re-enamelling in Keynsham?

Resurfacing from £350. Because every job differs, we price from photos. You know the full cost before anything is booked.

Is it safe with children and pets around?

We ask you to keep children and pets out of the room while we work and until it has cured. The rest of the house is unaffected.

How long will the bath be out of use?

One day for most baths, ready the following day. We give you timings with the quote.

Is it messy?

Very little mess: we sheet and mask everything nearby, and we take our waste away with us.

Is it worth repairing rather than replacing?

Generally, yes. Replacement brings removal, refitting and making good, which a repair avoids. If it isn’t worth repairing, we will tell you.

What areas do you cover?

Everywhere in the UK, Keynsham included. There is no extra charge for travel.

What your bath is made of matters

Acrylic

We resurface acrylic baths as well, using a system that bonds to acrylic. It must be solid and not flex underfoot.

Pressed steel

Steel baths re-enamel well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we check it carefully.

When to call us in Keynsham

The gloss on enamel is thin, and every scrub with an abrasive cleaner takes a little away. After years of use, the surface becomes porous and stains easily.

Keep an eye out for any of the following:

  • A peeling or bubbling previous coating
  • Stains that won’t shift
  • A dull, rough surface that will not come clean
  • An outdated colour you’d like to change

Questions to ask before you book

  • Aftercare advice
  • How changes to the job are handled
  • How long it needs to cure
  • What protection goes down before work starts

10 questions to ask before booking

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.