Shropshire · England
Bath Repair for Worthen homes
Bath repair for Worthen, without a refit. Get a fixed price from your pictures, then book a visit.
- Repairs from £95
- Chips caused by builders
- Hairline or through cracks in acrylic
Bath repair in Worthen without replacing anything
We repair enamelled steel, cast iron and acrylic baths. Each material is repaired a little differently: metal baths need any rust dealt with first, and acrylic cracks need support from behind. We regularly repair roll-top & freestanding, acrylic and pressed steel enamel, and common reasons people get in touch are deep scratches in acrylic and snagging damage from a refit.
You get a one-year guarantee, the same in Worthen as everywhere else we work.
- Where
- Worthen (SY5)
- County
- Shropshire
- Guarantee
- 12 months on all our work
- Quotes
- From £95. Free, fixed price from pictures
- Call
- 0345 017 0787
- Last updated
- 23 October 2026
Worthen questions
Will the repair show?
We aim for a repair you can’t easily find. How well it disappears depends on the condition of the rest of the bath.
Is my repair covered?
Yes, for a year. If anything goes wrong with the repair within the year, we return to fix it.
Can you redo an old repair?
Yes. We remove the old filler and start again. Tell us about it when you send pictures.
What does bath repair cost?
Repairs from £95. Because every job differs, we price from pictures. You’ll get a fixed figure before booking.
Do I have to be there?
We need someone to let us in. You don’t need to watch us work.
Can rust on a bath be repaired?
Yes. We remove the rust and loose enamel, fill the area, then colour-match the finish.
Can a cracked acrylic bath be fixed?
In most cases. We reinforce the crack from behind, then fill and refinish the front, so access behind the panel is important.
Is it messy?
We protect the room with dust sheets and masking first, and tidy up before we leave.
How the visit works
When we visit, the technician arrives at the agreed time, protects the room with dust sheets and masking and gets started. Expect it to take two to three hours for most chips. We tidy up before we leave and let you know when you can use it again.
- Dust sheets and masking go down around the bath.
- We clean, key and degrease the damage.
- Filler goes in and is sanded flush once it has set.
- Colour and gloss are matched to the surrounding surface.
- We tidy up and tell you when the bath can be used, normally the next day.
Getting ready for the visit
- Have a window or extractor fan available
- Tell us if there are stairs or a lift
- Avoid using the area for a few hours before we arrive
How to get a price
Upload a photo of the damage and one of the whole item, and tell us you’re in Worthen, and we will reply with a fixed price.
Advice
What your bath is made of matters
Acrylic
An acrylic bath is a moulded sheet strengthened from below. There is no rust, but cracks, holes and scratches happen, and a crack only stays repaired if it’s supported underneath.
Composite and resin
Stone resin and composite baths are heavy and solid, and often freestanding. Chips and scratches can be filled and colour matched, just like other baths.
Do you need bath repair in Worthen?
Baths take more knocks than people expect: everyday items get dropped into it all the time, and taps and wastes are tightened against the surface. Over time, chips and rust spots are almost inevitable.
You may need us if you’ve spotted:
- A hole punched through by something heavy
- A chip where the taps sit
- Chips caused by builders
- A chipped rim or side
Before you book anyone
- How the colour is matched
- How changes to the job are handled
- What aftercare is recommended
- How long the guarantee is and what it covers
Aftercare tips
How the surface is treated afterwards matters. Here’s what we suggest:
- Avoid scourers, wire wool and gritty cream cleaners
- If an acrylic bath flexes, have its feet adjusted
- Give the bath a quick rinse after use
- A dripping tap stains enamel, so fix it early
Treat the repaired area like the rest of the bath: warm water, washing-up liquid and a soft cloth. Avoid scourers and gritty cream cleaners.
A small chip is a quick job. Leave them and they collect dirt, stain and, on metal baths, rust, so it’s worth getting them done early.
What we can’t put right
A repair isn’t right for every job, including:
- A bath that flexes because its feet or cradle have failed (that needs fixing first)
- Leaks from the waste or overflow fittings (a plumber’s job)
- Cracks in acrylic we cannot reach from underneath
Not sure? Send photos and we’ll give you a straight answer before you book.
What we work on
- Pressed steel enamel
- Roll-top & freestanding
- Whirlpool & spa baths
- Cast iron enamel
- Acrylic
Should I try a DIY kit first?
If you do try a kit, read the instructions carefully, and don’t use it until it has fully cured. If it fails, we can still put it right.
What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
Also near Worthen
More services for Worthen
Landlord and trade work in Worthen
We’re used to working with agents and managing companies. Just send pictures, the address and how to get access.
We carry out planned and one-off repairs for housing associations and facilities teams in Shropshire and across the UK. A repair avoids taking out and refitting, which matters when someone is living in the home.
Covering Worthen
Worthen is about 12 miles south-west of Shrewsbury, in Shropshire. Whether you’re in the middle of Worthen or on the outskirts, the service is the same: a fixed quote, a tidy visit and a guarantee. Worthen is one of 433 places in Shropshire we cover. We work right across the region, from Worthen to Birmingham (about 48 miles away).
Every address in SY5 is covered, from the main roads to the quietest streets. Nearby, we also work in Pentirvin (2 miles south), Bentlawnt (2 miles south), Hopesgate (2 miles south-east), Westley (3 miles north-east) and Horsebridge (3 miles east). Within a short drive, we also cover Shrewsbury (12 miles north-east), Coleham (11 miles north-east), Kingsland (11 miles north-east), Belle Vue (11 miles north-east), Monkmoor (13 miles north-east) and Bagley (12 miles north-east).
Around Worthen
Around Worthen, we work in homes near Church of All Saints and Long Mountain CofE Primary School and the streets around them. Further afield, we also cover the area around Aston Rogers Pond House (1.6 miles north-east). For a walk, there’s Long Mountain.
What affects the price in Worthen
Repairs from £95. There’s no area surcharge for Worthen. The price reflects:
- How hard the colour is to match
- The size and number of damaged areas
- Doing more than one item at once
- The material and finish
We charge the same wherever you are, so there’s no premium for Worthen. The job itself decides the price: how much damage, what it’s made of and how many items.
Getting a price from pictures
Most quotes are done from pictures alone. To help us price it:
- One picture of the whole bath
- A clear, close picture of the problem area
- Your postcode, so we can check dates
- Daylight if possible, and no flash reflection
Ring 0345 017 0787, or send us photos through the quote form. With a clear picture of the damage and one of the whole bath, we can give you a fixed quote without visiting.
About our accreditations · Every repair comes with a one-year guarantee.
