Kent · England

Bath Repair for Ramsgate homes

Bath repair for Ramsgate, without a refit. Get a fixed quote from your pictures, then book a visit.

  • Repairs from £95
  • Damage done while the bathroom was being fitted
  • Damage beneath the taps
Surface Doctor technician refinishing the outside of a roll-top bath

Need bath repair in Ramsgate?

When we would advise against a repair

A repair isn’t always the answer, and we will tell you before we start. We can’t fix:

  • Rust that has eaten right through a steel bath
  • Cracks in parts of an acrylic bath we cannot get to from below
  • Water coming from the waste or taps rather than the bath

Send us pictures and we will tell you honestly before booking.

Materials we repair

  • Pressed steel enamel
  • Whirlpool & spa baths
  • Acrylic
  • Roll-top & freestanding
  • Cast iron enamel

Bath repair in Ramsgate, done in place

Bath repair is our most common job. A chip by the taps, a crack in the base and a rust spot by the plughole are all repaired in place, usually in a single visit. Our technicians work on acrylic, roll-top & freestanding and cast iron enamel, and people most often call us about chips caused by builders and a kit repair that didn’t last.

You are covered for a year from the day of the repair. Just call us if there’s a problem and we will sort it.

Where
Ramsgate (CT11, CT12, CT10)
Area hub
Kent
Cover
12 months on all our work
Price
From £95. Free and fixed, from your photos
Call
0345 017 0787
Page updated
23 October 2026
Before and after: a damaged acrylic bath corner repaired in place

Aftercare tips

Most damage we see is avoidable. A few tips:

  • Check that an acrylic bath does not move when you stand in it
  • Give the bath a quick rinse after use
  • Avoid scourers, wire wool and gritty cream cleaners
  • Stick to mild cleaners and a soft cloth

Clean with mild, non-abrasive cleaners and avoid dropping heavy items on the repaired area. Get any new chip seen to quickly, before rust can start.

Stop using the bath if a crack lets water through. Leaks under a bath can damage floors and ceilings.

Signs you need bath repair in Ramsgate

Baths take more knocks than people expect: everyday items get dropped into it all the time, and taps and wastes are tightened against the surface. Over time, chips and rust spots are almost inevitable.

You may need us if you’ve spotted any of these:

  • Chips caused by builders
  • A chip where the taps sit
  • A chipped rim or side
  • Hairline or through cracks in acrylic

What to look for in a quote

  • How the room is protected while they work
  • How the colour is matched
  • The length of the guarantee and what it covers
  • Who turns up on the day

10 questions to ask before you book

DIY repairs versus a professional job

What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, then guarantee it for a year.

Kits are cheap and easy to find, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.

Landlord and trade work in Ramsgate

For developers and builders, we fix damage before handover. We can visit several plots in one trip.

Rented homes see more wear and tear, and replacing items every time a tenant leaves is expensive. A repair between tenancies is a cheaper way to keep the property in good order.

What we do, step by step

It’s a tidy, low-fuss visit. We confirm the time with you beforehand, cover and mask the work area, and get on with the job, which generally takes two to three hours for most chips. If anything looks different from your pictures, we will talk to you before going ahead.

  1. We start by cleaning the damage and taking out loose enamel and rust.
  2. We fill the damage and sand it flush with the surrounding surface.
  3. We mix the colour on the day to match your bath’s exact shade.
  4. We build up the finish and polish it into the surrounding enamel.
  5. We leave it to cure; you can generally use the bath the next day.

How to prepare

  • Point us to the nearest place to park
  • Plan for the room to be out of bounds to pets and children
  • Mention if the room is upstairs or in a flat

Getting a price

There is no need for us to visit first. Nearly every job can be priced from photos: send a close-up, a wider shot and your postcode, and we will come back to you with a fixed figure.

Get a free quote

Read more

Your questions about bath repair in Ramsgate

Is a bath repair permanent?

Done properly, a repair lasts for years, and it’s guaranteed for a year. Gentle cleaning helps.

Is a repair better than a new one?

Generally, yes. Replacement brings removal, refitting and making good, which a repair avoids. We will be honest if it’s not worth it.

Will I be able to see the repair?

We aim for a repair you cannot easily find. How well it disappears depends on the condition of the rest of the bath, and we will tell you what to expect.

Will you leave a mess?

Very little mess: we sheet and mask everything nearby, and we leave the room clean.

Do you charge for travel?

Travel is included in the price, with the same prices everywhere we work.

How do I get a price for bath repair in Ramsgate?

Prices start from £95. We give a fixed quote based on pictures of the damage. Send a close-up and a photo of the entire item with your CT11 postcode.

Is it safe with children and pets around?

Yes, as long as they stay out of the room we are working in. We will let you know when it’s safe to use again.

Is a holed acrylic bath repairable?

Normally. Send us a picture of the hole and one from under the bath if you can.

Where we work around Ramsgate

Ramsgate is in Kent. Our work suits any type of property, old or new, large or small, plus businesses and rented homes. We work in 922 places in Kent. You can also see our page for London, about 66 miles away.

Here we cover the CT11, CT12 and CT10 postcode area. Jobs here include addresses on High Street, Church Road and High Street St Lawrence and the roads around them. With the A254 and A255 close by, Ramsgate is easy for our technicians to reach. If you are just outside Ramsgate, we cover St Lawrence (1 mile west), Northwood (1 mile north-west), Upton (1 mile north-east), Broadstairs (2 miles north-east) and St Peter's (2 miles north). Further out, we also cover Canterbury (15 miles west), Margate (3 miles north), Dover (15 miles south), Deal (8 miles south), Herne Bay (12 miles west) and Tower Hamlets (15 miles south).

Landmarks near Ramsgate

In Ramsgate, that means homes near The Derby Arms, St George's Boys School and St. Luke's Church and the streets around them. Other local landmarks include Priory Infant School (less than half a mile south) and Chatham House Grammar School (less than half a mile south-east). There is a railway station in Ramsgate itself: Ramsgate station. Other landmarks nearby include Westwood Cross (1.6 miles north-west) and Ramsgate Museum (less than half a mile south-east). The countryside around Ramsgate includes Sandwich and Pegwell Bay.

Map of Ramsgate © OpenStreetMap contributors

Repairs by material

Pressed steel

Steel baths and trays have a thin metal body under the enamel. Exposed steel rusts quickly, so the metal is treated and sealed before the repair.

Cast iron

Cast iron baths are thick and very strong, with a fused enamel surface. A chip down to the iron can rust, but the body of the bath lasts a very long time, which makes it well worth repairing.

Prices and what affects them

Prices start from £95. Each job gets its own fixed price. This is what makes a difference:

  • What the surface is made of
  • Any earlier repairs that need removing first
  • How many areas need work
  • What kind of damage it is

Every job is a little different, so we price each one individually. What’s damaged, how badly and how easy it is to reach all play a part, and doing several things on one visit costs less than separate visits.

Getting a price from photos

Photographing the damage takes a minute. Try to send:

  • A close-up of the damage, in focus
  • A picture taken from further back
  • A coin or ruler next to the damage for scale
  • Daylight if possible, and no flash reflection

Pricing is simple: take a close-up of the damage and a picture from further back, send them over with your postcode, and you will get a fixed price back. There is no charge for the quote and you are under no obligation.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.