Cheshire West and Chester · England
Bath re-enamelling & resurfacing in Beeston, Cheshire West and Chester
We travel to Beeston for full bath re-enamelling and resurfacing. Everything is done in place, and the work is guaranteed.
- Resurfacing from £350
- Wear marks under the taps
- A bath that stays dull however much you clean it
About our bath re-enamelling in Beeston
We don’t move the bath, so your taps, tiles and plumbing are left alone. Most baths are done in one visit, and can be used again the next day. Typical jobs include thin, worn enamel in places and a period or roll-top bath worth keeping, across cast iron baths, pressed steel baths and Victorian roll-tops.
Every job is backed for twelve months, and the guarantee is the same wherever you live. If something goes wrong with the work, we come back.
- Where
- Beeston (CW6)
- County
- Cheshire West and Chester
- Guarantee
- 12 months on all our work
- Quote
- From £350. Free and fixed, from your pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
Landlord and trade work in Beeston
Rental properties take more wear, and replacing things at every changeover adds up. Repairing between tenants keeps the property presentable for less.
We also carry out snagging repairs for builders and developers, putting right damage done during fitting so nothing needs replacing. We hold CHAS, Constructionline and SafeContractor accreditations.
When a repair isn’t the answer
Some jobs are not right for a repair, for example:
- Steel that has corroded right through
- A poorly supported acrylic bath, until it’s firmed up
- Leaking taps or wastes (a plumber’s job)
Send us photos and we will tell you honestly.
Surfaces we repair
- Pressed steel baths
- Cast iron baths
- Acrylic baths
- Basins & shower trays
- Victorian roll-tops
Do you need bath re-enamelling in Beeston?
Hard water speeds up the wear, and gritty cleaners are the worst culprits.
Typical reasons for a call-out include:
- An original cast iron bath that needs restoring
- A coating lifting around the plughole
- Worn patches where water runs and sits
- Several chips and rust patches
Comparing quotes
- How soon you can use it again
- Whether they match the colour on site
- What the guarantee covers, and for how long
- Aftercare advice
Keeping it looking good
Looking after the surface is easy, and it makes a real difference:
- Get any chip repaired quickly
- Avoid suction-cup mats
- Do not use the bath until it has fully cured
- Stick to gentle, non-abrasive cleaners
Use mild, non-abrasive cleaners, don’t use suction bath mats, and don’t leave bottles or razors standing on the surface.
Worn enamel only gets rougher with time, and any rust spreads underneath. Resurfacing sooner means less repair work first.
How we price bath re-enamelling
Prices start from £350. We charge the same across the UK, including Beeston. What changes the price is:
- Access to the area
- Doing more than one item at once
- Previous DIY repairs that have to come out
- What the surface is made of
There are no surprise extras on the day. What we quote from your pictures is what you pay, and if the damage turns out to be different, we discuss it before starting.
Quotes from your pictures
Before you send pictures, a few simple things make all the difference:
- The material, if you know it
- A coin or ruler next to the damage for scale
- A clear, close picture of the problem area
- Good light, ideally daylight, without flash glare
The quickest way to a price is to send two or three photos through our quote form or call us. We will say straight away if a repair is the right fix.
Repair or replace: which is better?
Replacing the bath means a plumber, removing a heavy bath, making good the walls and tiles and several days without a working bathroom. Resurfacing gives the bath a new finish with the bath left where it is. Resurfacing from £350, with every job priced individually. No two jobs are quite the same, so each one is priced on its own. What’s damaged, how badly and how easy it is to reach all play a part, and combining jobs on one visit brings the cost down.
Why Beeston clients choose us
- CHAS and Constructionline accredited
- We’ll tell you if it’s not worth repairing
- Rooms protected and left tidy
- We come to you, anywhere in the UK
Take a look at our prices page or bath cost comparison.
Should I try a DIY kit first?
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
How the visit works
When we visit, we arrive at the time we have agreed, cover the area with dust sheets and masking, and set to work. The job typically takes the best part of a day. We tidy up before we leave and tell you when it’s ready to use.
- We check the bath and agree the finish with you.
- Everything around the bath is masked and covered.
- We degrease the bath, fix any damage and key the surface.
- We apply the primer and then the finish coats.
- The masking comes off, we tidy up and tell you when it can be used.
Getting ready for the visit
- Have a window or extractor fan available
- Keep pets and children out of the room while we work
- Point us to the nearest place to park
Ask for a price
Getting a price is easy: take a close-up of the damage and a photo from further back, send them over with your postcode, and we will reply with a fixed price. Quotes are free and you are under no obligation.
Advice
About Beeston
Beeston is about 8 miles south-west of Winsford, in Cheshire West and Chester. Anywhere in CW6, we come to you. We work in all 224 towns and villages in Cheshire West and Chester. You can also see our page for Liverpool, about 22 miles away.
Every address in CW6 is within our area. We regularly work on streets such as Moss Lane and Peckforton Road and the roads around them. Close by, we cover Beeston-brook (1 mile north-east), Peckforton (1 mile south), Tiverton (1 mile north), Hand Green (1 mile north) and Bunbury (1 mile east). We also work in nearby towns such as Chester (10 miles north-west), Ellesmere Port (14 miles north-west), Winsford (8 miles north-east), Northwich (12 miles north-east), Boughton (9 miles north-west) and Frodsham (12 miles north).
Local landmarks in Beeston
Our customers here include homes close to Beeston Towers and Tarporley High School and Sixth Form College and the streets around them. Other landmarks nearby include The Old Fire Station (2.5 miles north) and Tarporley War Memorial Hospital (2.6 miles north). Not far away are Bickerton Hill.
Beeston: your questions answered
Can you redo someone else’s repair?
Typically, yes. We remove the old repair before doing a new one, so mention it when you send photos.
Which areas do you work in?
The whole UK, including all of Cheshire West and Chester. Just include your postcode and we’ll offer you dates.
Is there a smell?
A little, during the work. Ventilation keeps it down, and it fades as the finish cures.
How durable is a resurfaced bath?
It depends on preparation, use and care. Properly prepared and looked after, it lasts well, and our work is guaranteed for a year.
Are you accredited?
Yes, including CHAS, Constructionline and SafeContractor. The full list is on our accreditations page.
Can you price it without visiting?
Usually, yes. Clear photos let us give you a fixed price without visiting.
Is there any odour?
Expect a mild smell while we’re working, which fades afterwards.
How long will the bath be out of use?
One day for most baths, ready the day after. We give you timings with the quote.
Places near Beeston
Other services in Beeston
About our accreditations · Every repair comes with a one-year guarantee.
