Bath Re-enamelling in Blackburn with Darwen

About bath re-enamelling in Blackburn with Darwen

Cast iron and steel baths are ideal for re-enamelling, and acrylic baths can be resurfaced too. The result is a smooth, even, glossy finish. Typical jobs include a period or roll-top bath worth keeping and a bath that stays dull however much you clean it, in cast iron baths, basins & shower trays and acrylic baths.

A typical visit goes like this: we arrive at the agreed slot, protect everything around the work area, carry out the work and clear up. Plan for a full day from start to finish. Before leaving, we tell you when it can be used and how to care for it.

1. We sheet, mask and ventilate the room.
2. Old sealant is cut out and the bath is deep cleaned.
3. We repair chips, rust spots and pitting.
4. The surface is keyed and primed for the new finish.
5. The new finish is sprayed on in several coats and left to cure until the next day.

Cost

Resurfacing from £350, with every job priced individually. It helps to know what pushes a price up or down: access, material, the extent of the damage and whether we can do several items together. Photos let us give you a fixed figure.

What you get with us

• Dust sheets down, tidy finish
• Typically one visit, start to finish
• Straight answers about what a repair can do
• Colour-matched on site

Get a quote

No survey visit is needed: we price from pictures. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and you will get a fixed figure back.

Local landmarks in Blackburn

We visit homes around The Postal Order pub, Chapel Street Congregational Church and Corporation Park and the streets around them. Other local landmarks include St Wilfrid's Church of England Academy (0.5 miles west), St Wilfrid's Church of England Academy (0.5 miles west) and St Anne's Roman Catholic Primary School Blackburn (less than half a mile north-west). There’s a railway station in Blackburn itself: Blackburn station. Other landmarks nearby include Blackburn Royal Infirmary (0.6 miles south) and Ainsworth And Sons Ltd Museum (within half a mile north-east).

What affects the price in Blackburn with Darwen

Resurfacing from £350. Every quote is fixed and free. What we look at:

• Unusual colours or finishes
• What the surface is made of
• Whether old repairs or coatings need taking off
• Where the damage is and how we get to it

We charge the same wherever you are, so there’s no premium for Blackburn with Darwen. The job itself decides the price: the material, the amount of damage and how many items.

How to get a fixed price

You can take the pictures on your phone. Make sure they show:

• The postcode, so we can plan the visit
• A close-up of the damage, in focus
• Good light, ideally daylight, without flash glare
• What it’s made of, if you know

Call 0345 017 0787 or use the quote form. With a clear picture of the damage and one of the entire bath, we can give you a fixed price.

Keeping it looking good

A little care keeps the finish looking good. Our advice:

• Respect the curing time we give you
• Don’t let dyes or oils sit on the finish
• Stick to gentle, non-abrasive cleaners
• Do not leave a chip unrepaired

Dry the bath after use if possible, especially in hard water areas, and rinse off any bath products.

The longer worn enamel is left, the rougher it gets, and rust spots spread under the surface. Acting earlier keeps the preparation simpler.