Derbyshire · England
Bath Re-enamelling for Stanton by Bridge homes
Problem with your bath in Stanton by Bridge? We put it right where it is, match it on site and guarantee the work for a year.
- Resurfacing from £350
- A period or roll-top bath worth keeping
- Worn patches where water runs and sits
Landlords, agents and businesses in Stanton by Bridge
We also carry out snagging repairs for builders and developers, fixing chips and scratches before handover. We’re CHAS, Constructionline and SafeContractor accredited.
Letting agents often send us photos straight from the inventory. That means we can quote before you even visit the property, and we liaise with tenants about access if you’d like us to.
Bath re-enamelling in Stanton by Bridge without replacing anything
Cast iron, steel, acrylic, roll-top and period baths can all be resurfaced. The finish is sprayed on in several coats over a bonding primer, once the bath has been cleaned, repaired and prepared. Our technicians work on acrylic baths, cast iron baths and pressed steel baths, and the jobs we see most are a peeling or bubbling previous coating and lots of chips and rust spots.
The work is covered for a year after we finish. If anything is not right, ring us and we will sort it.
- Where
- Stanton by Bridge (DE73)
- Region
- Derbyshire
- Guarantee
- A year, on every repair
- Price
- From £350. Fixed and free, based on photos
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
Do you need bath re-enamelling in Stanton by Bridge?
Older baths often have several problems at once: worn patches, chips, rust spots and stains. Resurfacing sorts them out together.
If you can see any of these, send us a photo:
- Thin, worn enamel in places
- Staining under the taps and around the waste
- A bath in a colour that no longer suits
- A dull, rough surface that will not come clean
Before you book anyone
- How the room is protected while they work
- The length of the guarantee and what it covers
- Whether a trained technician does the job
- How long it needs to cure
Looking after it afterwards
A little care keeps the finish looking good. Our advice:
- Repair dripping taps early
- Avoid suction-cup mats
- Keep toiletries on a shelf rather than in the bath
- Have chips seen to early
The first few days matter most: give it the full curing time, then clean it gently. From then on, avoid abrasives and suction mats.
Rust spots on a worn bath get worse with time, and each one adds to the preparation. Resurfacing before they spread keeps it simpler.
When we’d advise against a repair
Honesty matters more than a booking, so here’s what a repair cannot fix:
- Holes rusted through the metal
- Anything hidden under an old coating, until we remove it
- An acrylic bath that flexes badly underfoot
Not sure? Send pictures and we will give you a straight answer.
What we work on
- Pressed steel baths
- Basins & shower trays
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
Stanton by Bridge: your questions answered
When can you do it?
We’ll give you dates with your quote. Tell us if you need it done quickly.
Can you make a coloured bath white?
Yes, most people go for white. Mention the colour you want when you send pictures.
Can a failed resurfacing be redone?
Yes. Stripping the old coating adds time, so it’s reflected in the quote.
Is there any odour?
There may be a mild smell during the work, which fades afterwards.
Will the new finish last?
A well-prepared finish lasts a long time if it’s looked after. Gentle cleaning, no suction mats.
What information do you need?
Some pictures, your postcode and how to reach you. On the day, access to the room.
Can pets and children be at home?
We ask you to keep children and pets out of the room while we work. Everywhere else in the home is fine.
Is the work guaranteed?
Every repair comes with a one-year guarantee. We will explain what it covers when we quote.
How we price bath re-enamelling
Prices start from £350. We price every job individually, from your photos. What matters most is:
- How many items we do on one visit
- Whether it’s a chip, crack, burn or wear
- Whether old repairs or coatings need taking off
- Unusual colours or finishes
Set against the cost of replacement, a repair is generally a fraction of the price, because there is no removal, plumbing or making good. Your fixed quote shows exactly what’s included.
How to get a fixed price
Almost every job we do is priced from pictures. This is what we need:
- The material, if you know it
- A clear, close picture of the problem area
- Any earlier repairs or coatings
- One picture of the entire bath
There’s no need for us to visit first. Nearly every job can be priced from pictures: send a close-up, a wider shot and your postcode, and we’ll reply with a fixed price.
DIY kit or professional repair?
A DIY attempt isn’t a disaster. We remove the old filler and start again, so it will not stop us repairing it. It does add a little time, so tell us about it when you send pictures.
What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
Nearby places to Stanton by Bridge
What else we do in Stanton by Bridge
The process
From the moment we arrive, we keep the work contained to the one room. Surfaces nearby are masked off, the job takes a full day, depending on what we find, and we finish by cleaning up and talking you through the result.
- The bathroom is protected and ventilation set up.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- The surface is keyed and primed for the new finish.
- Several coats of finish are sprayed on, then it cures until the following day.
How to prepare
- Avoid using the area for a few hours before we arrive
- Plan for the room to be out of bounds to pets and children
- Tell us if there are stairs or a lift
Ask for a price
Send us a picture of the damage and a wider shot of the entire item, and tell us you are in Stanton by Bridge, and we will come back with a fixed quote.
Advice
Repair or replace in Stanton by Bridge?
When the bathroom is fine apart from the bath’s finish, re-enamelling is the least disruptive fix. Tiles, panels and taps stay put. Our bath re-enamelling starts from £350. Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Send pictures and we’ll give you the exact figure.
What you get with us
- Same prices wherever you are
- Repair technicians who travel to you, UK-wide
- Free fixed quotes from pictures
- Accredited with CHAS, Constructionline and SafeContractor
Read our pricing or resurfacing vs replacement cost guide.
Our work in Stanton by Bridge
Stanton by Bridge is about 5 miles south of Derby, in Derbyshire. We agree a date that works for you, and we will give you an arrival time in advance, so there is no waiting around. We work in 532 places across Derbyshire, from the larger towns to small villages. Our jobs stretch from Stanton by Bridge to Birmingham (about 32 miles away).
Jobs in DE73 are booked in the same way as anywhere else. Neighbouring places we cover include Swarkestone (1 mile north-west), King's Newton (1 mile south-east), Melbourne (1 mile south-east), Barrow upon Trent (2 miles north-west) and Chellaston (2 miles north). Larger places within reach include Swadlincote (7 miles south-west), Ilkeston (11 miles north-east), Long Eaton (8 miles north-east), Belper (13 miles north), Heanor (13 miles north) and Ripley (14 miles north).
Landmarks near Stanton by Bridge
Typical jobs here are in homes near Crewe And Harpur Arms, Chellaston Academy and Church of St Michael, among other places. The nearest railway station is Peartree station, about 4 miles north of the centre. Other landmarks nearby include Melbourne Castle (1.6 miles south-east) and Aston Hall Hospital (2.7 miles north-east).
About our accreditations · Every repair comes with a one-year guarantee.
