Gwynedd · Wales
Bath Re-enamelling in Tabor
We travel to Tabor for full bath re-enamelling and resurfacing. Everything is done in place, with a one-year guarantee.
- Resurfacing from £350
- Lots of chips and rust spots
- A dull, rough surface that won’t come clean
About our bath re-enamelling in Tabor
We re-enamel a lot of period and roll-top baths, which would be difficult and expensive to replace. Resurfacing them in place keeps the original bath. Common call-outs are for a coating lifting around the plughole and several chips and rust patches, on pressed steel baths, cast iron baths and basins & shower trays.
Every repair comes with our one-year guarantee.
- Area
- Tabor (LL40)
- County
- Gwynedd
- Guarantee
- 12 months on all our work
- Quote
- From £350. Fixed and free, based on pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
What affects the price in Tabor
Resurfacing from £350. There are no hourly rates or hidden extras. The price depends on:
- How hard the colour is to match
- The type of damage
- How many areas need work
- Previous DIY repairs that have to come out
Our prices are the same across the UK, with no extra for Tabor. What changes the price is the job itself: the material, the amount of damage and how many items.
Quotes from your pictures
Before you send pictures, a few simple things make all the difference:
- A coin beside the damage so we can judge size
- Daylight if possible, and no flash reflection
- One sharp close-up of the damage
- A wider photo showing the entire bath
Ring 0345 017 0787, or send us pictures through the quote form. With one close-up and one wider picture, we can price the job without visiting.
When a repair isn’t the answer
We’ll always be straight with you, so here’s what a repair won’t do:
- An acrylic bath that flexes badly underfoot
- Anything hidden under an old coating, until we remove it
- A bath that is rusted through
If in doubt, send pictures and we’ll say what we think.
Surfaces we repair
- Acrylic baths
- Cast iron baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
DIY kit or professional repair?
The difference between a kit and a professional repair is mostly in the preparation and colour. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
It’s tempting to reach for a kit, but the repairs we redo most often are DIY ones that have discoloured or lifted. Doing it properly first is usually the cheaper route.
Landlord and trade work in Tabor
We carry out planned and one-off repairs for housing associations and facilities teams in Gwynedd and across the UK. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
Rented homes see more wear and tear, and replacing things at every changeover adds up. Repairing between tenants keeps the property presentable for less.
Questions from Tabor
How quickly can you book me in?
We will give you dates with your quote. If it’s urgent, say so and we will do what we can.
Can you quote from pictures?
Yes, almost always. A close-up and a wider photo are enough to give a fixed price.
Can you re-enamel a roll-top bath?
Yes. We can do the inside and outside.
Can a failed resurfacing be redone?
Yes, we do this regularly. Stripping the old coating adds time, so it’s reflected in the quote.
Do you need to take the bath out?
No. We resurface it in place, so the tiles and taps stay put.
Can pets and children be at home?
Keep pets and children away from the work area on the day.
Do you work for landlords and businesses?
Yes. We carry out repairs for homeowners, landlords, letting agents, builders and businesses in Tabor.
How long will the bath be out of use?
Most baths are done in a day, ready the next day. We give you timings with the quote.
The process
On the day itself, there is little for you to do. Let us in and show us the room, and we’ll take it from there. Most visits take a full day, including clearing up.
- The bathroom is protected and ventilation set up.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- We key the bath and apply a bonding primer.
- The new finish is sprayed on in several coats and left to cure until the next day.
Getting ready for the visit
- Clear the area around the damage
- Tell us if there are stairs or a lift
- Open a window if you can
Get a quote
If you’re in Tabor and want a price, the easiest route is photos: one close up, one from further back, plus your postcode. You’ll get a fixed quote with dates to choose from.
Related advice
Tabor and nearby
Tabor is about 25 miles north-east of Aberystwyth, in Gwynedd. Whether you are in the middle of Tabor or on the outskirts, we offer exactly the same service: fixed prices, tidy work and a one-year guarantee. We work in 165 places in Gwynedd, from the larger towns to small villages. You can also see our page for Liverpool, about 60 miles away.
We work across the LL40 postcode area and the streets around it. Close by, we cover Wenallt (1 mile west), Dolgellau (1 mile west), Llanelltyd (3 miles north-west), Rhydymain (4 miles north-east) and Aberllefenni (5 miles south). We also work in nearby towns such as Tywyn (15 miles south-west), Barmouth (9 miles west), Pen-dre (14 miles south-west), Harlech (14 miles north-west) and Fairbourne (9 miles west).
Local landmarks in Tabor
Locally, our jobs take us to homes close to St Mark's Church and Ysgol y Gader. A little further out are Tŷ Siamas (1.4 miles west) and Dolgellau and Barmouth Hospital (1.3 miles west). Green spaces nearby include Pen y Bwlch-coch and Llyn Cynwch.
How to care for the repair
Most damage we see is avoidable. These habits help:
- Wash away dyes and oils after use
- Don’t leave a chip unrepaired
- Store bottles off the bath
- Repair dripping taps early
A quick rinse and wipe after use helps, especially in hard water areas, so limescale cannot build up.
Avoid scrubbing a dull bath with abrasive cleaners. It removes more of the surface and makes resurfacing more work.
What your bath is made of matters
Cast iron
Re-enamelling suits cast iron baths perfectly. The body lasts for generations; only the enamel wears, so a new finish makes them look new again.
Acrylic
We resurface acrylic baths as well, using a system that bonds to acrylic. The bath needs to be firm and well supported for the finish to last.
Towns and villages near Tabor
Also in Tabor
When to call us in Tabor
Enamel does not fail overnight. Abrasive cleaners, limescale and years of use wear the gloss away, starting where water runs and sits.
Send us a photo if you notice any of these:
- A period or roll-top bath worth keeping
- An outdated colour you’d like to change
- An old resurfacing that is failing
- A dull, rough surface that will not come clean
Comparing quotes
- How to care for the finish
- Whether the price is fixed and includes VAT
- What protection goes down before work starts
- What the guarantee covers, and for how long
About our accreditations · Every repair comes with a one-year guarantee.
