Swansea · Wales
Bath Re-enamelling for Lunnon homes
Bath re-enamelling for Lunnon, without a refit. Get a fixed price from your photos, then book a visit.
- Resurfacing from £350
- Wear marks under the taps
- A bath that stays dull however much you clean it
When we would advise against a repair
Not everything can be repaired, and we’d rather say so up front. We cannot fix:
- Steel that has corroded right through
- Anything hidden under an old coating, until we remove it
- Acrylic that moves when you stand in it
If in doubt, send photos and we’ll say what we think before you book.
Surfaces we repair
- Basins & shower trays
- Victorian roll-tops
- Acrylic baths
- Pressed steel baths
- Cast iron baths
How we handle bath re-enamelling in Lunnon
We re-enamel plenty of period and roll-top baths, which are heavy, hard to move and costly to replace. Resurfacing them in place keeps the original bath. We work on acrylic baths, pressed steel baths and cast iron baths, and the jobs we see most are enamel that’s lost its shine and feels rough and stains that won’t shift.
Every repair is covered by our one-year guarantee.
- Location
- Lunnon (SA3)
- Area hub
- Swansea
- Warranty
- 12 months on all our work
- Price
- From £350. Free and fixed, from your photos
- Call
- 0345 017 0787
- Last updated
- 23 October 2026
Repairs by material
Pressed steel
Pressed steel baths take a new finish well, once any rust has been treated. Rust around the waste is common on steel, so we pay close attention there.
Roll-top and period baths
Freestanding roll-tops can be done inside and out, with the outside refinished as well.
Lunnon and nearby
Lunnon is about 6 miles south of Gorseinon, in Swansea. Customers in Lunnon get the same service as everywhere else we cover: a fixed quote from pictures, then a visit to do the work. Lunnon is one of 153 places in Swansea we cover.
We work across the SA3 postcode area and the streets around it. Nearby, we also work in Sandylane (1 mile south), Ilston (1 mile north-east), Southgate (1 mile south), Pennard (1 mile south-east) and Kittle (2 miles east). Larger places within reach include Swansea (7 miles north-east), Castle (7 miles east), Morriston (9 miles north-east), Mount Pleasant (7 miles east), Gorseinon (6 miles north) and Dyfaty (7 miles east).
Around Lunnon
Our customers here include homes close to Pennard Primary School, Church Of St Illtyd and The Gower Inn. The nearest railway station is Gowerton station, roughly 5 miles north-east of the centre. Well-known places in the area include Park Mill (less than half a mile south) and Fairwood Hospital (2.8 miles north-east). Open spaces near Lunnon include Cefn Bryn and Bishop's Wood.
What affects the price in Lunnon
Resurfacing from £350. Prices are worked out job by job. What matters most is:
- Access to the area
- The colour and finish to match
- The type of damage
- Any earlier repairs that need removing first
Rather than charging by the hour, we fix the price before we start. It depends on the damage, the material and access, and doing several items at once reduces it.
Quotes from your pictures
Almost every job we do is priced from pictures. This is what to send:
- Any earlier repairs or coatings
- One picture of the entire bath
- Good light, ideally daylight, without flash glare
- The postcode, so we can plan the visit
To get a price, send two or three pictures through our quote form or call us. We’ll tell you honestly whether it can be repaired.
How the visit works
Once we are through the door, the aim is to do the job without disturbing the rest of your home. We mask off everything nearby, the job takes a full day, and we finish by cleaning up and talking you through the result.
- The room is masked, protected and ventilated.
- The bath is cleaned, degreased and any chips or rust repaired.
- We prepare the surface and apply a bonding primer.
- We spray several coats of new enamel finish.
- The bath is left to cure and can generally be used the following day.
How to prepare
- Clear the area around the damage
- Point us to the nearest place to park
- Let us know about parking or access
How to get a price
Email us pictures of the damage and one of the whole item, and tell us you’re in Lunnon, and we’ll come back with a fixed quote.
Advice
Should I try a DIY kit first?
A DIY attempt is not a disaster. We remove the old filler and start again, so it does not stop a professional repair. Just mention it when you send photos, as it can add time.
DIY kits are sold for most surfaces, and they can tidy up a tiny mark. The trouble is colour and preparation: they come in a handful of shades, and if the surface is not prepared the repair will not last.
Looking after it afterwards
Most damage we see is avoidable. A few tips:
- Do not let dyes or oils sit on the finish
- Don’t leave bottles, razors or sponges standing on the surface
- Do not use the bath until it has fully cured
- Do not leave a chip unrepaired
Give the finish its full curing time before using the bath. After that, a soft cloth and washing-up liquid is all it needs.
If a previous coating is starting to peel, do not pick at it. Moisture gets underneath and makes it worse, so have it stripped and resurfaced.
FAQs for Lunnon
How do I get a price for bath re-enamelling in Lunnon?
Resurfacing from £350. The exact price depends on the damage, so we quote from photos. You’ll get a fixed figure before booking.
Is a repair better than a new one?
Generally, if the item is otherwise sound. A repair avoids removal and making good. We will tell you honestly if replacement makes more sense.
I’m a tenant. Can you help?
Yes, but check with your landlord or agent first. Landlords are often glad to have it sorted before the end of a tenancy.
How do I book?
Send photos through the quote form or call 0345 017 0787, and we’ll take it from there.
Which areas do you work in?
We work UK-wide, so Lunnon is covered. Prices do not change with location.
Do I have to be there?
Yes. We need access to the room while we work, at a time we agree with you.
Can you do the outside of a roll-top?
Yes, often. We resurface the inside, and the outside can be refinished too.
Is the work guaranteed?
Every repair comes with a one-year guarantee. Ask us what it covers when you get your quote.
Other services in Lunnon
Repair or replace: which is better?
Replacing a cast iron bath is a big job: it’s very heavy, may need breaking up, and the replacement can be costly. Resurfacing in place avoids that entirely. Prices start from £350. The price depends on how much damage there is and what kind, the material and how many items we do on one visit. We give a fixed quote from your photos, so there are no surprises on the day.
Why book with us
- CHAS, Constructionline and SafeContractor accredited
- Colour-matched on site
- Everything repaired in place
- Same prices wherever you are
See our prices page and bath cost comparison.
Work for landlords and builders
We carry out planned and one-off repairs for housing associations and facilities teams in Swansea and across the UK. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
For anyone letting property in or around Lunnon, we will quote for several properties at once. Just send photos for each address and we’ll come back with a combined price.
About our accreditations · Every repair comes with a one-year guarantee.
