North Yorkshire · England

Bath Repair in Hazlewood

Chip and crack repairs to enamel, acrylic and cast iron baths in Hazlewood, carried out at your home and guaranteed for a year.

  • Repairs from £95
  • Chips on the rim or sides
  • Scuffs and scratches in the surface
Surface Doctor technician refinishing the outside of a roll-top bath

Trusted bath repair in Hazlewood

Covering Hazlewood

Hazlewood is about 4 miles north-west of Ilkley, in North Yorkshire. Wherever you are in the BD23 postcode area, a technician comes to you. Hazlewood is one of 626 towns and villages in North Yorkshire we cover. Our nearest city page is Leeds, about 17 miles away.

Every address in BD23 is covered, from the main roads to the quietest streets. Close by, we cover Beamsley (1 mile south-west), Langbar (2 miles south), Nesfield (3 miles south), Addingham (3 miles south) and Small Banks (3 miles south). We also work in nearby towns such as Harrogate (13 miles east), Skipton (6 miles west), Starbeck (15 miles east), Bilton (13 miles east), Harlow Hill (12 miles east) and Pannal (13 miles east).

Landmarks near Hazlewood

Around Hazlewood, we work in homes near The Boyle and Petyt Primary School and Priory Church of St Mary & St Cuthbert and the streets around them. The nearest railway station is Ilkley station, roughly 4.2 miles south-east of the centre. Further afield, we also cover the area around Ilkley Coronation Hospital (4.4 miles south-east). For a walk, there is Earl Seat.

Map of Hazlewood © OpenStreetMap contributors

Bath repair in Hazlewood without replacing anything

Most of our bath repairs take a few hours, and you can normally bathe again the day after. There’s no need to book a plumber or tiler, because nothing is disconnected. Whether it’s a failed DIY repair that’s discoloured or lifting and a chipped rim or side, we can normally put it right.

We stand behind the work with a one-year guarantee, so you’re covered after the visit.

Where
Hazlewood (BD23)
Area hub
North Yorkshire
Cover
A year, on every repair
Price
From £95. Free and fixed, from your photos
Telephone
0345 017 0787
Page updated
23 October 2026
Rusty chip next to a bath plughole, before and after repair

The process

We begin by going over the job with you, so you know exactly what we are doing. Next, we cover and mask everything nearby and we start. Allow a morning or an afternoon.

  1. First, we check the damage against your pictures and agree the plan.
  2. Any rust and loose material comes out, and the area is degreased.
  3. The damage is filled in layers and shaped to the curve of the bath.
  4. We tint the finish by hand to match the bath.
  5. The repair is polished to the same gloss as the bath and left to cure.

Preparing for the visit

  • Point us to the nearest place to park
  • Ensure the area is dry
  • Make sure the room can be ventilated

How to get a price

Email us a photo of the damage and a wider shot of the entire item, and tell us you’re in Hazlewood, and we will come back with a fixed quote.

Get a free quote

Advice

Prices and what affects them

Repairs from £95. Prices are worked out job by job. The main factors are:

  • Whether we combine several jobs
  • The colour and finish to match
  • The material and finish
  • How much damage there is

Every job is a little different, so each one is priced on its own. What’s damaged, how badly and how easy it is to reach all make a difference, and doing several things on one visit costs less than separate visits.

Send pictures for a quote

We price nearly every job from photos. This is what we need:

  • Any earlier repairs or coatings
  • A close-up of the damage, in focus
  • A coin beside the damage so we can judge size
  • Your postcode, so we can check dates

The quickest way to a price is to send two or three pictures through our quote form or ring us. We will tell you honestly whether it can be repaired.

What your bath is made of matters

Composite and resin

Composite baths are dense and solid. Chips and scratches are filled and matched, just like other baths.

Acrylic

An acrylic bath is a moulded sheet strengthened from below. There’s no rust, but cracks, holes and scratches happen, and a crack only stays repaired if it’s supported underneath.

Common problems we fix in Hazlewood

The usual cause is something heavy dropped into the bath, and building work is a common culprit. Acrylic baths crack for a different reason: the bath isn’t properly supported, so it flexes under weight.

It’s worth getting a quote if you see:

  • A chip where the taps sit
  • Scuffs and scratches in the surface
  • Cracks in an acrylic bath
  • Rust spots around the plughole

Comparing quotes

  • How the colour is matched
  • If travel is included in the price
  • What preparation is included
  • Whether a trained technician does the job

Choosing a repair company

What a repair cannot fix

A repair isn’t always the answer, and we would rather say so up front. We cannot fix:

  • Rust that has eaten right through a steel bath
  • Cracks in parts of an acrylic bath we cannot get to from below
  • Leaking fittings, which need a plumber

If in doubt, send photos and we will say what we think before you book.

Surfaces we repair

  • Pressed steel enamel
  • Cast iron enamel
  • Roll-top & freestanding
  • Whirlpool & spa baths
  • Acrylic

Hazlewood: your questions answered

Do you repair coloured baths?

Yes. We mix the colour on the day to match, including older coloured suites.

What happens next?

We review the photos and send a fixed quote.

Is it OK to have pets in the house?

Keep pets and children away from the work area on the day, mainly so nothing gets touched before it has cured.

Do you hold any accreditations?

Yes, including CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.

Can I add another job to the visit?

Of course, and it normally saves money. Just add the extra items to your pictures and we’ll quote them together.

Is it worth repairing rather than replacing?

In most cases, yes. Replacement brings removal, refitting and making good, which a repair avoids. If it isn’t worth repairing, we will tell you.

How quickly can you book me in?

Your quote comes with available dates. Tell us if you need it done quickly.

Can you redo someone else’s repair?

Yes, we often do. It can add a little time, which we include in the quote.

Should I try a DIY kit first?

Kits are cheap and easy to find, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Doing it properly first is typically the cheaper route.

If you’ve already tried a DIY fix, that is fine. We remove the old filler and start again, so it won’t stop us repairing it. It does add a little time, so tell us about it when you send photos.

Keeping it looking good

Much of the damage we repair could have been avoided. These habits help:

  • A dripping tap stains enamel, so fix it early
  • Don’t leave razors or cans standing in the bath
  • Put a towel in the bath if you are working above it
  • Don’t scrub with anything abrasive

Give the repair the full curing time we recommend before running a bath. After that, gentle cleaning keeps it looking good.

A small chip is a quick job. Left alone, they stain and can rust, so early repair saves time and money.

Work for landlords and builders

Hotels, guest houses and holiday lets need rooms back in use quickly, so most of our work is done in a single visit. We can work around your bookings.

Letting agents often send us pictures straight from the inventory. That means we can quote before you even visit the property, and we can arrange access with the tenant directly if that helps.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.