Edinburgh · Scotland

Bath Repair for Polwarth homes

Chip and crack repairs to enamel, acrylic and cast iron baths for homes and businesses in Polwarth and across Edinburgh. Send photos for a free, fixed quote.

  • Repairs from £95
  • Deep scratches in acrylic
  • Rust by the waste and overflow
Surface Doctor technician refinishing the outside of a roll-top bath

Bath repair near Polwarth

How we handle bath repair in Polwarth

A typical bath repair is a few hours’ work, and you can typically bathe again the following day. You will not need a plumber or tiler, because the bath doesn’t move. Our technicians work on whirlpool & spa baths, acrylic and roll-top & freestanding, and people most often call us about impact holes in acrylic and chips caused by builders.

All of our repairs are guaranteed for twelve months. We return to put right any problem with the work.

Location
Polwarth (EH11, EH14, EH10)
Region
Edinburgh
Warranty
12 months on all our work
Quotes
From £95. Fixed and free, based on pictures
Call
0345 017 0787
Updated
23 October 2026
Before and after: a chipped, rust-stained bath around the plughole

Why repair rather than replace?

A repair makes sense whenever the damage is localised. It’s a fraction of the cost of a new bath and fitting, it takes one visit, and the bathroom stays exactly as it is. Repairs from £95, with every job priced individually. The price reflects the work involved, not your postcode. The full price is agreed before you book.

Why us?

  • Normally one visit, start to finish
  • Every repair guaranteed for a year
  • Dust sheets down, tidy finish
  • CHAS, Constructionline and SafeContractor accredited

Take a look at our full price list and resurfacing vs replacement cost guide.

Should I try a DIY kit first?

You can buy a DIY kit for most repairs, and they can make a small mark look better. The trouble is colour and preparation: they come in a handful of shades, and if the surface isn’t prepared the repair won’t last.

What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, then guarantee it for a year.

What we’re called out for in Polwarth

Heavy toiletries are the biggest single cause of chips, with dropped shower heads close behind. Taps and wastes cause problems too: water collects there, so chips nearby rust quickly.

People typically call us after spotting something like this:

  • Rust by the waste and overflow
  • A hole punched through by something heavy
  • Chips under the taps
  • Chips along the edge of the bath

What your quote should include

  • What happens if they find more damage
  • How to care for the finish
  • Whether the price is fixed and includes VAT
  • Whether the colour is mixed to match

Choosing a repair company

Polwarth questions

Is a bath repair permanent?

Done properly, a repair lasts for years, and ours come with a one-year guarantee. Gentle cleaning helps.

Can pets and children be at home?

Yes, as long as they stay out of the room we are working in. We’ll tell you when the room can be used again.

Are you a vetted contractor?

Yes, including CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.

Do I need to be at home?

Someone needs to let us in and show us the job. After that, you can carry on with your day.

How much does bath repair cost in Polwarth?

Repairs from £95. The exact price depends on the damage, so we quote from photos. You know the full cost before anything is booked.

What information do you need?

Send photos through the quote form or call 0345 017 0787, and we will take it from there.

What about rust by the waste?

Yes. We remove the rust and loose enamel, fill the area, then colour-match the finish.

Can you quote from pictures?

Generally, yes. A close-up and a wider photo are enough to give a fixed quote.

How the visit works

Expect a friendly, tidy visit. We agree the arrival time in advance, protect the area, then carry out the work, which normally takes a few hours, depending on the damage. If we find something your photos didn’t show, we’ll explain it before carrying on.

  1. We clean the area and remove any loose enamel or rust.
  2. We fill the damage and sand it flush with the surrounding surface.
  3. The colour is mixed on the spot to match your bath.
  4. We apply the finish coats and polish the repair so it blends in.
  5. We leave it to cure; you can generally use the bath the next day.

Preparing for the visit

  • Clear toiletries, mats and anything else from around the area
  • Keep children and pets away from the room on the day
  • Keep a parking space free if you can

Getting a price

Pricing is simple: take a close-up of the damage and a photo from further back, send them to us with your postcode, and we’ll reply with a fixed price. Quotes are free and no obligation.

Get a fixed price

Advice

For landlords and businesses

Builders use us to fix snagging damage before handover, saving last-minute replacements. Several plots can be done in one visit to keep costs down.

Builders, developers and site managers book us for snagging repairs, fixing chips and scratches before handover so nothing needs replacing. We hold CHAS, Constructionline and SafeContractor accreditations.

Materials and what they mean for the repair

Cast iron

Cast iron baths are thick and very strong, with a fused enamel surface. A chip down to the iron can rust, but the body of the bath lasts a very long time, so it’s always worth repairing.

Composite and resin

Composite baths are dense and solid. Chips and scratches can be filled and colour matched, just like other baths.

What affects the price in Polwarth

Repairs from £95. There’s no area surcharge for Polwarth. The price reflects:

  • Any earlier repairs that need removing first
  • The type of damage
  • Unusual colours or finishes
  • How much damage there is

Every job is a little different, so we price each one individually. What’s damaged, how badly and how easy it is to reach all play a part, and combining jobs on one visit brings the cost down.

How to get a fixed quote

Phone photos are fine. Make sure they show:

  • Details of any past repairs
  • What it’s made of, if you know
  • One picture of the whole bath
  • Natural light rather than flash

Call 0345 017 0787 or use the quote form. With a clear picture of the damage and one of the whole bath, we can give you a fixed quote.

Where we work around Polwarth

Polwarth is about 1 mile south-west of Edinburgh, in Edinburgh. Clients in Polwarth get the same service as everywhere else we cover: a fixed quote from pictures, and a technician at your door on the day. Polwarth is one of 175 towns and villages in Edinburgh where we work.

All of EH11, EH14 and EH10 is within our area. From Cowan Road, Spylaw Road and Ettrick Road or anywhere nearby, we can come to you. Other places close to Polwarth include Shandon (1 mile north), Gorgie (1 mile north-west), Slateford (1 mile west), Westfield (1 mile north-west) and Burghmuirhead (1 mile east). Larger places within reach include Leith (4 miles north-east), Bonnington (3 miles north-east), Gayfield (3 miles north-east), Pilrig (3 miles north-east), North Leith (4 miles north-east) and Queensferry (8 miles north-west).

Near you in Polwarth

Locally, our jobs take us to homes close to Harrison Park, Polwarth Parish Church and Hall and Gabrielle Keiller Library. Other local landmarks include Iain Tomlin School of Music (0.6 miles east), The Athletic Arms (0.6 miles north), Boroughmuir High School (0.9 miles north-east) and Craiglockhart Primary School (under half a mile north). For rail, the closest station is Slateford station, about 0.7 miles south-west of the centre. Further afield, we also cover the area around Murrayfield Experience (0.9 miles north-west) and Waverley Mall (2.1 miles north-east). Not far away are Dunsapie Loch and Craiglockhart Hill.

Map of Polwarth © OpenStreetMap contributors

When we’d advise against a repair

Honesty matters more than a booking, so here’s what a repair won’t do:

  • Leaking fittings, which need a plumber
  • A bath that flexes because its feet or cradle have failed (that needs fixing first)
  • A bath worn all over, where resurfacing makes more sense

Not sure? Send photos and we will give you a straight answer before booking.

Materials we repair

  • Acrylic
  • Whirlpool & spa baths
  • Cast iron enamel
  • Pressed steel enamel
  • Roll-top & freestanding
CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.