Highland · Scotland
Bath re-enamelling & resurfacing in Lonmore, Highland
We travel to Lonmore for full bath re-enamelling and resurfacing. Everything is done in place, with a one-year guarantee.
- Resurfacing from £350
- A bath in a colour that no longer suits
- A period or roll-top bath worth keeping
Bath re-enamelling in Lonmore, done in place
When a bath is structurally fine but worn out on the surface, resurfacing is normally the best value. It avoids removal, plumbing and re-tiling. If you are dealing with a coating lifting around the plughole and an original cast iron bath that needs restoring, we can help.
Every job is backed for twelve months. If something goes wrong with the work, we come back.
- Where
- Lonmore (IV55)
- Area hub
- Highland
- Guarantee
- A year, on every repair
- Quote
- From £350. Free, fixed quote from pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
What a repair cannot fix
Not everything can be repaired, and we’ll tell you before we start. We cannot fix:
- Leaks from fittings rather than the bath
- An acrylic bath that flexes badly underfoot
- A bath that’s rusted through
Not sure? Send photos and we will give you a straight answer before you book.
Surfaces we repair
- Victorian roll-tops
- Pressed steel baths
- Cast iron baths
- Acrylic baths
- Basins & shower trays
What happens on the day
On the day itself, there is little for you to do. Show us the job, point us to the room, and we will take it from there. Most visits take most of the day.
- We mask and protect the room and ventilate it.
- We clean and degrease the bath and repair any chips or rust.
- The surface is prepared and a bonding primer applied.
- We spray several coats of new enamel finish.
- The bath is left to cure and can typically be used the next day.
Before we arrive
- Let us know about parking or access
- Have somewhere for us to park nearby if possible
- Mention if the room is upstairs or in a flat
Get a quote
Ring 0345 017 0787, or send us pictures through the quote form. With one close-up and one wider picture, we can give you a fixed quote the same day in most cases.
Related advice
How we price bath re-enamelling
Resurfacing from £350. There are no hourly rates or hidden extras. The price is based on:
- The material and finish
- Whether it’s a chip, crack, burn or wear
- Previous DIY repairs that have to come out
- The size and number of damaged areas
Compared with replacing, a repair is usually a fraction of the price, because nothing has to be taken out, refitted or made good. Your fixed quote shows exactly what’s included.
Send pictures for a quote
Two or three clear photos are normally enough. Try to include:
- A close-up of the damage, in focus
- Your postcode, so we can check dates
- Natural light rather than flash
- What it’s made of, if you know
Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, include your postcode and send them over. You’ll get a fixed quote, not an estimate.
Also near Lonmore
Also in Lonmore
Common problems we fix in Lonmore
Many baths we resurface have simply been well used, with nothing wrong except the surface. The body of the bath is normally perfectly sound.
Signs it’s time to call us include:
- A coating lifting around the plughole
- An original cast iron bath that needs restoring
- Lots of chips and rust spots
- A coloured bath you want in white
What your quote should include
- Whether there are any call-out or travel charges
- Whether they match the colour on site
- Who will actually do the work
- How long the guarantee is and what it covers
Looking after it afterwards
It’s all simple stuff, just a few sensible habits:
- Dry the bath after use to stop limescale
- Clean with a soft cloth and mild detergent
- Don’t leave bottles, razors or sponges standing on the surface
- Fix dripping taps quickly
Give the finish its full curing time before using the bath. Then, gentle cleaning with a soft cloth is enough.
If a previous coating is starting to peel, don’t pick at it. Water gets under it and the damage spreads, so it’s better to have it stripped and redone.
Different materials, different repairs
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Steel frequently rusts by the plughole, so we pay close attention there.
Cast iron
Cast iron baths are the classic candidate for re-enamelling. The body lasts for generations; only the enamel wears, so resurfacing gives them a new life.
Our work in Lonmore
Lonmore is in Highland. We visit clients in Lonmore, so there’s no workshop to go to. We cover all 253 towns and villages in Highland, from the larger towns to small villages.
Every address in IV55 is within our area, from the main roads to the quietest streets. Nearby, we also work in Dunvegan (1 mile north-west), Kilmuir (1 mile north-west), Colbost (3 miles west), An t-Aodann Ban (6 miles north-east) and Coillore (8 miles south-east). For island and remote addresses, call first so we can plan the visit.
What’s near Lonmore
Our clients here include homes close to Free Church and the streets around them. Well-known places in the area include Dunvegan Castle (2 miles north-west) and Giant Angus Macaskill Museum (1 mile north-west). The countryside around Lonmore includes MacLeod's Table.
Lonmore: your questions answered
How durable is a resurfaced bath?
Look after it and it lasts. Avoid abrasive cleaners and suction mats.
Can you make a coloured bath white?
Yes, most people go for white. Tell us what you’d like when you ask for a quote.
What information do you need?
Use the quote form or ring 0345 017 0787.
Someone resurfaced my bath and it’s peeling. Can you help?
Yes. Removing the old finish takes extra time, which we include in the price.
Can I add another job to the visit?
Yes, and it’s often cheaper. Just add the extra items to your photos and you’ll get one combined price.
Do you charge for travel?
No. Our quotes include travel, with the same prices everywhere we work.
Does re-enamelling smell?
A little, during the work. Ventilation keeps it down, and it fades as the finish cures.
Do you work in Lonmore?
Yes. We work across the UK and travel to Lonmore and the rest of Highland. Send photos and we’ll quote, or call 0345 017 0787.
Should you replace it?
A replacement often means several trades over several days. Resurfacing takes one technician and generally a day, and the bath is usable the day after. Prices start from £350. Instead of hourly rates, we fix the price before we start. It depends on the damage, the material and access, and combining items on one visit brings it down.
Why Lonmore customers choose us
- No extra charge for your area
- No need to remove anything
- A fixed quote before booking
- Most jobs done in one visit
See our prices page and bath cost comparison.
Landlords, agents and businesses in Lonmore
Landlords, letting agents and housing providers in Lonmore use us as well as householders. Repairing between tenancies keeps void periods short, and it costs much less than replacing.
For developers and builders, we fix damage before handover, saving last-minute replacements. Several plots can be done in one visit to keep costs down.
About our accreditations · Every repair comes with a one-year guarantee.
