Nottinghamshire · England

Bath chip & crack repair in Holbeck, Nottinghamshire

Chip and crack repairs to enamel, acrylic and cast iron baths for homes and businesses in Holbeck and across Nottinghamshire. Free, fixed quotes from your photos.

  • Repairs from £95
  • Hairline or through cracks in acrylic
  • Damage done while the bathroom was being fitted
Surface Doctor technician refinishing the outside of a roll-top bath

Bath repair for Holbeck homes

Repairs by material

Cast iron

A cast iron bath is heavy enough that most people never want to move it. Only the enamel surface wears or chips, and that’s what we repair.

Pressed steel

Under the enamel of a steel bath is thin metal. Once a chip exposes it, rust follows quickly, so we treat and seal the metal before filling.

Bath repair in Holbeck, done in place

Whether your bath is steel, cast iron or acrylic, we can repair it. Each material is repaired a little differently: rust is treated on metal baths, while cracks in acrylic are reinforced from underneath. We’re often asked to fix rust by the waste and overflow and damage beneath the taps, across pressed steel enamel, roll-top & freestanding and cast iron enamel.

All of our repairs are guaranteed for twelve months in Holbeck and everywhere else. We return to put right any problem with the work.

Where
Holbeck (S80, NG20)
County
Nottinghamshire
Guarantee
One year on every repair
Quote
From £95. Free and fixed, from your photos
Call
0345 017 0787
Updated
23 October 2026
Rusty chip next to a bath plughole, before and after repair

Repair or replace: which is better?

A repair makes sense whenever the damage is localised. It’s a fraction of the cost of a new bath and fitting, it takes one visit, and nothing else in the room changes. Our bath repair starts from £95. Set against the cost of replacement, a repair is generally a fraction of the price, because there’s no removal, plumbing or making good. The quote lists exactly what you’re paying for.

Why book with us

  • Free fixed quotes from pictures
  • Nothing taken out or refitted
  • CHAS and Constructionline accredited
  • One visit for most repairs

Read our full price list or resurfacing vs replacement cost guide.

Where we work around Holbeck

Holbeck is about 4 miles north of Shirebrook, in Nottinghamshire. Wherever you are in the S80 postcode area, a technician comes to you. Our repair technicians cover 329 places across Nottinghamshire, from the larger towns to small villages. You can also see our page for Leeds, about 41 miles away.

Every address in S80 and NG20 is within our area, from the main roads to the quietest streets. Other places close to Holbeck include Holbeck Woodhouse (1 mile east), Cuckney (2 miles south-east), Norton (2 miles east), Hodthorpe (2 miles north) and Church Warsop (3 miles south-east). Within a short drive, we also cover Mansfield (8 miles south), Worksop (5 miles north-east), Sutton in Ashfield (9 miles south), Hucknall (15 miles south), Retford (11 miles north-east) and Mansfield Woodhouse (6 miles south).

Near you in Holbeck

We visit homes around St Winifred's Church. The nearest railway station is Creswell station, roughly 1.4 miles north-west of the centre. Other landmarks nearby include Creswell Crags Museum and Heritage Centre (1.8 miles north) and Norton and Cuckney (1.9 miles south-east). The countryside around Holbeck includes Sandhill Lake.

Map of Holbeck © OpenStreetMap contributors

How the visit works

Nothing needs to be moved out of the room beforehand. We bring everything we need with us, lay protective sheets and start once you’re happy with the plan. Most jobs take a few hours, depending on the damage, and you can get on with other things while we’re there.

  1. We start by cleaning the damage and taking out loose enamel and rust.
  2. The chip or crack is filled, then sanded level with the bath.
  3. The colour is mixed on the spot to match your bath.
  4. We apply the finish coats and polish the repair so it blends in.
  5. The repair is left to cure, and most baths can be used the next day.

Getting ready for the visit

  • Mention if the room is upstairs or in a flat
  • Tell us about any previous repairs or coatings
  • Make sure the room can be ventilated

Getting a price

Getting a price is easy: take a close-up of the damage and a photo from further back, send them over with your postcode, and you will get a fixed price back. Quotes are free and you are under no obligation.

Get a free quote

Related advice

Common problems we fix in Holbeck

Heavy toiletries are the biggest single cause of chips, with dropped shower heads close behind. Fittings cause damage too: water sits around them, and any chip there soon rusts.

You may need us if you’ve spotted any of these:

  • Damage done while the bathroom was being fitted
  • A failed DIY repair that is discoloured or lifting
  • Impact holes in acrylic
  • Hairline or through cracks in acrylic

Comparing quotes

  • A fixed quote, and whether VAT is included
  • How to care for the finish
  • How long the guarantee is and what it covers
  • How changes to the job are handled

How to compare quotes

Your questions about bath repair in Holbeck

Is repairing better than replacing?

Usually, if the item is otherwise sound. A repair avoids removal and making good. If replacing would be better, we’ll say so.

How much does bath repair cost in Holbeck?

Repairs from £95. Because every job differs, we price from photos. You will get a fixed figure before booking.

Can you fix rust around the plughole?

Yes. We remove the rust and loose enamel, seal and fill the area, then colour-match the finish.

Can you redo an old repair?

Yes. We remove the old filler and start again. Mention it when you send photos.

Do you cover the whole of Nottinghamshire?

Across the UK. Prices don’t change with location.

Are there extra charges for Holbeck?

We don’t add a call-out fee. The fixed quote covers the visit and the work.

Can you price it without visiting?

Yes, almost always. Clear photos let us give you a fixed price without visiting.

What happens once I’ve sent photos?

You get a fixed price and available dates. If anything’s unclear, we’ll ask for another photo.

Landlords, agents and businesses in Holbeck

Rental properties take more wear, and replacing items every time a tenant leaves is expensive. A repair between tenancies is a cheaper way to keep the property in good order.

We also carry out snagging repairs for builders and developers, putting right damage done during fitting. We are CHAS, Constructionline and SafeContractor accredited.

How we price bath repair

Prices start from £95. There’s no charge for travel to Holbeck. The price depends on:

  • Whether we combine several jobs
  • The material and finish
  • The size and number of damaged areas
  • The type of damage

Our prices are the same across the UK, with no extra for Holbeck. The job itself decides the price: the material, the amount of damage and how many items.

Quotes from your pictures

You can typically get a fixed price without us visiting. To help us price it:

  • Any details about the material
  • Details of any past repairs
  • A coin or ruler next to the damage for scale
  • The postcode, so we can plan the visit

Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, add your postcode and send them to us. What comes back is a fixed quote, not a guess.

Keeping it looking good

After the repair has cured, a few habits help it last:

  • Don’t leave a fresh chip for long
  • Give the bath a quick rinse after use
  • Fix dripping taps early to stop staining and limescale
  • Put a towel in the bath if you are working above it

Leave the repair to cure for as long as we say before running a bath. After that, gentle cleaning keeps it looking good.

Until we visit, a strip of waterproof tape over the damage helps, so water cannot get in. Take it off before we arrive.

Should I try a DIY kit first?

It’s tempting to reach for a kit, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Getting it right first time is generally cheaper.

A DIY attempt isn’t a disaster. We take the old repair out and do it properly, so it won’t stop us repairing it. Just mention it when you send pictures, as it can add time.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.