Staffordshire · England
Bath re-enamelling & resurfacing in Coton, Staffordshire
Bath re-enamelling for Coton, without a refit. Send us pictures for a fixed price, then book a visit.
- Resurfacing from £350
- An outdated colour you’d like to change
- A dull, rough surface that won’t come clean
How we handle bath re-enamelling in Coton
Many of the baths we re-enamel are period roll-tops, which would be difficult and expensive to replace. Resurfacing them in place keeps the original bath. We work on Victorian roll-tops, pressed steel baths and cast iron baths, and people most often call us about worn patches where water runs and sits and a dull, rough surface that won’t come clean.
Big or small, it’s backed by a one-year guarantee in Coton and across Staffordshire.
- Area
- Coton (ST18)
- Region
- Staffordshire
- Guarantee
- A year, on every repair
- Quotes
- From £350. Free, fixed price from pictures
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
Honest limits
A repair is not always the answer, and we would rather say so up front. Repairs will not solve:
- Problems we cannot see until an old finish comes off
- A poorly supported acrylic bath, until it’s firmed up
- A bath that’s rusted through
If in doubt, send pictures and we will say what we think.
Materials we repair
- Victorian roll-tops
- Cast iron baths
- Pressed steel baths
- Acrylic baths
- Basins & shower trays
Different materials, different repairs
Cast iron
A cast iron bath is heavy enough that most people never want to move it. The enamel is the part that wears or chips, and that is the part we put right.
Roll-top and period baths
Freestanding roll-tops can be done inside and out, and the outside can be refinished too.
Do you need bath re-enamelling in Coton?
By the time a bath is a few decades old, it may have a mix of issues: worn patches, chips, rust spots and stains. Resurfacing sorts them out together.
If you can see any of these, send us a photo:
- Wear marks under the taps
- Several chips and rust patches
- A coating lifting around the plughole
- A bath that stays dull however much you clean it
Questions to ask before booking
- Whether cleaning and preparation are in the price
- The length of the guarantee and what it covers
- Whether they match the colour on site
- Whether there are any call-out or travel charges
Questions from Coton
Can you change the colour of my bath?
Yes. Coloured baths can be resurfaced in white, and we can do the rest of the suite as well.
Can I get a quote without a visit?
Usually, yes. Clear pictures let us give you a fixed price without visiting.
Can you repair something that is been repaired before?
Yes, we often do. Removing the old work can add time, and that is in the quote.
Will the price change on the day?
If we find something the pictures didn’t show, we explain it first. The price only changes if you agree.
Are there extra charges for Coton?
No. Our quotes include travel, and we charge the same wherever you are.
Will it make a mess?
We protect the room with dust sheets and masking first, and we clean up when we have finished.
Does re-enamelling smell?
There is some smell while the coating is applied, which is why we ventilate the bathroom. It clears as the finish cures.
How much does bath re-enamelling cost in Coton?
Prices start from £350. Because every job differs, we price from photos. You’ll get a fixed figure before booking.
DIY repairs versus a professional job
If you are set on a kit, follow its instructions closely, make sure the area is clean and completely dry, and don’t use it until it has fully cured. If it fails, we can still put it right.
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
What bath re-enamelling costs
Resurfacing from £350. You will know the full cost before you book. We take into account:
- Previous DIY repairs that have to come out
- The type of damage
- How much damage there is
- Unusual colours or finishes
Set against the cost of replacement, repairing normally costs far less, because there is no removal, plumbing or making good. Your fixed quote shows exactly what’s included.
Send pictures for a quote
We price nearly every job from pictures. This is what we need:
- One picture of the whole bath
- A close-up of the damage, in focus
- Where you are, by postcode
- Good light, ideally daylight, without flash glare
A quote takes minutes to ask for: take one close-up and one wider shot of the bath, include your postcode and send them over. What comes back is a fixed quote, not a guess.
The process
It’s a tidy, low-fuss visit. We agree the arrival time in advance, protect the area, and get on with the job, which normally takes a full day. If anything looks different from your photos, we’ll talk to you before going ahead.
- The bathroom is protected and ventilation set up.
- Old sealant is cut out and the bath is deep cleaned.
- Chips, rust and pitting are repaired.
- We key the bath and apply a bonding primer.
- The new finish is sprayed on in several coats and left to cure until the following day.
Preparing for the visit
- Let us know if it has been repaired before
- Have a window or extractor fan available
- Plan for the room to be out of bounds to pets and children
Get a quote
Email us a picture of the damage and one of the entire item, with your ST18 postcode, and we will reply with a fixed quote.
Related advice
Repair or replace in Coton?
When the bathroom is fine apart from the bath’s finish, re-enamelling is the least disruptive fix. Tiles, panels and taps stay put. Prices start from £350. What it costs depends on the type and amount of damage, the material and how many jobs we combine into one visit. You get a fixed price from your photos, so there are no surprises on the day.
Why book with us
- Accredited with CHAS, Constructionline and SafeContractor
- Same prices wherever you are
- Typically one visit, start to finish
- A fixed quote before booking
Take a look at our prices page and guide to resurfacing and replacement costs.
What else we do in Coton
Covering Coton
Coton is about 5 miles east of Stone, in Staffordshire. We visit customers in Coton and nearby villages, so you do not need to take anything anywhere. Coton is one of 512 towns and villages in Staffordshire where we work. We work right across the region, from Coton to Birmingham (about 29 miles away).
Jobs in ST18 are booked in the same way as anywhere else. You’ll find streets such as Uttoxeter Road and Wallbrook Road, all of which we cover. We also travel to Coton Hayes (1 mile north-east), Milwich (1 mile west), Fradswell (1 mile south-east), Dayhills (2 miles west) and Smallrice (2 miles west). Within a short drive, we also cover Stafford (7 miles south-west), Newcastle-under-Lyme (13 miles north-west), Cannock (13 miles south), Longton (8 miles north-west), Rugeley (10 miles south) and Burntwood (15 miles south).
Around Coton
In Coton, that means homes near Green Lea First School, The Green Man pub and Church of All Saints and the streets around them. Further afield, we also cover the area around Chartley Castle (2.9 miles south-east).
Landlords, agents and businesses in Coton
We regularly work with letting and managing agents. Send the address, photos and access details and we will arrange it.
For anyone letting property in or around Coton, we can repair and quote for several addresses together. Send photos for each one and we will price them together.
About our accreditations · Every repair comes with a one-year guarantee.
