North Yorkshire · England
Bath re-enamelling & resurfacing in Cloughton Newlands, North Yorkshire
We travel to Cloughton Newlands for full bath re-enamelling and resurfacing. Everything is done in place, and the work is guaranteed.
- Resurfacing from £350
- Thin, worn enamel in places
- Chips and rust in more than one place
What we do, step by step
Here’s how a visit normally runs: we arrive on time, sheet and mask the area around the job, carry out the work and clear up. Allow the best part of a day. Before we go, we’ll explain how long to leave it and how to look after it.
- The bathroom is protected and ventilation set up.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- We key the bath and apply a bonding primer.
- Several coats of finish are sprayed on, then it cures until the next day.
How to prepare
- Avoid using the area for a few hours before we arrive
- Mention if the room is upstairs or in a flat
- Tell us about parking, stairs or access
Ask for a price
A quote takes minutes to ask for: take one close-up and one wider shot of the bath, add your postcode and send them over. What comes back is a fixed quote, not a guess.
Related advice
Bath re-enamelling in Cloughton Newlands without replacing anything
Re-enamelling gives a worn bath a new glossy surface without taking anything out. It’s the answer when the whole bath is tired rather than one spot. We’re frequently asked to fix thin, worn enamel in places and an old resurfacing that’s failing, across Victorian roll-tops, pressed steel baths and cast iron baths.
You’re covered for a year from the day of the repair. If anything is not right, ring us and we will sort it.
- Area
- Cloughton Newlands (YO13)
- Area hub
- North Yorkshire
- Guarantee
- One year on every repair
- Price
- From £350. Free and fixed, from your pictures
- Phone
- 0345 017 0787
- Last updated
- 23 October 2026
FAQs for Cloughton Newlands
Which areas do you work in?
All of North Yorkshire, and the rest of the UK. There’s no extra charge for travel.
Will the bath be moved?
Not at all. Everything is done in your bathroom, with the room masked and ventilated.
Can you fix a peeling bath coating?
Usually, yes. We strip the failing coating and resurface it properly. Tell us about it when you ask for a quote.
Is repairing better than replacing?
Usually, if the item is otherwise sound. A repair avoids removal and making good. If replacing would be better, we will say so.
Is it safe with children and pets around?
Just keep them out of the work area. We’ll let you know when it’s safe to use again.
Is my repair covered?
All our work carries our one-year guarantee. Ask us what it covers when you get your quote.
Is there any odour?
There may be a mild smell during the work that clears as it cures.
How long does re-enamelling last?
It depends on preparation, use and care. Properly prepared and looked after, it lasts well, and our work is guaranteed for a year.
Repair or replace: which is better?
Replacing a bath can take several days across several trades. Re-enamelling is one technician, generally one day. Prices start from £350. The price reflects the work involved, not your postcode. You will see the full price before you book.
What you get with us
- CHAS, Constructionline and SafeContractor accredited
- Every repair guaranteed for a year
- Most jobs done in one visit
- Colour-matched on site
See our pricing and resurfacing vs replacement cost guide.
DIY kit or professional repair?
A kit can be fine for a tiny mark out of sight. For damage in plain view, cracks, holes or rust, or coloured finishes, a professional repair is worth it.
If you do try a kit, read the instructions carefully and work on a clean, dry surface, and give it the full curing time. If it does not work out, we can still repair it properly.
How to look after the repair
How the surface is treated afterwards matters:
- Have chips seen to early
- Stick to gentle, non-abrasive cleaners
- A dripping tap should be fixed promptly
- Never use suction bath mats
Rinse the bath and wipe it over after use, particularly where water is hard, to stop limescale building up.
The longer worn enamel is left, the rougher it gets, and rust spots spread under the surface. Acting earlier keeps the preparation simpler.
Our work in Cloughton Newlands
Cloughton Newlands is about 5 miles north of Scarborough, in North Yorkshire. Customers in Cloughton Newlands get the same service as everywhere else we cover: a fixed quote from photos, and a technician at your door on the day. Cloughton Newlands is one of 626 places in North Yorkshire where we work. Our jobs stretch from Cloughton Newlands to Leeds (about 58 miles away).
Here we cover the YO13 postcode area. Other places close to Cloughton Newlands include Cloughton (1 mile south), Lind Head (1 mile south-west), Crowdon (1 mile north-west), Burniston (2 miles south) and Staintondale (2 miles north-west). We also work in nearby towns such as Scarborough (5 miles south), Whitby (12 miles north-west), Falsgrave (5 miles south), Filey (11 miles south-east), Pickering (15 miles south-west) and Northstead (4 miles south).
Around Cloughton Newlands
Typical jobs here are in homes near The Bryherstones Country Inn and Church of St Mary. The closest station to Cloughton Newlands is Scarborough station, about 5 miles south. Well-known places in the area include Cross Lane Hospital (3.6 miles south) and Scarborough Castle (4.8 miles south-east).
Prices and what affects them
Resurfacing from £350. We charge the same across the UK, including Cloughton Newlands. The price reflects:
- How hard the colour is to match
- What the surface is made of
- How much damage there is
- Whether we combine several jobs
Our prices are the same across the UK, with no extra for Cloughton Newlands. What changes the price is the job itself: how much damage, what it’s made of and how many items.
How to get a fixed quote
Photographing the damage takes a minute. Try to send:
- A wider photo showing the entire bath
- One sharp close-up of the damage
- Your postcode, so we can check dates
- Any details about the material
Pricing is simple: snap the damage close up and then the entire item, send them over with your postcode, and we’ll reply with a fixed quote. There is no charge for the quote and no obligation.
Places near Cloughton Newlands
Other services in Cloughton Newlands
When we would advise against a repair
A repair is not right for every job, including:
- Leaking taps or wastes (a plumber’s job)
- Problems we cannot see until an old finish comes off
- Acrylic that moves when you stand in it
Not sure? Send pictures and we will give you a straight answer before you book.
Surfaces we repair
- Basins & shower trays
- Acrylic baths
- Cast iron baths
- Victorian roll-tops
- Pressed steel baths
What we are called out for in Cloughton Newlands
Enamel’s shine is only skin deep, and every scrub with an abrasive cleaner takes a little away. Eventually the surface turns porous and stains.
If you can see any of these, send us a picture:
- Staining under the taps and around the waste
- A dull, rough surface that will not come clean
- An original cast iron bath that needs restoring
- A peeling or bubbling previous coating
Questions to ask before booking
- How to care for the finish
- How long the guarantee is and what it covers
- Whether the price covers travel
- What prep work is covered
What your bath is made of matters
Cast iron
Cast iron baths are the classic candidate for re-enamelling. They’re built to last, and only the surface wears, so a new finish makes them look new again.
Acrylic
Acrylic is light and warm to the touch, but it needs firm support underneath. Cracks are strengthened from behind before the front is finished.
About our accreditations · Every repair comes with a one-year guarantee.
