Worcestershire · England

Bath re-enamelling & resurfacing in Napleton, Worcestershire

Problem with your bath in Napleton? We put it right where it is, mix the colour on the day and guarantee the work for a year.

  • Resurfacing from £350
  • A roll-top that is seen better days
  • Worn patches where water runs and sits
Surface Doctor technician refinishing the outside of a roll-top bath

Bath re-enamelling for Napleton homes

Bath re-enamelling in Napleton, done in place

Cast iron, steel, acrylic, roll-top and period baths can all be resurfaced. The finish is sprayed on in several coats over a bonding primer, after the bath has been cleaned, repaired and keyed. We work on pressed steel baths, acrylic baths and cast iron baths, and people most frequently call us about wear marks under the taps and a coating lifting around the plughole.

The work is covered for a year after we finish. If anything is not right, ring us and we will sort it.

Roll-top bath being refinished by a Surface Doctor technician
Where
Napleton (WR5)
Region
Worcestershire
Cover
12 months on all our work
Quotes
From £350. Fixed and free, based on pictures
Call
0345 017 0787
Last updated
23 October 2026

DIY kit or professional repair?

It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Getting it right first time is normally cheaper.

What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.

What happens on the day

There is not much you need to do on the day. Show us the job, point us to the room, and we’ll take it from there. Most visits take the best part of a day, including clearing up.

  1. We check the bath and agree the finish with you.
  2. Everything around the bath is masked and covered.
  3. The bath is degreased, repaired and keyed.
  4. We apply the primer and then the finish coats.
  5. The masking comes off, we tidy up and tell you when it can be used.

How to prepare

  • Tell us about any previous repairs or coatings
  • Open a window if you can
  • Let the surface dry out before the visit

Getting a price

Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, add your postcode and send them over. What comes back is a fixed quote, not a guess.

Send pictures for a quote

Advice

When a repair is not the answer

We would rather lose a job than do one that will not last, so here’s what a repair cannot put right:

  • Leaking taps or wastes (a plumber’s job)
  • Steel that has corroded right through
  • A bath split right through the body

If in doubt, send photos and we’ll say what we think.

Materials we repair

  • Victorian roll-tops
  • Basins & shower trays
  • Acrylic baths
  • Cast iron baths
  • Pressed steel baths

Common questions in Napleton

Is there a smell?

Some odour is normal while we spray, so we ventilate the room. It fades as the coating cures.

How soon can you come?

That depends on our diary for your area. We will offer you dates when we send your quote.

Do you cover Napleton?

Yes. We work across the UK and come to Napleton. Send us pictures for a fixed quote, or call 0345 017 0787.

Which areas do you work in?

Across the UK, so Napleton is covered. Prices do not change with location.

Can you fix a peeling bath coating?

Yes. Stripping the old coating adds time, so it’s reflected in the quote.

How do I book?

Send photos through the quote form or call 0345 017 0787.

Can you redo someone else’s repair?

In most cases. We remove the old repair before doing a new one, so mention it when you send pictures.

What happens once I’ve sent pictures?

We check the damage, the material and your postcode, then reply with a quote with dates.

Repairing versus replacing in Napleton

Replacing a bath can take several days across several trades. Re-enamelling is one technician, usually one day, with the bath back in use the day after. Our bath re-enamelling starts from £350. Rather than charging by the hour, we fix the price before we start. It depends on the damage, the material and access, and doing several items at once reduces it.

What you get with us

  • Every repair guaranteed for a year
  • Colour mixed on the day to match
  • Accredited with CHAS, Constructionline and SafeContractor
  • Dust sheets down, tidy finish

Take a look at our full price list or bath cost comparison.

Aftercare tips

Most damage we see is avoidable. A few tips:

  • Store bottles off the bath
  • Do not let dyes or oils sit on the finish
  • Have chips seen to early
  • Repair dripping taps early

The first few days matter most: let it cure fully, then use mild cleaners only. After that, no abrasives and no suction mats.

Don’t try to scrub a worn bath back to shine. It removes more of the surface.

How we price bath re-enamelling

Resurfacing from £350. We do not charge extra for travel to Napleton. The price comes down to:

  • Doing more than one item at once
  • The material
  • The colour and finish to match
  • How much damage there is

The price depends on the type and amount of damage, the material and how many jobs we combine into one visit. You get a fixed price from your photos, so there are no surprises on the day.

Send photos for a quote

Phone photos are fine. Just ensure we can see:

  • Natural light rather than flash
  • The material, if you know it
  • Where you are, by postcode
  • A picture taken from further back

The quickest way to a price is to send two or three photos through our quote form or ring us. We will say straight away whether it can be repaired.

Do you need bath re-enamelling in Napleton?

The gloss on enamel is thin, and every scrub with an abrasive cleaner takes a little away. Eventually the surface turns porous and stains.

These are the problems we’re asked about most:

  • An old resurfacing that’s failing
  • Staining under the taps and around the waste
  • Several chips and rust patches
  • A roll-top that’s seen better days

Comparing quotes

  • How to look after the finish
  • Whether the price is fixed and includes VAT
  • When it can be used again
  • Who will actually do the work

How to compare quotes

Napleton and the surrounding area

Napleton is about 4 miles south of Worcester, in Worcestershire. We visit homes and businesses in Napleton and the surrounding area, so there’s no workshop to go to. We cover all 376 towns and villages across Worcestershire. Our jobs stretch from Napleton to Birmingham (about 27 miles away).

Postcode districts we cover here: WR5. Nearby, we also work in Draycott (1 mile west), Kempsey (1 mile north-west), Baynhall (1 mile south-west), Brook End (1 mile north) and Callow End (2 miles north-west). Larger places within reach include Worcester (4 miles north), Bromsgrove (15 miles north-east), Great Malvern (5 miles west), Droitwich Spa (9 miles north), Evesham (12 miles east) and Stourport-on-Severn (15 miles north).

Landmarks near Napleton

Locally, our jobs take us to homes close to Kempsey Primary School, The Gurkha Knight pub and Kerswell Green Church. For rail, the closest station is Worcestershire Parkway station, about 2.5 miles north-east of the centre. A little further out are Museum of Royal Worcester (3.9 miles north) and Worcester Castle (3.8 miles north). Open spaces near Napleton include Tiddesley Wood.

Map of Napleton © OpenStreetMap contributors

Work for landlords and builders

We carry out planned and one-off repairs for housing associations and facilities teams. Repairing in place avoids the disruption of a replacement, which is easier on the people living there.

For anyone letting property in or around Napleton, we can repair and quote for several addresses together. Send pictures for each one and we will price them together.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.