North Tyneside · England
Bath re-enamelling & resurfacing in Point Pleasant, North Tyneside
Fixed-price bath re-enamelling in Point Pleasant and the surrounding area, done in a single visit in most cases and guaranteed for a year.
- Resurfacing from £350
- An original cast iron bath that needs restoring
- A bath that stays dull however much you clean it
Bath re-enamelling in Point Pleasant without replacing anything
Re-enamelling gives a worn bath a new glossy surface without taking anything out. It suits baths that are dull, stained, rough or chipped all over. Whether it’s worn patches where water runs and sits and a coating lifting around the plughole, we can help, whatever the material.
We stand behind the work with a one-year guarantee, so you’re not left on your own once we’ve gone.
- Location
- Point Pleasant (NE28, NE31, NE32)
- Area hub
- North Tyneside
- Warranty
- 12 months on all our work
- Price
- From £350. Fixed and free, based on pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
When to call us in Point Pleasant
By the time a bath is a few decades old, it may have a mix of issues: worn patches, chips, rust spots and stains. Resurfacing sorts them out together.
Look out for these signs:
- Lots of chips and rust spots
- An original cast iron bath that needs restoring
- Wear marks under the taps
- Staining under the taps and around the waste
What your quote should include
- What the guarantee covers, and for how long
- Whether the price is fixed and includes VAT
- How long it needs to cure
- Who turns up on the day
Point Pleasant and the surrounding area
Point Pleasant is about 1 mile south-east of Wallsend, in North Tyneside. Clients in Point Pleasant get the same service as everywhere else we cover: a fixed quote from your pictures, then a visit to do the work. We work in all 30 towns and villages in North Tyneside, from the larger towns to small villages.
All of NE28, NE31 and NE32 is covered. Jobs here include addresses on Gut Road, Kent Avenue and Ropery Lane. With the A187 and A193 close by, Point Pleasant is easy for our repair technicians to reach. Other places close to Point Pleasant include Willington Quay (1 mile south-east), Wallsend (1 mile north-west), Hebburn (1 mile south), Low Walker (2 miles south-west) and Monkton (2 miles south). Larger places within reach include Tynemouth (3 miles north-east), Whitley Bay (4 miles north-east), North Shields (3 miles north-east), Longbenton (3 miles north-west), Cullercoats (4 miles north-east) and Killingworth (4 miles north-west).
Near you in Point Pleasant
Locally, our jobs take us to homes close to Burnside Business and Enterprise College, West Park and Churchill Community College and the streets around them. Other local landmarks include Church of St Peter (less than half a mile north-west), Albion Inn (less than half a mile east) and Wallsend St Peter's CofE Aided Primary School (under half a mile north-west). For rail, the closest station is Northumberland Park (Tyne and Wear) station, about 2.9 miles north. Further afield, we also cover the area around Silverlink Shopping Park (1.5 miles north) and Tynemouth Castle and Priory (4 miles north-east).
- Parks and local facilities nearby include Municipal Borough of Wallsend (1.3 miles west)
Towns and villages near Point Pleasant
Also in Point Pleasant
What we do, step by step
We agree an arrival time beforehand, so you know when to expect us. Once we are there, the work takes a full day in most cases. The room is left tidy.
- We check the bath and agree the finish with you.
- Taps, tiles and the floor are masked off.
- The bath is degreased, repaired and keyed.
- Primer and finish coats are applied.
- The masking comes off, we tidy up and tell you when it can be used.
Getting ready for the visit
- Mention if the room is upstairs or in a flat
- Point us to the nearest place to park
- Let the surface dry out before the visit
Getting a price
No survey visit is needed: we price from pictures. Use the quote form, or ring 0345 017 0787 to talk it through.
Read more
Looking after it afterwards
Aftercare is simple:
- Keep toiletries on a shelf rather than in the bath
- Repair dripping taps early
- Dry the bath after use to stop limescale
- Keep suction mats out of the bath
Rinse the bath and wipe it over after use, particularly where water is hard, so limescale cannot build up.
Rust spots on a worn bath get worse with time and make the job bigger. Resurfacing before they spread keeps it simpler.
What bath re-enamelling costs
Prices start from £350. Prices are worked out job by job, from your pictures. What matters most is:
- Any earlier repairs that need removing first
- The material and finish
- How much damage there is
- Access to the area
Rather than charging by the hour, we price the whole job up front. It depends on the damage, the material and access.
Send photos for a quote
Almost every job we do is priced from pictures. This is what to send:
- The postcode, so we can plan the visit
- Daylight if possible, and no flash reflection
- A photo taken from further back
- One sharp close-up of the damage
Call 0345 017 0787 or use the quote form. With one close-up and one wider picture, we can give you a fixed quote.
Your questions about bath re-enamelling in Point Pleasant
Which areas do you work in?
We work UK-wide, so Point Pleasant is covered. Prices do not change with location.
Do you come to Point Pleasant?
Yes. We work across the UK and come to Point Pleasant and the rest of North Tyneside. Send us photos for a fixed quote, or call 0345 017 0787.
Will there be a smell?
There can be some smell while we work, so we ventilate the room. It clears as the materials cure.
What if the damage is worse than the pictures show?
If we find something the pictures didn’t show, we explain it first. The price only changes if you agree.
Do I have to be there?
We need someone to let us in. You don’t need to watch us work.
I’m a tenant. Can you help?
Yes. Ask your landlord first, and we can send them the quote if that helps.
Will there be fumes?
Yes, while we are applying the finish. Ventilation keeps it down, and it fades as the finish cures.
Can you change the colour of my bath?
Yes. Coloured baths can be resurfaced in white, and the basin and toilet can be done too.
DIY kit or professional repair?
For a hairline mark somewhere you’ll never see, a kit may be enough. For damage in plain view, cracks, holes or rust, or coloured finishes, it’s worth having it done properly.
DIY kits are sold for most surfaces, and they can make a small mark look better. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
Repairing versus replacing in Point Pleasant
There are times replacing is better: if the bath is cracked through, if you want a different size or shape, or if you are refitting the whole room anyway. Otherwise, resurfacing typically wins. Prices start from £350. Set against the cost of replacement, repairing normally costs far less, because nothing has to be taken out, refitted or made good. The quote lists exactly what you are paying for.
Why us?
- Repair technicians who travel to you, UK-wide
- Accredited with CHAS, Constructionline and SafeContractor
- Honest advice, even when it means no job
- One-year guarantee on every repair
Take a look at our pricing and guide to resurfacing and replacement costs.
What your bath is made of matters
Acrylic
Acrylic feels warm and is light, but it relies on good support. Cracks are strengthened from behind before the front is finished.
Pressed steel
Steel baths and trays have a thin metal body under the enamel. Exposed steel rusts quickly, so we treat and seal the metal before filling.
Work for landlords and builders
We regularly work with letting and managing agents. Send the address, photos and access details and we’ll handle the rest.
We also carry out snagging repairs for builders and developers, fixing chips and scratches before handover. We hold CHAS, Constructionline and SafeContractor accreditations.
About our accreditations · Every repair comes with a one-year guarantee.
