Bradford · England

Bath re-enamelling & resurfacing in Marsh, Bradford

Damaged bath in Marsh? We repair it in place, mix the colour on the day and guarantee the work for a year.

  • Resurfacing from £350
  • Worn patches where water runs and sits
  • Chips and rust in more than one place
Surface Doctor technician refinishing the outside of a roll-top bath

Bath re-enamelling in Marsh

When to call us in Marsh

Enamel’s shine is only skin deep, and abrasive cleaning slowly wears it away. After years of use, the surface becomes porous and stains easily.

Signs it’s time to call us include:

  • A bath in a colour that no longer suits
  • A peeling or bubbling previous coating
  • A bath that stays dull however much you clean it
  • Lots of chips and rust spots

Questions to ask before you book

  • How long it needs to cure
  • Whether the price covers travel
  • Who turns up on the day
  • How your room will be protected

Our hiring checklist

How we handle bath re-enamelling in Marsh

Re-enamelling gives a worn bath a new glossy surface without a refit. It suits baths that are dull, stained, rough or chipped all over. If you’re dealing with thin, worn enamel in places and a bath in a colour that no longer suits, we can help.

All our work is covered by our one-year guarantee, wherever you are in Bradford.

Where
Marsh (BD22)
County
Bradford
Cover
12 months on all our work
Price
From £350. Free and fixed, from your photos
Call
0345 017 0787
Updated
23 October 2026
Technician in a mask working on a freestanding roll-top bath

When we’d advise against a repair

Before you book, it’s worth knowing the limits too:

  • A bath that is rusted through
  • Problems we cannot see until an old finish comes off
  • A bath split right through the body

Send us pictures and we’ll tell you honestly before booking.

Materials we repair

  • Basins & shower trays
  • Pressed steel baths
  • Cast iron baths
  • Victorian roll-tops
  • Acrylic baths

Our work in Marsh

Marsh is about 1 mile south-west of Haworth, in Bradford. From the centre of Marsh to the outlying streets, the service is the same: a fixed quote, a tidy visit and a guarantee. We cover 140 places across Bradford. Our jobs stretch from Marsh to Leeds (about 17 miles away).

Every address in BD22 is within our area. Streets in the area include Lee Lane, Marsh Lane and Cross Lane, and we cover them all. Neighbouring places we cover include Oxenhope (1 mile south-east), Haworth (1 mile north-east), Cackleshaw (1 mile north-east), Lumb Foot (1 mile north-west) and Stanbury (1 mile north-west). Further out, we also cover Bradford (8 miles east), Keighley (4 miles north-east), Bingley (6 miles north-east), Shipley (8 miles east), Baildon (8 miles east) and Great Horton (8 miles east).

Local landmarks in Marsh

Our customers here include homes close to Penistone Hill Country Park, Bay Horse Public House and Oxenhope CofE Primary School and the streets around them. Marsh’s nearest station is Keighley station, roughly 4.3 miles north-east of the centre. Nearby you’ll also find Ingrow Loco Museum (3.2 miles north-east) and Haworth (1.2 miles north-east). The countryside around Marsh includes Redcar Tarn.

Map of Marsh © OpenStreetMap contributors

Work for landlords and builders

For anyone letting property in or around Marsh, we can repair and quote for several addresses together. Just send photos for each address and we’ll price them together.

Letting agents often send us pictures straight from the inventory. That means we can quote before you even visit the property, and we liaise with tenants about access if you’d like us to.

How it works

When we visit, we arrive at the time we have agreed, cover the area with dust sheets and masking, and set to work. The job normally takes most of the day. We tidy up before we leave and let you know when you can use it again.

  1. We mask and protect the room and ventilate it.
  2. The bath is cleaned, degreased and any chips or rust repaired.
  3. We key the surface and put on a bonding primer.
  4. Several coats of new finish are sprayed on.
  5. Once cured, normally by the day after, the bath is ready.

How to prepare

  • Mention if the room is upstairs or in a flat
  • Clear the area around the damage
  • Let us know about parking or access

Get a quote

Pricing is simple: snap the damage close up and then the whole item, send them over with your postcode, and we will reply with a fixed price. Quotes are free and you are under no obligation.

Send photos for a quote

Related advice

DIY kit or professional repair?

If you’ve already tried a DIY fix, that’s fine. We take the old repair out and do it properly, so it will not stop us repairing it. Just mention it when you send pictures, as it can add time.

A kit can be fine for a tiny mark out of sight. For anything you look at every day, anything that has rusted, cracked or holed, or anything on a coloured surface, a professional repair is worth it.

Looking after it afterwards

To keep it looking its best for years:

  • Wash away dyes and oils after use
  • Stick to gentle, non-abrasive cleaners
  • Store bottles off the bath
  • Repair dripping taps early

The first few days matter most: let it cure fully, then use mild cleaners only. After that, no abrasives and no suction mats.

Worn enamel only gets rougher with time, and any rust spreads underneath. Acting earlier keeps the preparation simpler.

Common questions in Marsh

Do you come to Marsh?

Yes. We cover the entire UK and travel to Marsh and the rest of Bradford. Send us pictures for a fixed quote, or call 0345 017 0787.

How do I book?

Just pictures, your postcode and a contact number. On the day, access to the room.

Can you price it without visiting?

Normally, yes. Clear photos let us give you a fixed price without visiting.

Do you hold any accreditations?

Yes. Our accreditations include CHAS, Constructionline and SafeContractor. The full list is on our accreditations page.

It’s been repaired before. Can you still fix it?

Yes, regularly. It can add a little time, which we include in the quote.

Can you repair several things at once?

Yes, and it’s frequently cheaper. Send pictures of everything together and we’ll quote them together.

Will there be a smell?

A little, depending on the job. Ventilation keeps it to a minimum, and it soon fades.

Do I need to be at home?

Someone needs to let us in and show us the job. After that, you can carry on with your day.

Repairs by material

Acrylic

Acrylic feels warm and is light, but it relies on good support. Repairs to cracks are reinforced from the back.

Cast iron

Cast iron baths are so heavy that repairing in place makes obvious sense. The enamel is the part that wears or chips, and that’s what we repair.

Repair or replace in Marsh?

A refit takes several trades and several days. Resurfacing is one technician, normally in a day, and the bath can be used the day after. Prices start from £350. Instead of hourly rates, we price the entire job up front. It depends on the damage, the material and access.

Why choose Surface Doctor in Marsh

  • Most jobs done in one visit
  • Same prices wherever you are
  • Every repair guaranteed for a year
  • Accredited with CHAS, Constructionline and SafeContractor

Take a look at our prices page or resurfacing vs replacement cost guide.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.