Highland · Scotland

Bath Resealing for Arabella homes

Bath resealing for Arabella, without a refit. Get a fixed price from your photos, then book a visit.

  • Leaks at the edges
  • Mould you can’t clean out
  • Sealant that is split or lifting
Surface Doctor technician refinishing the outside of a roll-top bath

Need bath resealing in Arabella?

Where we work around Arabella

Arabella is about 13 miles north of Nairn, in Highland. Jobs in Arabella are booked in like any other job: a fixed quote from photos, and a technician at your door on the day. We work in all 253 towns and villages in Highland.

All of IV19 is covered, from the main roads to the quietest streets. Neighbouring places we cover include Hill of Fearn (2 miles north-east), Fearn (2 miles north-east), Pitcalnie (2 miles south), Kildary (2 miles west) and Nigg (3 miles south). Larger places within reach include Nairn (13 miles south), Tain (4 miles north-west), Alness (10 miles south-west), Dornoch (9 miles north), Invergordon (8 miles south-west) and Fortrose (13 miles south). If you’re somewhere remote, call first so we can plan the visit.

What’s near Arabella

The closest station to Arabella is Fearn station, roughly 1.5 miles north of the centre. Nearby you will also find Milntown Castle (2.6 miles south-west). Not far away are Loch Eye.

Map of Arabella © OpenStreetMap contributors

Bath resealing in Arabella, done in place

We reseal baths with them filled with water, so the joint is at its widest, which stops the new seal tearing the first time the bath is used. We work on kitchen worktops & sinks, baths and wet rooms, and common reasons people get in touch are black mould in the sealant and an untidy old seal.

You are covered after we leave: each job carries a one-year guarantee, and we explain what it covers before you book.

Where
Arabella (IV19)
Region
Highland
Guarantee
One year on every repair
Price
Free, fixed quote from pictures
Call
0345 017 0787
Last updated
23 October 2026
Technician in a mask working on a freestanding roll-top bath

What we do, step by step

It’s a tidy, low-fuss visit. We agree the arrival time in advance, cover and mask the work area, then carry out the work, which normally takes about two hours for a bath. If anything looks different from your pictures, we will talk to you before going ahead.

  1. The surrounding area is protected and the joints masked.
  2. We remove the old sealant and every trace of residue.
  3. We clean, treat and dry the joint.
  4. We run a continuous bead of new silicone.
  5. The bead is smoothed, the tape removed and the seal left to cure.

Before we arrive

  • Move bottles, mats and clutter away from the area
  • Mention any parking restrictions or tricky access
  • Have a window or extractor fan available

Getting a price

Pricing is simple: take a close-up of the damage and a picture from further back, send them to us with your postcode, and we will reply with a fixed price. There’s no charge for the quote and you are under no obligation.

Send pictures for a quote

Read more

What we’re called out for in Arabella

Joints split if the bath or tray moves, frequently because it was sealed with the bath empty.

Send us a picture if you notice any of these:

  • Silicone smeared on tiles
  • Black spots in the silicone
  • Silicone coming away from the tiles
  • Leaks at the edges

Questions to ask before booking

  • How long the guarantee is and what it covers
  • What happens if they find more damage
  • Who turns up on the day
  • Whether the price is fixed and includes VAT

Choosing a repair company

What affects the price in Arabella

Each job gets its own fixed price. This is what makes a difference:

  • Doing more than one item at once
  • The colour and finish to match
  • Previous DIY repairs that have to come out
  • Where the damage is and how we get to it

No two jobs are quite the same, so we price each one individually. The size and type of damage, the material and access all play a part, and combining jobs on one visit brings the cost down.

Getting a price from pictures

You can typically get a fixed price without us visiting. To help us price it:

  • One picture of the entire bath or shower
  • A clear, close picture of the problem area
  • The postcode, so we can plan the visit
  • Whether it’s been repaired or coated before

There is no need for us to visit first. Nearly every job can be priced from pictures: we need a close-up, a wider picture and your postcode, and we’ll come back to you with a fixed figure.

Can I fix it myself?

If you do try a kit, read the instructions carefully, make sure the area is clean and completely dry, and give it the full curing time. If it fails, we can still put it right.

Kits are cheap and easy to find, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.

Work for landlords and builders

We regularly price jobs from inventory or check-out pictures. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.

We carry out planned and one-off repairs for housing associations and facilities teams in Highland and across the UK. A repair avoids taking out and refitting, which is easier on the people living there.

Why reseal now?

Resealing is a small job. Putting off a reseal lets water get behind the bath or tray, and that damage costs much more to fix. Instead of hourly rates, we price the entire job up front. It depends on the damage, the material and access, and doing several items at once reduces it.

Why us?

  • Same prices wherever you are
  • Usually one visit, start to finish
  • CHAS, Constructionline and SafeContractor accredited
  • Everything repaired in place

Read our pricing.

FAQs for Arabella

It’s been repaired before. Can you still fix it?

Most of the time. Tell us what was done before.

What do you need from me?

Use the quote form or ring 0345 017 0787, and we will take it from there.

How soon can you come?

Your quote comes with available dates. Tell us if you need it done quickly.

How do I stop mould in sealant?

Damp is the cause. Ventilation and drying keep it clean longer.

Can you quote from pictures?

In nearly every case. We only ask to see it in person if the photos cannot show what we need.

Is the work guaranteed?

Yes, for a year. If anything goes wrong with the repair within the year, we return to fix it.

Do you hold any accreditations?

We are accredited with CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile.

Do you charge for travel?

We don’t add a call-out fee. The fixed price covers the visit and the work.

What we cannot put right

A repair is not always the answer, and we’ll tell you before we start. Repairs will not solve:

  • Tiles that move, until they’re refixed
  • Very wide gaps that need a trim
  • Hidden water damage

Send us photos and we’ll tell you honestly.

What we work on

  • Basins & vanity units
  • Shower trays & enclosures
  • Baths
  • Wet rooms
  • Kitchen worktops & sinks

Repairs by material

Baths

Baths are resealed with water in them, to open the joint fully.

Shower trays

We put weight on a tray before sealing it, for the same reason.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.