Lincolnshire · England
Bath Re-enamelling in Brand End
Our repair technicians come to Brand End for full bath re-enamelling and resurfacing. Everything is done in place, with a one-year guarantee.
- Resurfacing from £350
- Thin, worn enamel in places
- A dull, rough surface that will not come clean
About our bath re-enamelling in Brand End
We don’t move the bath, so the taps, tiles and plumbing are not touched. Most baths are done in one visit, with the bath ready to use the following day. Whether it’s an original cast iron bath that needs restoring and a bath that stays dull however much you clean it, we can typically put it right, on cast iron baths, pressed steel baths and Victorian roll-tops alike.
Peace of mind is built in: our one-year guarantee applies to every job, and we explain what it covers before booking.
- Area
- Brand End (PE22)
- Region
- Lincolnshire
- Guarantee
- 12 months on all our work
- Quotes
- From £350. Free, fixed price from pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
How we price bath re-enamelling
Resurfacing from £350. A fixed quote means you know the cost before booking. We look at:
- Whether we combine several jobs
- Unusual colours or finishes
- The material
- How many areas need work
Instead of hourly rates, we fix the price before we start. It depends on the damage, the material and access, and combining items on one visit brings it down.
How to get a fixed price
It only takes a minute to photograph the damage, and it saves a visit. Try to send:
- Any earlier repairs or coatings
- A wider photo showing the entire bath
- The material, if you know it
- A clear, close picture of the problem area
For most jobs, photos are all we need to give you a price. Add a line about what happened and your postcode, and we’ll send back a fixed quote and some dates.
When to call us in Brand End
A dull surface stains and holds dirt, and scrubbing it wears it down further. At that stage, resurfacing is the fix.
You may need us if you’ve spotted any of these:
- Stains that will not shift
- Several chips and rust patches
- An outdated colour you’d like to change
- A roll-top that’s seen better days
Questions to ask before booking
- A fixed quote, and whether VAT is included
- How your room will be protected
- How to look after the finish
- What prep work is covered
Honest limits
Some jobs are not right for a repair, including:
- Acrylic that moves when you stand in it
- A cast iron or steel bath that is cracked right through
- Problems we cannot see until an old finish comes off
Send us photos and we will tell you honestly.
Surfaces we repair
- Basins & shower trays
- Victorian roll-tops
- Pressed steel baths
- Cast iron baths
- Acrylic baths
Covering Brand End
Brand End is about 3 miles east of Boston, in Lincolnshire. We work in every kind of home, old or new, large or small, plus businesses and rented homes. Our technicians cover 732 places across Lincolnshire, from the larger towns to small villages.
Our technicians cover all of PE22 and the streets around it. Streets in the area include Homers Lane, Spittal Hill Road and Swanhole Lane, all of which we cover. Nearby, we also work in Butterwick (1 mile south-east), Haltoft End (1 mile west), Freiston (1 mile south), Benington (1 mile north-east) and Benington Sea End (2 miles east). Within a short drive, we also cover Boston (3 miles west), Holbeach (13 miles south), Pinchbeck (15 miles south-west), Witham (4 miles west), Long Sutton (14 miles south) and Staniland (4 miles west).
Landmarks near Brand End
In Brand End, that means homes near Kings Head pub, The Butterwick Pinchbeck's Endowed CofE Primary School and Church of St Andrew. The nearest railway station is Boston station, roughly 3.5 miles west. Further afield, we also cover the area around Pilgrim Hospital (2.6 miles west) and We'll Meet Again Homefront Museum (2.2 miles south-east). For a walk, there is Freiston Shore RSPB reserve.
Can I fix it myself?
We understand the appeal of fixing it yourself. The trouble is that kit repairs frequently look fine at first and then fail, and the old filler has to come out before a proper repair.
You can buy a DIY kit for most repairs, and they can make a small mark look better. Where they fall down is colour and preparation: they come in a handful of shades, and if the surface is not prepared the repair won’t last.
What happens on the day
Here’s how a visit typically runs: we arrive at the agreed slot, sheet and mask the area around the job, carry out the work and clear up. Plan for a full day from start to finish. Before leaving, we tell you how long to leave it and how to look after it.
- We mask and protect the room and ventilate it.
- Next we degrease the bath and fix chips and rust spots.
- We prepare the surface and apply a bonding primer.
- We spray several coats of new enamel finish.
- The bath is left to cure and can normally be used the following day.
Preparing for the visit
- Point us to the nearest place to park
- Let the surface dry out before the visit
- Ensure the room can be ventilated
Get a quote
No survey visit is needed: we price from pictures. Use the quote form, or ring 0345 017 0787 to talk it through.
Related advice
Common questions in Brand End
Can a failed resurfacing be redone?
Yes, we do this regularly. Removing the old finish takes extra time, which we include in the price.
Is repairing better than replacing?
In most cases, yes. Replacement brings removal, refitting and making good, which a repair avoids. If it isn’t worth repairing, we will tell you.
What happens next?
We look at the photos and reply with a fixed quote and some dates. If we need another angle, we will ask.
I’m a tenant. Can you help?
Yes, though it’s best to check with your landlord first. Landlords are often glad to have it sorted.
Do you cover the whole of Lincolnshire?
All of Lincolnshire, and the rest of the UK. There is no extra charge for travel.
Do I need to be at home?
Yes. The technician needs access to the room for the visit, at a time we agree with you.
Can you repair several things at once?
Yes. Combining jobs on one visit brings the cost down. Send pictures of everything you’d like done.
Is it OK to have pets in the house?
We ask you to keep children and pets out of the room while we work and until it has cured. Everywhere else in the home is fine.
How to look after the repair
After the repair has cured, a few habits help it last:
- Dry the bath after use to stop limescale
- Respect the curing time we give you
- Clean with a soft cloth and mild detergent
- Don’t let dyes or oils sit on the finish
Rinse the bath and wipe it over after use, particularly where water is hard, so limescale can’t build up.
Worn enamel only gets rougher with time, and rust spots spread under the surface. Resurfacing sooner means less repair work first.
Repair or replace in Brand End?
When the bathroom is fine apart from the bath’s finish, resurfacing is the simplest answer. Nothing else is disturbed. Prices start from £350. Our prices are the same across the UK, with no extra for Brand End. What changes the price is the job itself: how much damage, what it’s made of and how many items.
Why Brand End customers choose us
- Colour-matched on site
- Nothing taken out or refitted
- We leave the room as we found it
- Honest advice, even when it means no job
See our prices page and bath cost comparison.
For landlords and businesses
Landlords, letting agents and housing providers in Brand End use us as well as homeowners. A repair between tenants keeps the property empty for less time, and it costs much less than replacing.
We are used to working with agents and managing companies. Send the address, pictures and access details and we will arrange it.
Nearby places to Brand End
Also in Brand End
About our accreditations · Every repair comes with a one-year guarantee.
