Perth and Kinross · Scotland
Bath Re-enamelling for Logierait homes
Full bath re-enamelling and resurfacing for homes and businesses in Logierait and across Perth and Kinross. Free, fixed quotes from your photos.
- Resurfacing from £350
- Staining under the taps and around the waste
- A coating lifting around the plughole
Bath re-enamelling at your home in Logierait
Re-enamelling gives a worn bath a new glossy surface without a refit. It’s the answer when the whole bath is tired rather than one spot. Whether it’s a roll-top that’s seen better days and several chips and rust patches, we can generally put it right, on Victorian roll-tops, pressed steel baths and acrylic baths alike.
Your repair is guaranteed for a year, as with every job we do.
- Area
- Logierait (PH9)
- Region
- Perth and Kinross
- Cover
- One year on every repair
- Quotes
- From £350. Fixed and free, based on pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
Logierait and nearby
Logierait is about 14 miles west of Blairgowrie and Rattray, in Perth and Kinross. We travel to homes and businesses in Logierait, so there’s no workshop to go to. We work in 107 places across Perth and Kinross, from the larger towns to small villages. We work right across the region, from Logierait to Edinburgh (52 miles away).
We cover every part of the PH9 postcode area and the streets around it. From Clais-an-Deor and Murray Terrace or anywhere nearby, a technician can come to you. Neighbouring places we cover include Ballinluig (1 mile north-east), Dowally (3 miles south-east), Grandtully (4 miles west), Little Ballinluig (4 miles west) and Port na Craig (4 miles north-west). We also work in nearby towns such as Blairgowrie and Rattray (14 miles east), Rattray (14 miles east), Aberfeldy (7 miles west), Stanley (14 miles south-east) and Bankfoot (12 miles south-east).
Landmarks near Logierait
Our clients here include homes close to Logierait Parish Church and the streets around them. Logierait’s nearest station is Pitlochry station, roughly 4.3 miles north-west. Well-known places in the area include Tom na Croiche (under half a mile north-east) and Pitlochry Community Hospital (4.3 miles north-west). Green spaces nearby include Loch Skiach.
What happens on the day
Your technician turns up at the time we agreed with you, introduces themselves and checks the damage against your photos first. The floor and nearby surfaces are covered before any work starts. Most visits take most of the day, and we leave the room as we found it.
- The room is masked, protected and ventilated.
- The bath is cleaned, degreased and any chips or rust repaired.
- We key the surface and put on a bonding primer.
- Several coats of new finish are sprayed on.
- The bath is left to cure and can normally be used the next day.
Preparing for the visit
- Let us know if it has been repaired before
- Keep a parking space free if you can
- Have a window or extractor fan available
How to get a price
Ring 0345 017 0787, or send us pictures through the quote form. With a clear picture of the damage and one of the entire bath, we can price the job the same day in most cases.
Read more
DIY kit or professional repair?
You can buy a DIY kit for most repairs, and they can tidy up a tiny mark. The trouble is colour and preparation: they come in a handful of shades, and if the surface isn’t prepared the repair won’t last.
If you do try a kit, read the instructions carefully, ensure the area is clean and completely dry, and give it the full curing time. If it doesn’t work out, we can still repair it properly.
Repairs by material
Pressed steel
Under the enamel of a steel bath is thin metal. Once a chip exposes it, rust follows quickly, so we treat and seal the metal before filling.
Cast iron
Re-enamelling suits cast iron baths perfectly. They’re built to last, and only the surface wears, so resurfacing gives them a new life.
What we are called out for in Logierait
Many baths we resurface have simply been well used, and only the surface is worn. The body of the bath is normally perfectly sound.
The most common problems we are called about are:
- Brown or grey marks that don’t clean off
- Chips and rust in more than one place
- An old resurfacing that is failing
- Wear marks under the taps
What to look for in a quote
- How to look after the finish
- Whether a trained technician does the job
- Whether the colour is mixed to match
- How the room is protected while they work
Keeping it looking good
Most damage we see is avoidable. These habits help:
- A quick wipe after use keeps limescale away
- Get any chip repaired quickly
- Repair dripping taps early
- Clean with a soft cloth and mild detergent
A quick rinse and wipe after use helps, especially in hard water areas, to stop limescale building up.
Worn enamel only gets rougher with time, and rust spots spread under the surface. Acting earlier keeps the preparation simpler.
What we cannot put right
A repair isn’t right for every job, including:
- A cast iron or steel bath that is cracked right through
- Leaks from fittings rather than the bath
- Problems we cannot see until an old finish comes off
Send us photos and we will tell you honestly before booking.
Surfaces we repair
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
- Cast iron baths
- Acrylic baths
Your questions about bath re-enamelling in Logierait
Can you do the outside of a roll-top?
Yes, roll-tops are a big part of our work. The inside is resurfaced, and we can refinish the outside as well.
I’m a tenant. Can you help?
Yes, but check with your landlord or agent first. Landlords are frequently glad to have it sorted before the end of a tenancy.
Can you make a coloured bath white?
Yes. We can resurface a coloured bath in white, and we can do the rest of the suite as well.
Will the new finish last?
That depends on preparation and how the bath is treated. Properly prepared and looked after, it lasts well, and our work is guaranteed for a year.
How quickly can you book me in?
That depends on our diary for your area. We will offer you dates when we send your quote.
Can a failed resurfacing be redone?
Yes. Stripping the old coating adds time, so it’s reflected in the quote.
What happens if you find more damage?
We stop, show you and agree any change before carrying on. Nothing extra is done without your say-so.
Do you work for landlords and businesses?
Yes, often. We quote for multiple addresses and fit around tenancy changeovers.
Repair or replace in Logierait?
For a sound bath, resurfacing costs far less than replacement, when you count removal, plumbing, tiling and decorating. It’s also far quicker. Resurfacing from £350, with every job priced individually. A repair usually costs much less than people expect, especially compared with replacing and refitting. Photos let us give you the exact figure.
Why book with us
- Colour mixed on the day to match
- Accredited with CHAS, Constructionline and SafeContractor
- Nothing taken out or refitted
- Technicians who travel to you, UK-wide
Take a look at our full price list or resurfacing vs replacement cost guide.
Towns and villages near Logierait
Also in Logierait
Landlords, agents and businesses in Logierait
Builders, developers and site managers book us for snagging repairs, putting right damage done during fitting so nothing needs replacing. We hold CHAS, Constructionline and SafeContractor accreditations.
We regularly work with letting and managing agents. Send the address, pictures and access details and we will handle the rest.
About our accreditations · Every repair comes with a one-year guarantee.
