Buckinghamshire · England
Bath chip & crack repair in Lane End, Buckinghamshire
Our technicians come to Lane End for chip and crack repairs to enamel, acrylic and cast iron baths. Everything is done in place, and the work is guaranteed.
- Repairs from £95
- Damage done while the bathroom was being fitted
- Rust spots around the plughole
Bath repair at your home in Lane End
It pays to repair bath damage while it’s small. On steel and cast iron, exposed metal starts to rust, and on acrylic, a crack keeps spreading while the bath flexes. A repair stops both. Common call-outs are for damage beneath the taps and deep scratches in acrylic, on roll-top & freestanding, pressed steel enamel and cast iron enamel.
You are covered after we leave: our one-year guarantee applies to every job, and we explain what it covers before booking.
- Area
- Lane End (HP14)
- County
- Buckinghamshire
- Cover
- 12 months on all our work
- Quotes
- From £95. Fixed and free, based on photos
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
Aftercare tips
Simple care helps the repair last. Our advice:
- Don’t leave razors or cans standing in the bath
- Get a dripping tap fixed promptly
- If an acrylic bath flexes, have its feet adjusted
- Avoid scourers, wire wool and gritty cream cleaners
Give the repair the full curing time we recommend before running a bath. After that, gentle cleaning keeps it looking good.
If an acrylic bath has a crack, stop showering in it until it’s repaired. Every use opens the crack a little more, and it can start to leak underneath.
Materials and what they mean for the repair
Acrylic
Acrylic baths are moulded sheet reinforced underneath. There’s no rust, but cracks, holes and scratches happen, and a crack only stays repaired if it’s supported underneath.
Composite and resin
Composite baths are dense and solid. Chips and scratches are filled and matched, just like other baths.
What else we do in Lane End
What happens on the day
Here’s how a visit usually runs: we arrive at the agreed slot, protect everything around the work area, do the job and tidy away. Allow two to three hours for most chips from start to finish. Before we go, we’ll explain when it can be used and how to look after it.
- We protect the bath and the floor around it.
- We clean, key and degrease the damage.
- Filler goes in and is sanded flush once it has set.
- We match both the colour and the shine.
- We clear up and give you the curing time, normally until the following day.
How to prepare
- Ensure the room can be ventilated
- Avoid using the area for a few hours before we arrive
- Keep pets and children out of the room while we work
Get a quote
You don’t need a survey visit. Nearly every job can be priced from photos: send a close-up, a wider shot and your postcode, and we’ll reply with a fixed price.
Related advice
About Lane End
Lane End is about 4 miles west of High Wycombe, in Buckinghamshire. Jobs in Lane End are booked in like any other job: a fixed quote from your pictures, and a technician at your door on the day. We work in all 263 towns and villages in Buckinghamshire. You can also see our page for London, about 33 miles away.
Here we cover the HP14 postcode area. Whether you live on High Street, Church Road and Elwes Road or a nearby road, we can come to you. Being close to the B482, Lane End is easy for our repair technicians to reach. Close by, we cover Wheeler End (1 mile north-west), Bolter End (1 mile north-west), Piddington (1 mile north), Frieth (1 mile south-west) and Little Frieth (1 mile south-west). We also work in nearby towns such as Aylesbury (14 miles north), High Wycombe (4 miles east), Chesham (11 miles north-east), Marlow (4 miles south-east), Amersham (11 miles east) and Beaconsfield (8 miles east).
Local landmarks in Lane End
Around Lane End, we work in homes near Grouse & Ale, Cressex Community School and Lane End Primary School. The closest station to Lane End is High Wycombe station, roughly 3.8 miles east. A little further out are Wycombe Hospital (3.3 miles east) and West Wycombe Rural (1.8 miles north). Open spaces near Lane End include Yoesden.
Signs you need bath repair in Lane End
Dropped items cause the majority of chips, and building work is a common culprit. Acrylic baths crack for a different reason: poor support underneath, so the bath flexes when it’s full.
It’s worth getting a quote if you see:
- A kit repair that didn’t last
- Rust spots around the plughole
- Chips along the edge of the bath
- Damage done while the bathroom was being fitted
Comparing quotes
- How the colour is matched
- The length of the guarantee and what it covers
- Whether cleaning and preparation are in the price
- Aftercare advice
Prices and what affects them
Prices start from £95. We don’t charge extra for travel to Lane End. The price comes down to:
- Previous DIY repairs that have to come out
- How much damage there is
- What the surface is made of
- Whether it’s a chip, crack, burn or wear
There are no surprise extras on the day. What we quote from your pictures is what you pay, unless the damage turns out to be different, in which case we talk to you first.
Getting a price from pictures
Good photos mean an accurate price. Here’s what helps:
- A coin beside the damage so we can judge size
- Any details about the material
- Good light, ideally daylight, without flash glare
- One sharp close-up of the damage
Ring 0345 017 0787, or send us photos through the quote form. With one close-up and one wider picture, we can give you a fixed price the same day in most cases.
Lane End questions
Is repairing better than replacing?
In most cases, yes. Replacement brings removal, refitting and making good, which a repair avoids. We’ll be honest if it’s not worth it.
Is it safe with children and pets around?
We ask you to keep children and pets out of the room while we work and until it has cured. Everywhere else in the home is fine.
Can you redo an old repair?
Regularly. We strip it out, deal with any rust and repair it again.
Will the repair show?
On a glossy bath, you’ll struggle to find it. On worn enamel, it can look shinier than the rest.
Does someone need to be in?
Yes. The technician needs access to the room for the visit, at a time we agree with you.
Is a cracked acrylic bath repairable?
Most of the time. The back of the crack is strengthened before the front is filled and refinished, so access behind the panel is important.
Can I get a quote without a visit?
Yes, almost always. A close-up and a wider photo are enough to give a fixed quote.
What do you need from me?
Just pictures, your postcode and a contact number. On the day, access to the room.
Honest limits
Some jobs aren’t right for a repair, for example:
- A bath that flexes because its feet or cradle have failed (that needs fixing first)
- Water coming from the waste or taps rather than the bath
- A bath worn all over, where resurfacing makes more sense
Not sure? Send photos and we will give you a straight answer before you book.
Materials we work on in Lane End
- Acrylic
- Pressed steel enamel
- Roll-top & freestanding
- Whirlpool & spa baths
- Cast iron enamel
Should I try a DIY kit first?
For a hairline mark somewhere you will never see, a kit may be enough. For damage in plain view, cracks, holes or rust, or coloured finishes, it’s worth having it done properly.
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Getting it right first time is usually cheaper.
Work for landlords and builders
We regularly work with letting and managing agents. Send the address, photos and access details and we’ll handle the rest.
Hospitality businesses cannot afford rooms out of action for long, so most of our work is done in a single visit. We can work around your bookings.
About our accreditations · Every repair comes with a one-year guarantee.
