Perth and Kinross · Scotland

Bath chip & crack repair in Comrie, Perth and Kinross

Bath repair in Comrie without the cost of replacing. Get a fixed quote from your pictures, then book a visit.

  • Repairs from £95
  • Impact holes in acrylic
  • Snagging damage from a refit
Surface Doctor technician refinishing the outside of a roll-top bath

Bath repair in Comrie

Bath repair in Comrie, done in place

You don’t need a new bath because of a chip. Our technicians fill, shape and refinish the damage, mixing the colour on the day. Common call-outs are for a kit repair that didn’t last and hairline or through cracks in acrylic, in cast iron enamel, acrylic and roll-top & freestanding.

Big or small, you get the same one-year guarantee.

Location
Comrie (PH6)
Area hub
Perth and Kinross
Warranty
12 months on all our work
Price
From £95. Fixed and free, based on photos
Telephone
0345 017 0787
Last updated
23 October 2026
Broken acrylic bath corner, rebuilt and refinished (before and after)

How we price bath repair

Prices start from £95. Prices are worked out job by job, from your pictures. What matters most is:

  • Where the damage is and how we get to it
  • How much damage there is
  • The material
  • How hard the colour is to match

Compared with replacing, a repair is usually a fraction of the price, because there is no removal, plumbing or making good. The quote lists exactly what you’re paying for.

Getting a price from pictures

A couple of clear pictures is all it takes. It helps if you send:

  • A wider photo showing the whole bath
  • Where you are, by postcode
  • A clear, close picture of the problem area
  • Good light, ideally daylight, without flash glare

For a price in Comrie, pictures are the quickest way: a close-up, a wider shot and your postcode. You will get a fixed quote with dates to choose from.

DIY repairs versus a professional job

If you’ve already tried a DIY fix, that’s fine. We take the old repair out and do it properly, so it does not stop a professional repair. It does add a little time, so tell us about it when you send photos.

It’s natural to want to try a repair yourself. The risk is that a kit repair hides the damage for a while, then fails, and the old filler has to come out before a proper repair.

How to look after the repair

Good habits make a big difference to how long a repair lasts. Here’s what we suggest:

  • Check that an acrylic bath does not move when you stand in it
  • Clean with warm water and a mild detergent
  • Put a towel in the bath if you are working above it
  • Rinse the bath after use, especially in hard water areas

Treat the repaired area like the rest of the bath: warm water, washing-up liquid and a soft cloth. Keep scouring pads and gritty cleaners away from it.

Stop using the bath if a crack lets water through. Leaks under a bath can damage floors and ceilings.

Why repair rather than replace?

A repair makes sense whenever the damage is localised. It’s a fraction of the cost of a new bath and fitting, it takes one visit, and the bathroom stays exactly as it is. Repairs from £95, with every job priced individually. Instead of hourly rates, we price the whole job up front. Damage, material and access decide it, and combining items on one visit brings it down.

Why choose Surface Doctor in Comrie

  • Work done at your home or business
  • CHAS and Constructionline accredited
  • Free fixed quotes from pictures
  • Dust sheets down, tidy finish

See our prices page and bath cost comparison.

Your questions about bath repair in Comrie

Will I be able to see the repair?

On a glossy bath, you will struggle to find it. On older, dull enamel the repair can look glossier than the area around it.

Can pets and children be at home?

Just keep them out of the work area. We’ll tell you when the room can be used again.

Can landlords book you?

Yes. We work for landlords, agents, builders and businesses as well as homeowners across Perth and Kinross.

How much does bath repair cost in Comrie?

Repairs from £95. The exact price depends on the damage, so we quote from photos. You will get a fixed figure before booking.

Is it messy?

Very little mess: we sheet and mask everything nearby, and we take our waste away with us.

Is a bath repair permanent?

Yes, if it’s prepared properly and the bath is sound. It’s covered by our one-year guarantee.

Can you repair something that is been repaired before?

Generally, yes. Tell us what was done before and we’ll plan for it.

What information do you need?

Use the quote form or ring 0345 017 0787.

Repairs by material

Composite and resin

Stone resin and composite baths are heavy and solid. Chips and scratches can be filled and colour matched, just like other baths.

Pressed steel

Under the enamel of a steel bath is thin metal. Once a chip exposes it, rust follows quickly, so we treat and seal the metal before filling.

How the visit works

On the day itself, there’s little for you to do. Show us the job, point us to the room, and we will get on with it. Most visits take two to three hours for most chips, tidy-up included.

  1. We protect the bath and the floor around it.
  2. We clean, key and degrease the damage.
  3. We fill it, let it set, then sand it flush.
  4. Colour and gloss are matched to the surrounding surface.
  5. We clear up and give you the curing time, normally until the day after.

Before we arrive

  • Tell us about parking, stairs or access
  • Tell us about any previous repairs or coatings
  • Let the surface dry out before the visit

Get a quote

Send us a picture of the damage and one of the entire item, and tell us you are in Comrie, and we will come back with a fixed quote.

Get a fixed price

Advice

Landlords, agents and businesses in Comrie

We regularly work with letting and managing agents. Just send photos, the address and how to get access.

Landlords, letting agents and housing providers in Comrie use us as well as homeowners. A repair between tenants keeps the property empty for less time, and it typically costs far less than a refit.

Our work in Comrie

Comrie is about 18 miles north of Stirling, in Perth and Kinross. We visit homes and businesses in Comrie and the surrounding area, so nothing has to leave your home. Comrie is one of 107 places in Perth and Kinross where we work. We work right across the region, from Comrie to Glasgow (37 miles away).

Jobs in PH6 work the same way as everywhere else we cover. You’ll find streets such as Queens Road, Dukes Road and Glebe Road, all of which we cover. Nearby, we also work in St Fillans (5 miles west), Crieff (6 miles east), Muthill (7 miles south-east), Gilmerton (7 miles east) and Braco (8 miles south-east).

Near you in Comrie

Typical jobs here are in homes near Secession Church, among other places. Other landmarks nearby include Castle Cluggy (4.1 miles east) and Crieff Community Hospital (5.4 miles east). Open spaces near Comrie include Loch Monzievaird.

Map of Comrie © OpenStreetMap contributors

When to call us in Comrie

Heavy toiletries are the biggest single cause of chips, closely followed by shower heads. Fittings cause damage too: water collects there, so chips nearby rust quickly.

Get in touch if you’ve noticed any of these:

  • A chip where the taps sit
  • Chips caused by builders
  • Rust spots around the plughole
  • Scuffs and scratches in the surface

What your quote should include

  • Who will actually do the work
  • What protection goes down before work starts
  • How long the guarantee is and what it covers
  • Aftercare advice

10 questions to ask before you book

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.