Pembrokeshire · Wales

Bath Repair for Pembroke Ferry homes

Chip and crack repairs to enamel, acrylic and cast iron baths for homeowners, landlords and businesses in Pembroke Ferry. Free, fixed quotes from your pictures.

Repairs from £95
Scratches you can feel with a fingernail
Impact holes in acrylic

Surface Doctor technician refinishing the outside of a roll-top bath

Need bath repair in Pembroke Ferry?

Call 0345 017 0787

Get a free quote

Bath repair in Pembroke Ferry, done in place

Most of our bath repairs take a few hours, and you can usually bathe again the day after. You will not need a plumber or tiler, because nothing is disconnected. Typical jobs include rust spots around the plughole and impact holes in acrylic, in cast iron enamel, pressed steel enamel and whirlpool & spa baths.

The work is guaranteed for twelve months. If something is not right in that time, we come back and put it right.

Before and after: a damaged acrylic bath corner repaired in place

Location: Pembroke Ferry (SA72, SA73, SA71)
Area hub: Pembrokeshire
Warranty: 12 months on all our work
Quotes: From £95. Free and fixed, from your photos
Call: 0345 017 0787
Last updated: 23 October 2026

Materials and what they mean for the repair

Pressed steel

Under the enamel of a steel bath is thin metal. Exposed steel rusts quickly, so we treat and seal the metal before filling.

Acrylic

Acrylic baths are moulded sheet reinforced underneath. They do not rust, but they can crack, scratch or be holed, and cracks need support from behind to stay fixed.

Work for landlords and builders

Housing associations and facilities teams use us for planned and reactive repairs. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.

Landlords, letting agents and housing providers in Pembroke Ferry use us as well as homeowners. Repairing between tenancies keeps void periods short, and it costs much less than replacing.

How it works

Once we are through the door, we keep the work contained to the one room. Surfaces nearby are masked off, the job takes two to three hours for most chips, and we finish by cleaning up and talking you through the result.

Dust sheets and masking go down around the bath.
The damaged area is cleaned, keyed and degreased, and any rust is treated.
We fill it, let it set, then sand it flush.
Colour and gloss are matched to the surrounding surface.
We tidy up and tell you when the bath can be used, normally the following day.

Preparing for the visit

Keep a parking space free if you can
Let us know about parking or access
Let the surface dry out before the visit

How to get a price

For most jobs, photos are all we need to give you a price. Add a line about what happened and your postcode, and we will reply with a fixed quote and the earliest dates we have.

Get a fixed quote

Related advice

Do DIY bath repair kits work?

Covering Pembroke Ferry

Pembroke Ferry is about 1 mile north-east of Pembroke Dock, in Pembrokeshire. We work in every kind of home, old or new, large or small, as well as offices, shops and holiday lets. We work in all 223 towns and villages across Pembrokeshire.

Our visits in SA72, SA73 and SA71 work the same way as everywhere else we cover. Whether you live on Pier Road, Essex Road and London Road or anywhere nearby, a technician can come to you. Pembroke Ferry is on the A477 and A4139, which makes it straightforward to reach. We also travel to Burton Ferry (1 mile north), Burton (1 mile north-east), Neyland (1 mile north-west), Great Honeyborough (1 mile north-west) and Llanstadwell (2 miles west). Within a short drive, we also cover Haverfordwest (7 miles north), Milford Haven (5 miles west), The Marsh (7 miles north), Dinbych-y-Pysgod (10 miles east), The Green (10 miles east) and Pill (4 miles west).

What’s near Pembroke Ferry

In Pembroke Ferry, that means homes near Ysgol Harri Tudur/Henry Tudor School, St Andrew's Church and Pembroke Dock CP School. For rail, the closest station is Pembroke Dock station, about 0.5 miles south-west. Other landmarks nearby include Pembroke Dock: Llanion (less than half a mile south) and South Pembrokeshire Hospital (1.2 miles south-west). Not far away are Pembroke River lower and Ferry Wood.

Map of Pembroke Ferry © OpenStreetMap contributors

Should I try a DIY kit first?

The difference between a kit and a professional repair is mostly in the preparation and colour. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, then guarantee it for a year.

It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is typically the cheaper route.

Aftercare tips

Much of the damage we repair could have been avoided. A few tips:

Put a towel in the bath if you are working above it
A dripping tap stains enamel, so fix it early
Store metal items away from the bath
If an acrylic bath flexes, have its feet adjusted

There’s nothing special to do after a repair, beyond gentle cleaning. Skip bleach and gritty creams.

Do not leave a chip on a steel or cast iron bath. Once water reaches the metal, rust begins, and a rust spot is a bigger repair than a clean chip.

What affects the price in Pembroke Ferry

Prices start from £95. There are no hourly rates or hidden extras. The price is based on:

Access to the area
Any earlier repairs that need removing first
The size and number of damaged areas
The material

What it costs depends on the type and amount of damage, the material and how many items we do on one visit. You get a fixed price from your photos, so there are no surprises on the day.

Quotes from your pictures

You can take the pictures on your phone, there is no need for anything special. Just make sure we can see:

The postcode, so we can plan the visit
A picture taken from further back
Details of any past repairs
Natural light rather than flash

To get a price, send two or three pictures through our quote form or ring us. We’ll say right away if a repair is the right fix.

Pembroke Ferry: your questions answered

Can you do more than one item on the same visit?

Of course, and it typically saves money. Just add the extra items to your pictures and we’ll quote them together.

Do you come to Pembroke Ferry?

Yes, we do. We send a technician to Pembroke Ferry for every job, and the price is the same as everywhere else.

Can you repair a chip on a coloured bath?

Yes, we match coloured baths too. We tint the finish to your bath on site.

Is there a guarantee?

All our work carries a one-year guarantee. We will explain what it covers when we quote.

What happens after I send pictures?

You’ll get a fixed quote back. You’re under no obligation.

Can rust on a bath be repaired?

Yes, very often. We take it back to sound metal, seal it, fill it and match the colour.

Do I need to be at home?

We need someone to let us in. You don’t need to watch us work.

Can you repair a hole in a bath?

In most cases. Send us a photo of the hole and one from under the bath if you can.

Should you replace it?

A new bath costs more than the bath itself: taking out the old one, plumbing, tiling, a panel and redecorating. A repair is one job, done in one visit. Our bath repair starts from £95. Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Send pictures and we will give you the exact figure.