East Sussex · England
Bath Re-enamelling in Telscombe Cliffs
Full bath re-enamelling and resurfacing for homeowners, landlords and businesses in Telscombe Cliffs. Send pictures for a free, fixed quote.
- Resurfacing from £350
- A peeling or bubbling previous coating
- A bath that stays dull however much you clean it
About our bath re-enamelling in Telscombe Cliffs
Re-enamelling gives a worn bath a new glossy surface without a refit. It suits baths that are dull, stained, rough or chipped all over. If you are dealing with a roll-top that’s seen better days and a dull, rough surface that won’t come clean, we can usually put it right, whatever the material.
The work is covered for a year after we finish. Just call us if there’s a problem and we’ll come back.
- Location
- Telscombe Cliffs (BN10)
- Area hub
- East Sussex
- Guarantee
- A year, on every repair
- Quotes
- From £350. Free and fixed, from your pictures
- Call
- 0345 017 0787
- Page updated
- 23 October 2026
For landlords and businesses
Hotels, guest houses and holiday lets need rooms back in use quickly, so we keep visits short and tidy. We can work around your bookings.
Rented homes see more wear and tear, and replacing things at every changeover adds up. A repair between tenancies is a cheaper way to keep the property in good order.
Can I fix it myself?
It’s tempting to reach for a kit, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Doing it properly first is normally the cheaper route.
DIY kits are sold for most surfaces, and they can make a small mark look better. Where they fall down is colour and preparation: they come in a handful of shades, and if the surface isn’t prepared the repair won’t last.
What we do, step by step
The work is clean and fairly quiet, so you can carry on at home. We protect the area first, then the job itself takes most of the day. Before we leave, we explain how soon it can be used and how to care for it.
- First we look the bath over and confirm the finish.
- Taps, tiles and the floor are masked off.
- The bath is degreased, repaired and keyed.
- Primer and finish coats are applied.
- The masking comes off, we tidy up and tell you when it can be used.
Preparing for the visit
- Keep pets and children out of the room while we work
- Point us to the nearest place to park
- Tell us about any previous repairs or coatings
Get a quote
Ring 0345 017 0787, or send us photos through the quote form. With one close-up and one wider picture, we can give you a fixed price.
Advice
Where we work around Telscombe Cliffs
Telscombe Cliffs is about 3 miles west of Newhaven, in East Sussex. Whether you are in the middle of Telscombe Cliffs or on the outskirts, the service is the same: fixed prices, tidy work and a one-year guarantee. We cover 289 places across East Sussex, from the larger towns to small villages. Our nearest city page is London, about 49 miles away.
Here we cover the BN10 postcode area. Whether you live on Park Avenue, Ambleside Avenue and Park View Rise or a nearby road, we can come to you. If you are just outside Telscombe Cliffs, we cover Telscombe (1 mile north), Peacehaven (1 mile east), East Saltdean (1 mile west), Saltdean (1 mile west) and Piddinghoe (2 miles east). Further out, we also cover Eastbourne (13 miles east), Seaford (5 miles east), Lewes (5 miles north), Hailsham (12 miles east), Uckfield (13 miles north-east) and Newhaven (3 miles east).
Around Telscombe Cliffs
In Telscombe Cliffs, that means homes near Ascension Church, Telscombe Cliffs Community Primary School and Smugglers Rest pub. The nearest railway station is Newhaven Town station, about 2.9 miles east. Nearby you will also find Planet Earth Museum (2.8 miles east) and Chailey Heritage Marine Hospital (3.7 miles east). Not far away are Itford Hill and Beacon Hill Local Nature Reserve.
Nearby places to Telscombe Cliffs
What else we do in Telscombe Cliffs
What your bath is made of matters
Pressed steel
Steel baths re-enamel well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we pay close attention there.
Roll-top and period baths
Freestanding roll-tops can be done inside and out, with the outside refinished as well.
Repair or replace in Telscombe Cliffs?
A replacement often means several trades over several days. Re-enamelling is one technician, typically one day, with the bath back in use the day after. Our bath re-enamelling starts from £350. No two jobs are quite the same, so we price each one individually. The size and type of damage, the material and access all play a part, and combining jobs on one visit brings the cost down.
What you get with us
- One price list for the entire UK
- A year’s guarantee on all work
- Work done at your home or business
- CHAS and Constructionline accredited
See our pricing and bath cost comparison.
What we cannot put right
Honesty matters more than a booking, so here’s what a repair cannot fix:
- A bath that’s rusted through
- A cast iron or steel bath that’s cracked right through
- Problems we can’t see until an old finish comes off
Send us pictures and we’ll tell you honestly.
Materials we work on in Telscombe Cliffs
- Acrylic baths
- Basins & shower trays
- Victorian roll-tops
- Cast iron baths
- Pressed steel baths
How we price bath re-enamelling
Resurfacing from £350. We give every job a fixed price from pictures. These are the things that affect it:
- The size and number of damaged areas
- The material and finish
- Whether it’s a chip, crack, burn or wear
- Access to the area
Set against the cost of replacement, repairing usually costs far less, because there is no removal, plumbing or making good. Your fixed quote shows exactly what’s included.
Send photos for a quote
We price nearly every job from pictures. This is what to send:
- Whether it’s been repaired or coated before
- One sharp close-up of the damage
- Something in shot to show the size
- Your postcode, so we can check dates
Getting a price is easy: snap the damage close up and then the entire item, send them over with your postcode, and we will reply with a fixed price. Quotes are free and no obligation.
When to call us in Telscombe Cliffs
Sometimes it’s an earlier resurfacing that has failed, lifting by the plughole or blistering. Failing coatings are stripped back before we resurface.
Get in touch if you’ve noticed:
- A roll-top that is seen better days
- Enamel that’s lost its shine and feels rough
- An outdated colour you’d like to change
- An old resurfacing that is failing
Before you book anyone
- Whether a trained technician does the job
- Aftercare advice
- What protection goes down before work starts
- Whether there are any call-out or travel charges
Common questions in Telscombe Cliffs
Can a failed resurfacing be redone?
Yes. Removing the old finish takes extra time, which we include in the price.
Will it make a mess?
Dust sheets and masking go down before we start, and we clean up when we have finished.
Do you work in Telscombe Cliffs?
We do. Technicians travel to Telscombe Cliffs from across the region, with no extra charge for travel.
Can you repair several things at once?
Yes. Combining jobs on one visit brings the cost down. Send pictures of everything you’d like done.
Is there a smell?
Yes, while we’re applying the finish. Ventilation keeps it down, and it fades as the finish cures.
Will there be a smell?
Expect a mild smell while we are working.
Do I need to be at home?
Yes. The technician needs access to the room for the visit, at a time we agree with you.
What happens if you find more damage?
If we find something the pictures didn’t show, we explain it first. The price only changes if you agree.
About our accreditations · Every repair comes with a one-year guarantee.
