Devon · England

Bath re-enamelling & resurfacing in Belstone Corner, Devon

Full bath re-enamelling and resurfacing for homes and businesses in Belstone Corner and across Devon. Free, fixed quotes from your photos.

  • Resurfacing from £350
  • Wear marks under the taps
  • A coloured bath you want in white
Surface Doctor technician refinishing the outside of a roll-top bath

Bath re-enamelling for Belstone Corner homes

What happens on the day

A typical visit goes like this: we arrive at the agreed slot, sheet and mask the area around the job, carry out the work and clear up. Allow most of the day. Before we go, we will explain when it can be used and what to avoid for the first few days.

  1. First we look the bath over and confirm the finish.
  2. Taps, tiles and the floor are masked off.
  3. The bath is degreased, repaired and keyed.
  4. We apply the primer and then the finish coats.
  5. We remove the masking, tidy up and give you the curing time.

Before we arrive

  • Clear toiletries, mats and anything else from around the area
  • Plan for the room to be out of bounds to pets and children
  • Let us know about parking or access

How to get a price

Send us a photo of the damage and one of the entire item, with your EX20 postcode, and we’ll reply with a fixed quote.

Get a fixed price

Read more

Bath re-enamelling in Belstone Corner without replacing anything

When a bath is structurally fine but worn out on the surface, resurfacing is normally the best value. There is no removal, plumbing or tiling involved. If you’re dealing with a coloured bath you want in white and chips and rust in more than one place, we can usually put it right.

We guarantee the work for a year. If there is a problem with the repair within the year, we return and sort it.

Where
Belstone Corner (EX20)
Region
Devon
Warranty
12 months on all our work
Quotes
From £350. Fixed and free, based on pictures
Phone
0345 017 0787
Last updated
23 October 2026
Before and after: an old basin refinished to bright white

How we price bath re-enamelling

Prices start from £350. There’s no charge for travel to Belstone Corner. The price depends on:

  • Unusual colours or finishes
  • Access to the area
  • What kind of damage it is
  • What the surface is made of

Instead of hourly rates, we price the entire job up front. It depends on the damage, the material and access.

Quotes from your pictures

Almost every job we do is priced from pictures. This is what to send:

  • A picture taken from further back
  • Any earlier repairs or coatings
  • Daylight if possible, and no flash reflection
  • A coin or ruler next to the damage for scale

To get a price, send two or three pictures through our quote form or ring us. We will tell you honestly whether it can be repaired.

Keeping it looking good

Nothing complicated is needed:

  • Never use suction bath mats
  • Store bottles off the bath
  • Fix dripping taps quickly
  • A quick wipe after use keeps limescale away

Wipe the bath dry after use where you can, especially in hard water areas, and rinse off any bath products.

The longer worn enamel is left, the rougher it gets, and any rust spreads underneath. Resurfacing sooner means less repair work first.

Belstone Corner questions

Is it messy?

Dust sheets and masking go down before we start, and tidy up before we leave.

Do you come to Belstone Corner?

We do. Technicians travel to Belstone Corner from across the region, and the price is the same as everywhere else.

Do you cover the entire of Devon?

Everywhere in the UK, Belstone Corner included. Travel is included in the price.

Are you accredited?

We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.

How much does bath re-enamelling cost in Belstone Corner?

Prices start from £350. The exact price depends on the damage, so we quote from photos. You will get a fixed figure before booking.

What happens after I send pictures?

We look at the pictures and reply with a fixed price and some dates. If we need another angle, we will ask.

Can you do more than one item on the same visit?

Yes, and it’s often cheaper. Send pictures of everything together and we’ll quote them together.

Can you price it without visiting?

In nearly every case. If photos don’t show enough, we’ll ask for another angle.

Signs you need bath re-enamelling in Belstone Corner

Enamel does not fail overnight. Years of cleaning, hard water and hot baths wear the gloss away, starting where water runs and sits.

Most people contact us after spotting one of these:

  • A roll-top that is seen better days
  • An old resurfacing that is failing
  • Worn patches where water runs and sits
  • A dull, rough surface that will not come clean

What to look for in a quote

  • Aftercare advice
  • Whether a trained technician does the job
  • Whether there are any call-out or travel charges
  • How changes to the job are handled

Choosing a repair company

Where we work around Belstone Corner

Belstone Corner is about 18 miles north-east of Tavistock, in Devon. We work in every kind of home, old or new, large or small, plus businesses and rented homes. Belstone Corner is one of 586 places in Devon we cover.

Our visits in EX20 work the same way as everywhere else we cover. Close by, we cover Sampford Chapple (2 miles north), Sampford Courtenay (2 miles north), Stockley (3 miles south-west), Okehampton (3 miles south-west) and Sticklepath (3 miles south). Larger places within reach include Crediton (13 miles east), Great Torrington (15 miles north-west), Hatherleigh (7 miles north-west), North Tawton (3 miles north-east), Winkleigh (6 miles north) and Chagford (8 miles south-east).

Local landmarks in Belstone Corner

Our clients here include homes close to Countryman pub, among other places. The nearest railway station is Okehampton Interchange station, about 2.4 miles south-west of the centre. Well-known places in the area include Museum of Policing in Devon and Cornwall (3.1 miles south-west) and Okehampton Community Hospital (3 miles south-west). The countryside around Belstone Corner includes Cosdon Hill.

Map of Belstone Corner © OpenStreetMap contributors

Can I fix it myself?

The difference between a kit and a professional repair is mostly in the preparation and colour. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.

We understand the appeal of fixing it yourself. The trouble is that kit repairs frequently look fine at first and then fail, and the old filler has to come out before a proper repair.

Work for landlords and builders

Hospitality businesses can’t afford rooms out of action for long, so we keep visits short and tidy. We can work around your bookings.

We regularly work with letting and managing agents. Send the address, photos and access details and we will handle the rest.

When we would advise against a repair

A repair isn’t right for every job, for example:

  • Leaking taps or wastes (a plumber’s job)
  • A cast iron or steel bath that is cracked right through
  • Holes rusted through the metal

If in doubt, send photos and we will say what we think before you book.

Surfaces we repair

  • Cast iron baths
  • Victorian roll-tops
  • Pressed steel baths
  • Acrylic baths
  • Basins & shower trays

What your bath is made of matters

Cast iron

Cast iron baths are so heavy that repairing in place makes obvious sense. The enamel is the part that wears or chips, and that is the part we put right.

Roll-top and period baths

Freestanding roll-tops can be done inside and out, and the outside can be refinished too.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.