Warwickshire · England
Bath chip & crack repair in Grendon, Warwickshire
Chip and crack repairs to enamel, acrylic and cast iron baths for homeowners, landlords and businesses in Grendon. Send photos for a free, fixed quote.
- Repairs from £95
- Hairline or through cracks in acrylic
- Scuffs and scratches in the surface
Looking after it afterwards
Nothing complicated is needed:
- Keep abrasive pads and gritty cleaners away from the bath
- If an acrylic bath flexes, have its feet adjusted
- Get any new chip repaired before it rusts
- Put a towel in the bath if you are working above it
Use gentle, non-abrasive cleaners and avoid dropping heavy items on the repaired area. Deal with new chips early, before rust can start.
If water is getting through a crack, stop using the bath. Leaks under a bath can damage floors and ceilings.
Bath repair in Grendon without replacing anything
Bath repair is our most common job. Chips on the rim, rust around the waste and cracks in acrylic are all repaired in place, typically in a single visit. Whether it’s rusty patches near the plughole and an old repair that has yellowed or come loose, we can normally put it right, whatever the material.
A one-year guarantee comes as standard, so you are not left on your own once we have gone.
- Location
- Grendon (CV9)
- County
- Warwickshire
- Cover
- A year, on every repair
- Price
- From £95. Fixed and free, based on photos
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
DIY repairs versus a professional job
If you do try a kit, read the instructions carefully, and don’t use it until it has fully cured. If it fails, we can still put it right.
You can buy a DIY kit for most repairs, and they can tidy up a tiny mark. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
How we price bath repair
Prices start from £95. Quotes are free and the price is fixed. What we look at:
- Any earlier repairs that need removing first
- How hard the colour is to match
- Doing more than one item at once
- The material
Instead of hourly rates, we price the whole job up front. It depends on the damage, the material and access.
Quotes from your photos
Most quotes are done from pictures alone. To make it quick:
- A close-up of the damage, in focus
- Whether it’s been repaired or coated before
- A coin or ruler next to the damage for scale
- Where you are, by postcode
If you are in Grendon and want a price, pictures are the quickest way: a close-up, a wider shot and your postcode. We reply with a fixed quote and our next available dates.
Landlords, agents and businesses in Grendon
We’re used to working with agents and managing companies. Just send photos, the address and how to get access.
For anyone letting property in or around Grendon, we will quote for several properties at once. Send pictures for each one and we will come back with a combined price.
How the visit works
Your technician turns up when we said we would and checks the damage against your photos first. The floor and nearby surfaces are covered before we open a single tin. Most visits take a few hours, depending on the damage, and we leave the room as we found it.
- Dust sheets and masking go down around the bath.
- We clean, key and degrease the damage.
- Filler goes in and is sanded flush once it has set.
- Colour and gloss are matched to the surrounding surface.
- We tidy up and tell you when the bath can be used, normally the following day.
Before we arrive
- Open a window if you can
- Let us know if it has been repaired before
- Plan for the room to be out of bounds to pets and children
Getting a price
We price from pictures so you don’t have to wait in for a survey. Use the quote form, or ring 0345 017 0787 to talk it through, and we will come back with a fixed figure.
Advice
What we’re called out for in Grendon
Rust tends to begin where water collects, around the waste, under the taps or in an old chip. Water on bare metal causes rust that creeps under the surrounding enamel.
It’s worth getting a quote if you see:
- Rust spots around the plughole
- A hole punched through by something heavy
- Damage beneath the taps
- A chipped rim or side
Questions to ask before you book
- What preparation is included
- How the colour is matched
- What happens if the damage is worse than the photos show
- What the guarantee covers, and for how long
Also near Grendon
Also in Grendon
What a repair can’t fix
It helps to know what we cannot do:
- Rust that has eaten right through a steel bath
- A whole bath that’s dull or worn, where a full re-enamel is the better fix
- A bath that moves underfoot, until its support is fixed
If in doubt, send pictures and we will say what we think before you book.
What we work on
- Roll-top & freestanding
- Whirlpool & spa baths
- Acrylic
- Pressed steel enamel
- Cast iron enamel
FAQs for Grendon
What about rust by the waste?
Yes. We remove the rust and loose enamel, fill the area, then colour-match the finish.
Can landlords book you?
Yes. We carry out repairs for homeowners, landlords, letting agents, builders and businesses in Grendon.
It’s been repaired before. Can you still fix it?
In most cases. We remove the old repair before doing a new one, so mention it when you send pictures.
Do you charge for travel?
We do not add a call-out fee. The fixed price covers the visit and the work.
Can you quote from photos?
Yes, almost always. Clear pictures let us give you a fixed quote without visiting.
Is it OK to have pets in the house?
Yes, as long as they stay out of the room we’re working in. We’ll let you know when it’s safe to use again.
What happens after I send photos?
We look at the pictures and reply with a fixed quote and some dates. If anything’s unclear, we will ask for another photo.
Is the work guaranteed?
Yes, for a year. If there is a problem with the work in that time, we come back and put it right.
Where we work around Grendon
Grendon is about 4 miles south-east of Tamworth, in Warwickshire. We travel to customers in Grendon and the surrounding area, so nothing has to leave your home. Grendon is one of 324 places in Warwickshire we cover. We work right across the region, from Grendon to Birmingham (about 15 miles away).
Our visits in CV9 work the same way as everywhere else we cover. That includes homes on Willows Lane, Watling Street and Sparrowdale Close. Nearby, we also work in Merevale (1 mile south-east), Whittington (1 mile east), Baxterley (2 miles south), Pinwall (2 miles east) and Bentley (2 miles south). Larger places within reach include Nuneaton (7 miles south-east), Bedworth (9 miles south-east), Fordbridge (10 miles south-west), Castle Vale (9 miles south-west), Chilvers Coton (7 miles south-east) and Camp Hill (6 miles south-east).
Local landmarks in Grendon
In Grendon, that means homes near Woodside CofE Primary School, Boot Inn and The Polesworth School and the streets around them. For rail, the closest station is Atherstone station, about 1.9 miles south-east of the centre. Nearby you will also find Sir Robert Peel Community Hospital (5.9 miles west) and Ratcliffe Culey (3.1 miles east). For a walk, there is Middleton Lakes RSPB reserve.
Repairs by material
Pressed steel
Pressed steel is thinner and lighter, with an enamel finish like cast iron. Chips rust quickly on steel, particularly by the plughole, so repair chips early.
Cast iron
Cast iron is heavy and rigid, with a fused enamel surface. Chips can rust if left, but the bath itself lasts for generations, which makes it well worth repairing.
About our accreditations · Every repair comes with a one-year guarantee.
