Perth and Kinross · Scotland

Bath Resealing in Kinross

Our repair technicians come to Kinross for bath, shower and sink resealing with new mould-resistant silicone. Nothing is taken out, and the work is guaranteed.

  • An untidy old seal
  • Black mould in the sealant
  • Damp near the bath
Surface Doctor technician refinishing the outside of a roll-top bath

Bath resealing in Kinross

Bath resealing in Kinross, done in place

All of the old sealant is cut out, deal with any mould, and apply fresh mould-resistant silicone. We reseal baths, showers, sinks and worktops, including the awkward bits behind the taps. We regularly repair basins & vanity units, shower trays & enclosures and kitchen worktops & sinks, and common reasons people contact us are discoloured, yellow sealant and gaps by the taps.

Your repair is guaranteed for a year, as with every job we do.

Roll-top bath being refinished by a Surface Doctor technician
Location
Kinross (KY13)
Region
Perth and Kinross
Cover
One year on every repair
Quotes
Free and fixed, from your photos
Telephone
0345 017 0787
Last updated
23 October 2026

What affects the price in Kinross

A fixed quote means you know the cost before you book. We look at:

  • How many areas need work
  • Access to the area
  • The colour and finish to match
  • The material

Compared with replacing, repairing normally costs far less, because nothing has to be taken out, refitted or made good. The quote lists exactly what you’re paying for.

How to get a fixed price

Photographing the damage takes a minute. Try to send:

  • Good light, ideally daylight, without flash glare
  • A clear, close picture of the problem area
  • Any details about the material
  • A coin or ruler next to the damage for scale

To get a price, send a couple of pictures using our quote form or ring us. We will tell you honestly whether it can be repaired.

When we would advise against a repair

We won’t take on work that won’t last, so these are the limits:

  • A flexing bath
  • Gaps so wide they need filling or trims before sealing
  • Hidden water damage

Not sure? Send pictures and we’ll give you a straight answer.

Materials we repair

  • Baths
  • Shower trays & enclosures
  • Kitchen worktops & sinks
  • Basins & vanity units
  • Wet rooms

Kinross and the surrounding area

Kinross is about 10 miles north of Dunfermline, in Perth and Kinross. From the centre of Kinross to the outlying streets, the service is the same: fixed prices, tidy work and a one-year guarantee. Kinross is one of 107 places in Perth and Kinross where we work. We work right across the region, from Kinross to Edinburgh (20 miles away).

Postcode districts we cover here: KY13. That includes homes on Station Road, High Street and Mcbain Place and the roads around them. You’ll find Kinross on the A922 and A977, which makes it straightforward to reach. Other places close to Kinross include Milnathort (1 mile north), Balado (1 mile west), Gairney Bank (2 miles south), Gairneybridge (3 miles south) and Wester Balgedie (3 miles east). Larger places within reach include Perth (13 miles north), Auchterarder (12 miles north-west), Letham (13 miles north), Scone (15 miles north), Tulloch (14 miles north) and Oakbank (12 miles north). Kinross is one of the larger places we cover in Perth and Kinross.

Local landmarks in Kinross

Around Kinross, we work in homes near The Green Hotel, St Paul's Episcopal Church and Kinross High School and the streets around them. Other landmarks nearby include Michael Bruce Cottage Museum (3.8 miles east) and Loch Leven Castle (1.6 miles south-east). Not far away are Loch Leven and Loch Leven National Nature Reserve.

Map of Kinross © OpenStreetMap contributors

Repairs by material

Shower trays

Trays are sealed with weight on them, so the joint is at its widest.

Baths

We fill the bath before sealing, to open the joint fully.

Landlord and trade work in Kinross

We regularly work with letting and managing agents. Send the address, photos and access details and we’ll handle the rest.

We also carry out snagging repairs for builders and developers, putting right damage done during fitting. We hold CHAS, Constructionline and SafeContractor accreditations.

The process

Your technician turns up at the time we agreed with you and checks the damage against your pictures first. The floor and nearby surfaces are covered before we open a single tin. Most visits take about two hours for a bath, and the room is left clean and tidy.

  1. The surrounding area is protected and the joints masked.
  2. Old sealant and residue are removed.
  3. We clean, treat and dry the joint.
  4. We run a continuous bead of new silicone.
  5. The bead is smoothed, the tape removed and the seal left to cure.

Before we arrive

  • Open a window if you can
  • Tell us if there are stairs or a lift
  • Clear the area around the damage

Get a quote

Ring 0345 017 0787, or send us pictures through the quote form. With one close-up and one wider picture, we can give you a fixed price without visiting.

Get a free quote

Related advice

Signs you need bath resealing in Kinross

Sealant does not last forever. Every bath or shower adds moisture and soap residue, which mould loves, and the joint moves slightly every time the bath is filled.

Look out for any of the following:

  • Leaks at the edges
  • Gaps by the taps
  • Black spots in the silicone
  • Silicone smeared on tiles

What your quote should include

  • Whether the price covers travel
  • Is the price fixed, and does it include VAT?
  • How the room is protected while they work
  • What preparation is included

Our hiring checklist

Your questions about bath resealing in Kinross

When can you do it?

We will give you dates with your quote. If it’s urgent, say so and we will do what we can.

Will you leave a mess?

No. The work area is masked and covered, and we leave the room clean.

Can you repair several things at once?

Yes. Combining jobs on one visit brings the cost down. Include photos of each item.

It’s been repaired before. Can you still fix it?

In most cases. We remove the old repair before doing a new one.

Will there be a smell?

There can be some smell while we work. It fades as everything cures.

Are you a vetted contractor?

Yes, including CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.

Can you quote from photos?

Nearly always. If pictures don’t show enough, we’ll ask for another angle.

Do I have to be there?

Yes. The technician needs access to the room for the visit, at a time that suits you.

Looking after it afterwards

A little care keeps the finish looking good. Our advice:

  • Keep the joints dry
  • Clean the sealant gently and regularly
  • Use the extractor fan
  • Don’t stand toiletries on the seal

Good ventilation is the best protection, and wipe the joints after use to keep mould away.

Black mould in sealant is not just unsightly, it’s a sign moisture is sitting in the joint. An early reseal keeps water where it belongs.

Why reseal now?

Compared with repairing water damage, resealing is cheap. It’s quick, tidy and protects your home. Rather than charging by the hour, we fix the price before we start. It depends on the damage, the material and access, and doing several items at once reduces it.

Why Kinross clients choose us

  • We leave the room as we found it
  • One-year guarantee on every repair
  • Fixed prices from your photos
  • No extra charge for your area

Take a look at our full price list.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.