Shropshire · England
Bath Re-enamelling for Leebotwood homes
Full bath re-enamelling and resurfacing in Leebotwood, carried out at your home and guaranteed for a year.
- Resurfacing from £350
- Several chips and rust patches
- Staining under the taps and around the waste
Bath re-enamelling in Leebotwood without replacing anything
After cleaning, repairing and priming, we spray on the new finish. Most of the work, and most of the durability, is in the preparation, so we do not cut corners on it. If you’re dealing with stains that won’t shift and lots of chips and rust spots, we can usually put it right.
You are covered after we leave: each job carries a one-year guarantee, and we explain what it covers before you book.
- Area
- Leebotwood (SY6)
- County
- Shropshire
- Warranty
- One year on every repair
- Quote
- From £350. Fixed and free, based on pictures
- Call
- 0345 017 0787
- Page updated
- 23 October 2026
What we’re called out for in Leebotwood
Hard water speeds up the wear, and gritty cleaners are the worst culprits.
Customers normally contact us about:
- A bath that stays dull however much you clean it
- Wear marks under the taps
- An original cast iron bath that needs restoring
- Chips and rust in more than one place
What to look for in a quote
- A fixed quote, and whether VAT is included
- How to care for the finish
- What happens if they find more damage
- What the guarantee covers, and for how long
What we cannot put right
We will always be straight with you, so here’s what a repair won’t do:
- A poorly supported acrylic bath, until it’s firmed up
- Damage hidden under a previous coating, until it’s stripped back
- A cast iron or steel bath that’s cracked right through
Send us photos and we will tell you honestly before booking.
Surfaces we repair
- Basins & shower trays
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
- Pressed steel baths
Looking after it afterwards
Much of the damage we repair could have been avoided. A few tips:
- Dry the bath after use to stop limescale
- Do not leave bottles, razors or sponges standing on the surface
- Have chips seen to early
- Rinse off hair dye, oils and bath bombs straight away
Rinse the bath and wipe it over after use, especially in hard water areas, to stop limescale building up.
Do not try to scrub a worn bath back to shine. It removes more of the surface.
Different materials, different repairs
Acrylic
Acrylic feels warm and is light, but it needs firm support underneath. Repairs to cracks are reinforced from the back.
Pressed steel
Steel baths re-enamel well, once any rust has been treated. Rust around the waste is common on steel, so we check it carefully.
FAQs for Leebotwood
Will the price change on the day?
It’s rare, but if it happens we talk to you first. You decide whether to go ahead.
Which areas do you work in?
The whole UK, including all of Shropshire. Just include your postcode and we’ll offer you dates.
How durable is a resurfaced bath?
That depends on preparation and how the bath is treated. Properly prepared and looked after, it lasts well, and our work is guaranteed for a year.
Is there a call-out fee?
We don’t add a call-out fee. The fixed price covers the visit and the work.
Are you a vetted contractor?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
Can you repair several things at once?
Yes. Combining jobs on one visit brings the cost down. Send pictures of everything you’d like done.
Will the bath be moved?
No, it stays where it is. We work on the bath in place, with the room masked and ventilated.
Do you come to Leebotwood?
Yes. We cover the entire UK and travel to Leebotwood. Send us photos for a fixed quote, or call 0345 017 0787.
How the visit works
Here’s how a visit typically runs: we arrive at the agreed slot, sheet and mask the area around the job, carry out the work and clear up. Allow most of the day. Before leaving, we tell you how long to leave it and how to care for it.
- First we protect the bathroom and set up ventilation.
- Next we degrease the bath and fix chips and rust spots.
- The surface is prepared and a bonding primer applied.
- We spray on the new enamel finish in several coats.
- We leave it to cure, and it’s usually ready the day after.
Before we arrive
- Let the surface dry out before the visit
- Tell us if there are stairs or a lift
- Move bottles, mats and clutter away from the area
Getting a price
Upload pictures of the damage and a wider shot of the entire item, and tell us you are in Leebotwood, and we will reply with a fixed price.
Related advice
What affects the price in Leebotwood
Resurfacing from £350. You will not pay by the hour. The price depends on:
- What the surface is made of
- Previous DIY repairs that have to come out
- How much damage there is
- The colour and finish to match
A repair is priced on what needs doing, not your postcode. You’ll see the full price before you book, with nothing added on the day.
Getting a price from photos
Phone pictures are fine. Just make sure we can see:
- One sharp close-up of the damage
- Your postcode, so we can check dates
- Good light, ideally daylight, without flash glare
- A wider photo showing the whole bath
There’s no need for us to visit first. Photos are enough for us to price nearly every job: we need a close-up, a wider picture and your postcode, and we’ll reply with a fixed price.
Should I try a DIY kit first?
What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
We understand the appeal of fixing it yourself. The risk is that a kit repair hides the damage for a while, then fails, and then the old filler has to be removed first.
Covering Leebotwood
Leebotwood is about 9 miles south of Shrewsbury, in Shropshire. Across the SY6 area, we carry out the work at your property. Our technicians cover 433 places across Shropshire. You can also see our page for Birmingham, about 38 miles away.
Here we cover the SY6 postcode area. Nearby, we also work in Longnor (1 mile north-east), All Stretton (2 miles south-west), Gilberries (4 miles south-east), Hope Bowdler (4 miles south) and Wall under Heywood (5 miles south-east). Larger places within reach include Shrewsbury (9 miles north), Madeley (14 miles east), Bridgnorth (15 miles east), Coleham (8 miles north), Ludlow (15 miles south) and Kingsland (9 miles north).
Landmarks near Leebotwood
Our customers here include homes close to Church of St Mary and the streets around them. Leebotwood’s nearest station is Church Stretton station, about 3.4 miles south. A little further out are The Jensen Museum (3.4 miles south) and Worsley Castle Hill (2 miles south-west). Open spaces near Leebotwood include The Lawley.
Work for landlords and builders
We also carry out snagging repairs for builders and developers, fixing chips and scratches before handover. We hold CHAS, Constructionline and SafeContractor accreditations.
Rented homes see more wear and tear, and replacing things at every changeover adds up. A repair between tenancies is a cheaper way to keep the property in good order.
Also near Leebotwood
Other services in Leebotwood
About our accreditations · Every repair comes with a one-year guarantee.
