Shropshire · England
Worktop Repair for Eaton Constantine homes
Damaged worktop in Eaton Constantine? We put it right where it is, match it on site and guarantee the work for a year.
- Repairs from £95
- Knife marks
- Chips caused during installation
About our worktop repair in Eaton Constantine
Burns from hot pans, chips on edges and scratches from knives are the most common worktop repairs. All are repaired in place. We work on laminate, solid surface (such as Corian) and quartz, and common reasons people get in touch are chips in quartz or granite and damage from fitting or building work.
Big or small, you get the same one-year guarantee in Eaton Constantine and across Shropshire.
- Area
- Eaton Constantine (SY5)
- Area hub
- Shropshire
- Cover
- 12 months on all our work
- Quotes
- From £95. Fixed and free, based on photos
- Call
- 0345 017 0787
- Last updated
- 23 October 2026
DIY kit or professional repair?
Kits are cheap and easy to find, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.
DIY kits are sold for most surfaces, and they can make a small mark look better. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
Signs you need worktop repair in Eaton Constantine
Edges and corners chip most often, typically from pans, tins or dishes knocked against them.
Typical reasons for a call-out include:
- Burns from hot pans
- A chipped edge
- Knife marks
- Chips in quartz or granite
Comparing quotes
- How the room is protected while they work
- How soon you can use it again
- What prep work is covered
- Is the price fixed, and does it include VAT?
When a repair isn’t the answer
Some jobs aren’t right for a repair, including:
- Failed support under the worktop
- Laminate swollen by water from underneath
- Deep heat discolouration in quartz, which may not fully disappear
If in doubt, send photos and we’ll say what we think before you book.
Surfaces we repair
- Quartz
- Solid wood
- Laminate
- Granite & marble
- Solid surface (such as Corian)
Also in Eaton Constantine
What your worktop is made of matters
Laminate
Laminate is a printed surface over a board. We fill the damage and recreate the pattern by hand.
Quartz
Quartz is tough, though edges can chip. We fill chips with a tinted resin and polish them.
Repair or replace in Eaton Constantine?
An identical replacement may look different next to aged worktops. A repair is matched to what you have now. Repairs from £95, with every job priced individually. There are no surprise extras on the day. What we quote from your photos is what you pay, unless the damage turns out to be different, in which case we talk to you first.
Why Eaton Constantine customers choose us
- Everything repaired in place
- No extra charge for your area
- One-year guarantee on every repair
- Repair technicians who travel to you, UK-wide
See our pricing.
Our work in Eaton Constantine
Eaton Constantine is about 6 miles south-west of Telford, in Shropshire. Whether you’re in the middle of Eaton Constantine or on the outskirts, we offer exactly the same service: a fixed price, a tidy visit and a guarantee. Eaton Constantine is one of 433 towns and villages in Shropshire we cover. Our jobs stretch from Eaton Constantine to Birmingham (32 miles away).
Here we cover the SY5 postcode area. If you’re just outside Eaton Constantine, we cover Garmston (1 mile east), Leighton (1 mile south-east), Buildwas (3 miles south-east), Little Wenlock (3 miles east) and Homer (3 miles south). Within a short drive, we also cover Shrewsbury (8 miles north-west), Madeley (6 miles east), Bridgnorth (11 miles south-east), Coleham (7 miles north-west), Kingsland (8 miles north-west) and Belle Vue (7 miles north-west).
Near you in Eaton Constantine
Typical jobs here are in homes near Church of St Mary, among other places. The closest station to Eaton Constantine is Wellington (Shropshire) station, roughly 4.5 miles north-east. Well-known places in the area include Charlton Castle (3 miles north) and Wroxeter Roman Site And Museum (2.7 miles north-west). The countryside around Eaton Constantine includes The Ercall.
How to look after the repair
How the surface is treated afterwards matters. Here’s what we suggest:
- Use pH-neutral cleaners on stone
- Always use a trivet for hot pans
- Don’t knock pans against the edge
- Re-oil timber worktops
Hot pans should always go on a trivet. Even stone and quartz can be marked by heat.
Daily use can make burns and chips worse, especially near the sink. An earlier repair is a smaller repair.
Common questions in Eaton Constantine
Can you match granite flecks?
We match colour, flecks and veining by hand, so the repair blends into the surface.
Can you redo someone else’s repair?
Generally, yes. Tell us what was done before and we’ll plan for it.
Is it safe with children and pets around?
Just keep them out of the work area. We will let you know when it’s safe to use again.
Do the materials smell?
Expect a mild smell while we are working, which fades afterwards.
Do you hold any accreditations?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
How soon can you come?
It depends on the time of year and where you are. We will offer you dates when we send your quote.
Do you work for landlords and businesses?
Yes, often. We quote for multiple addresses and fit around tenancy changeovers.
What does worktop repair cost?
Prices start from £95. The exact price depends on the damage, so we quote from pictures. You’ll get a fixed figure before booking.
Work for landlords and builders
We work for landlords, letting agents and housing providers in Eaton Constantine as well as homeowners. A repair between tenants keeps the property empty for less time, and it generally costs far less than a refit.
We carry out planned and one-off repairs for housing associations and facilities teams. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
How the visit works
Here’s how a visit typically runs: we arrive on time, sheet and mask the area around the job, carry out the work and clear up. Allow a few hours, depending on the damage from start to finish. Before leaving, we tell you when it can be used and what to avoid for the first few days.
- First, we check the damage and the finish we need to match.
- Burnt or loose material is cut back.
- We fill and shape the damaged area.
- We recreate the pattern, flecks or grain.
- It’s finished to the same sheen and left to cure.
Before we arrive
- Ensure the room can be ventilated
- Mention any parking restrictions or tricky access
- Move bottles, mats and clutter away from the area
Getting a price
Getting a price is easy: snap the damage close up and then the whole item, send them over with your postcode, and we’ll reply with a fixed price. Quotes are free and you are under no obligation.
Related advice
About our accreditations · Every repair comes with a one-year guarantee.
