Pembrokeshire · Wales
Bath Re-enamelling in Bosherston
Bath re-enamelling in Bosherston without the cost of replacing. Send us photos for a fixed price, then book a visit.
- Resurfacing from £350
- Staining under the taps and around the waste
- Wear marks under the taps
Looking after it afterwards
Nothing complicated is needed:
- Have chips seen to early
- Store bottles off the bath
- Wash away dyes and oils after use
- Use washing-up liquid and a soft cloth
Rinse away dyes, oils and bath bombs straight after use, because they can mark the finish. Repair dripping taps promptly.
Do not try to scrub a worn bath back to shine. It removes more of the surface.
About our bath re-enamelling in Bosherston
Cast iron, steel, acrylic, roll-top and period baths can all be resurfaced. Several coats of finish go on over a bonding primer, after the bath has been cleaned, repaired and keyed. Our technicians work on basins & shower trays, cast iron baths and pressed steel baths, and common reasons people get in touch are a peeling or bubbling previous coating and an outdated colour you’d like to change.
You are covered for a year from the day of the repair. Just call us if there’s a problem and we’ll come back.
- Where
- Bosherston (SA71)
- County
- Pembrokeshire
- Guarantee
- 12 months on all our work
- Quote
- From £350. Free and fixed, from your photos
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
What affects the price in Bosherston
Prices start from £350. Prices are worked out job by job. What matters most is:
- How hard the colour is to match
- How many areas need work
- Any earlier repairs that need removing first
- What kind of damage it is
Instead of hourly rates, we fix the price before we start. Damage, material and access decide it, and combining items on one visit brings it down.
Quotes from your photos
When you take your pictures, these tips help us give you a firm price:
- Any earlier repairs or coatings
- Good light, ideally daylight, without flash glare
- A coin or ruler next to the damage for scale
- A close-up of the damage, in focus
Getting a quote takes a couple of minutes: photograph the damage, then the entire bath, add your postcode and send them to us. You will get a fixed price, not an estimate.
Places near Bosherston
More services for Bosherston
Where we work around Bosherston
Bosherston is about 8 miles south-east of Milford Haven, in Pembrokeshire. Clients in Bosherston get the same service as everywhere else we cover: a fixed price from your pictures, and a technician at your door on the day. Bosherston is one of 223 places in Pembrokeshire we cover.
All of SA71 is within our area. Nearby, we also work in Stackpole (2 miles north-east), Stackpole and Castlemartin (2 miles west), Merrion (2 miles north-west), St Twynnells (2 miles north-west) and Warren (3 miles north-west). Larger places within reach include Haverfordwest (13 miles north), Milford Haven (8 miles north-west), Pembroke (4 miles north), Pembroke Dock (5 miles north), The Marsh (13 miles north) and Dinbych-y-Pysgod (11 miles east).
Near you in Bosherston
Locally, our jobs take us to homes close to St. Govan's Country Inn and St Michael and All Angels' Church and the streets around them. The nearest railway station is Pembroke station, about 4.3 miles north of the centre. A little further out are South Pembrokeshire Hospital (5.5 miles north) and Castlemartin Castle (3.9 miles north-west). Not far away are Pembroke River middle and New Quay Stack.
Repairs by material
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we pay close attention there.
Roll-top and period baths
Freestanding roll-tops can be done inside and out, and the outside can be refinished too.
What we do, step by step
On the day, we arrive at the time we have agreed, cover the area with dust sheets and masking, and set to work. The job typically takes most of the day. We clean up when we’re done and let you know when you can use it again.
- We check the bath and agree the finish with you.
- Everything around the bath is masked and covered.
- The bath is degreased, repaired and keyed.
- Primer and finish coats are applied.
- The masking comes off, we tidy up and tell you when it can be used.
Before we arrive
- Make sure the area is dry
- Move bottles, mats and clutter away from the area
- Mention any earlier repairs or resurfacing
How to get a price
Getting a price is easy: snap the damage close up and then the whole item, send them over with your postcode, and we will reply with a fixed quote. There’s no charge for the quote and you’re under no obligation.
Related advice
Should I try a DIY kit first?
DIY kits are sold for most surfaces, and they can tidy up a tiny mark. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
If you’ve already tried a DIY fix, that is fine. We remove the old filler and start again, so it does not stop a professional repair. Just mention it when you send photos, as it can add time.
Your questions about bath re-enamelling in Bosherston
Do you cover the whole of Pembrokeshire?
All of Pembrokeshire, and the rest of the UK. Travel is included in the price.
Is it worth repairing rather than replacing?
Generally, yes. Replacement brings removal, refitting and making good, which a repair avoids. If it is not worth repairing, we will tell you.
When can you do it?
It depends on the time of year and where you are. We will offer you dates when we send your quote.
Is it OK to have pets in the house?
Yes, as long as they stay out of the room we are working in. We’ll let you know when it’s safe to use again.
Will you leave a mess?
Dust sheets and masking go down before we start, and tidy up before we leave.
Is there any odour?
A little, depending on the job. Ventilation keeps it to a minimum, and it soon fades.
Is there a smell?
Yes, while we are applying the finish. We set up ventilation and the smell fades as it cures.
Someone resurfaced my bath and it’s peeling. Can you help?
Yes, we do this regularly. Stripping the old coating adds time, so it’s reflected in the quote.
For landlords and businesses
For developers and builders, we fix damage before handover, so there’s no need to replace a damaged item at the last minute. Several plots can be done in one visit.
Letting agents often send us photos straight from the inventory. That means we can quote before you even visit the property, and we can arrange access with the tenant directly if that helps.
Honest limits
Not everything can be repaired, and we will tell you before we start. We can’t fix:
- Problems we can’t see until an old finish comes off
- A cast iron or steel bath that’s cracked right through
- A bath that is rusted through
Send us pictures and we will tell you honestly.
Surfaces we repair
- Cast iron baths
- Basins & shower trays
- Acrylic baths
- Pressed steel baths
- Victorian roll-tops
Repair or replace in Bosherston?
Replacing a cast iron bath is a big job: they’re heavy, frequently need breaking up, and a new one is not cheap. Re-enamelling avoids all of it. Our bath re-enamelling starts from £350. What it costs depends on the type and amount of damage, what it’s made of and how many jobs we combine into one visit. You get a fixed price from your photos, so you know the cost before you book.
Why Bosherston clients choose us
- Normally one visit, start to finish
- Honest advice, even when it means no job
- Rooms protected and left tidy
- Colour-matched on site
Read our prices page and guide to resurfacing and replacement costs.
About our accreditations · Every repair comes with a one-year guarantee.
