Staffordshire · England
Bath chip & crack repair in Walton-on-the-Hill, Staffordshire
Chip and crack repairs to enamel, acrylic and cast iron baths in Walton-on-the-Hill, carried out at your home and guaranteed for a year.
- Repairs from £95
- Rust by the waste and overflow
- Damage done while the bathroom was being fitted
About our bath repair in Walton-on-the-Hill
We repair just the damaged spot and colour-match it to the bath, which costs far less than replacing a fitted bath and the tiles around it. Most baths can be used again the next day. If you’re dealing with cracks in an acrylic bath and impact holes in acrylic, we can normally put it right.
All our work is covered by a one-year guarantee, wherever you are in Staffordshire.
- Where
- Walton-on-the-Hill (ST17)
- Region
- Staffordshire
- Guarantee
- 12 months on all our work
- Quotes
- From £95. Free, fixed price from pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Prices and what affects them
Prices start from £95. There are no hourly rates or hidden extras. The price is based on:
- Whether it’s a chip, crack, burn or wear
- The size and number of damaged areas
- How many items we do on one visit
- What the surface is made of
It helps to know what pushes a price up or down: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Photos let us give you a fixed figure.
How to get a fixed quote
Photographing the damage takes a minute. Please include:
- A picture taken from further back
- Any details about the material
- One sharp close-up of the damage
- Whether it’s been repaired or coated before
Upload a photo of the damage and a wider shot of the whole item, with your ST17 postcode, and we’ll reply with a fixed price.
Can I fix it myself?
If you’ve already tried a DIY fix, that’s fine. We remove the old filler and start again, so it does not stop a professional repair. Just mention it when you send photos, as it can add time.
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is typically the cheaper route.
Do you need bath repair in Walton-on-the-Hill?
Damage during fitting is very common. Tradespeople drop tools and tiles into the bath, frequently before anyone notices. We repair snagging damage like this regularly.
Get in touch if you’ve noticed:
- A chipped rim or side
- Chips under the taps
- Rusty patches near the plughole
- Cracks in an acrylic bath
Comparing quotes
- Aftercare advice
- What preparation is included
- How changes to the job are handled
- Whether they match the colour on site
Walton-on-the-Hill and nearby
Walton-on-the-Hill is about 3 miles south-east of Stafford, in Staffordshire. Whether you’re in the middle of Walton-on-the-Hill or on the outskirts, we offer exactly the same service: fixed prices, tidy work and a one-year guarantee. We work in all 512 towns and villages across Staffordshire, from the larger towns to small villages. Our jobs stretch from Walton-on-the-Hill to Birmingham (23 miles away).
We cover every part of the ST17 postcode area and the streets around it. From Oak Avenue, Elm Avenue and School Lane or anywhere nearby, we can come to you. We also travel to Berkswich (1 mile north-west), Milford (1 mile east), Brocton (1 mile south-east), Baswich (1 mile north-west) and Tixall (1 mile north-east). Larger places within reach include Stafford (3 miles north-west), Cannock (6 miles south), Lichfield (12 miles south-east), Longton (14 miles north), Rugeley (6 miles east) and Burntwood (9 miles south-east).
Local landmarks in Walton-on-the-Hill
Our clients here include homes close to Walton High School, Berkswich CofE (VC) Primary School and St Thomas' Church Walton and the streets around them. The closest station to Walton-on-the-Hill is Stafford station, roughly 2.7 miles north-west of the centre. A little further out are The Staffordshire Police Museum (0.7 miles west) and Stafford Castle (3.6 miles west). Not far away are Tixall Wide and Radford Meadows.
More services for Walton-on-the-Hill
Keeping it looking good
Nothing complicated is needed, just a few sensible habits:
- Clean with warm water and a mild detergent
- Avoid scourers, wire wool and gritty cream cleaners
- Store metal items away from the bath
- Get a dripping tap fixed promptly
A repaired bath needs no special treatment, just sensible cleaning. Avoid bleach-based and gritty cleaners and give it a rinse after each bath.
Tape over a fresh chip or crack until it’s repaired, to keep water out. Take it off before we arrive.
Honest limits
Honesty matters more than a booking, so here’s what a repair cannot fix:
- Flexing caused by a failed cradle or loose feet
- Leaking fittings, which need a plumber
- A bath worn all over, where resurfacing makes more sense
Not sure? Send photos and we will give you a straight answer before you book.
What we work on
- Whirlpool & spa baths
- Acrylic
- Roll-top & freestanding
- Cast iron enamel
- Pressed steel enamel
What happens on the day
On the day, we arrive at the time we’ve agreed, cover the area with dust sheets and masking, and set to work. Expect it to take a few hours, depending on the damage. We tidy up before we leave and let you know when you can use it again.
- First, we check the damage against your photos and agree the plan.
- Loose enamel, rust and dirt are removed so the repair can bond.
- The damage is filled in layers and shaped to the curve of the bath.
- The colour is tinted by hand until it matches.
- The repair is polished to the same gloss as the bath and left to cure.
Before we arrive
- Open a window if you can
- Mention if the room is upstairs or in a flat
- Tell us about parking, stairs or access
Ask for a price
For most jobs, pictures are all we need to give you a price. Add a line about what happened and your postcode, and we’ll send back a fixed quote and some dates.
Read more
Common questions in Walton-on-the-Hill
Are you a vetted contractor?
Yes, including CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.
How invisible is a bath repair?
We aim for a repair you cannot easily find. The rest of the bath’s condition makes a difference, and we will tell you what to expect.
Can landlords book you?
Yes. We carry out repairs for homeowners, landlords, letting agents, builders and businesses.
Can you price it without visiting?
Yes, almost always. Clear photos let us give you a fixed quote without visiting.
I’m a tenant. Can you help?
Yes. Ask your landlord first, and we can send them the quote if that helps.
Is my repair covered?
Every repair comes with a one-year guarantee. We’ll explain what it covers when we quote.
What information do you need?
A close-up, a wider photo and your postcode. Then we’ll agree a date.
Something went through my bath. Can it be fixed?
In most cases. Send us a picture of the hole and one from under the bath if you can.
For landlords and businesses
We carry out planned and one-off repairs for housing associations and facilities teams in Staffordshire and across the UK. A repair avoids taking out and refitting, which matters when someone is living in the home.
For developers and builders, we fix damage before handover, saving last-minute replacements. We can visit several plots in one trip to keep costs down.
What your bath is made of matters
Acrylic
An acrylic bath is a moulded sheet strengthened from below. They do not rust, but they can crack, scratch or be holed, and cracks need support from behind to stay fixed.
Cast iron
A cast iron bath is heavy enough that most people never want to move it. The enamel is the part that wears or chips, and that’s what we repair.
About our accreditations · Every repair comes with a one-year guarantee.
