Cornwall · England
Bath Re-enamelling in Burgois
Full bath re-enamelling and resurfacing for homes and businesses in Burgois and across Cornwall. Send photos for a free, fixed quote.
- Resurfacing from £350
- A dull, rough surface that won’t come clean
- Lots of chips and rust spots
Bath re-enamelling in Burgois, done in place
We resurface cast iron, steel and acrylic baths, including roll-tops and period baths. The finish is sprayed on in several coats over a bonding primer, once the bath has been cleaned, repaired and prepared. If you’re dealing with an original cast iron bath that needs restoring and staining under the taps and around the waste, we can generally put it right.
Every repair is covered by a one-year guarantee, wherever you are in Cornwall.
- Location
- Burgois (PL27)
- County
- Cornwall
- Warranty
- One year on every repair
- Quotes
- From £350. Free and fixed, from your pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Landlords, agents and businesses in Burgois
Landlords, letting agents and housing providers in Burgois use us as well as householders. Repairing between tenancies keeps void periods short, and it usually costs far less than a refit.
We are used to working with agents and managing companies. Send the address, pictures and access details.
How it works
On the day, we arrive at the time we have agreed, cover the area with dust sheets and masking, and set to work. The job usually takes most of the day. We clean up when we’re done and tell you when it’s ready to use.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- The surface is keyed and primed for the new finish.
- The new finish is sprayed on in several coats and left to cure until the following day.
Before we arrive
- Tell us if there are stairs or a lift
- Mention any parking restrictions or tricky access
- Make sure the area is dry
Getting a price
A quote takes minutes to ask for: photograph the damage, then the entire bath, include your postcode and send them to us. You will get a fixed price, not an estimate.
Related advice
Burgois and the surrounding area
Burgois is about 9 miles north-east of Newquay, in Cornwall. Clients in Burgois get the same service as everywhere else we cover: a fixed quote from pictures, and a technician at your door on the day. Burgois is one of 644 towns and villages in Cornwall where we work.
Our visits in PL27 are booked in the same way as anywhere else. We also travel to St Issey (1 mile south-east), Padstow (2 miles north-west), Porthilly (2 miles north), Rock (2 miles north-east) and Splatt (3 miles north-east). Further out, we also cover Newquay (9 miles south-west), St Austell (14 miles south-east), Bodmin (10 miles east), Sandy Bottom (14 miles south-east), Bethel (14 miles south-east) and Wadebridge (4 miles east).
Landmarks near Burgois
In Burgois, that means homes near The Pickwick Inn, Church of St Ida and St Issey Church of England Primary School, among other places. Further afield, we also cover the area around Shipwreck Museum (1.7 miles north). The countryside around Burgois includes Brea Hill.
What bath re-enamelling costs
Resurfacing from £350. We give every job a fixed quote from photos. This is what makes a difference:
- Where the damage is and how we get to it
- Previous DIY repairs that have to come out
- What the surface is made of
- How many items we do on one visit
A repair is priced on what needs doing, not your postcode. You will see the full price before you book, with nothing added on the day.
How to get a fixed quote
Two or three clear photos are generally enough. It helps if you send:
- Any earlier repairs or coatings
- One picture of the whole bath
- Any details about the material
- Daylight if possible, and no flash reflection
For most jobs, pictures are all we need to give you a price. Tell us what happened and where you are, and we will reply with a fixed quote and the earliest dates we have.
Looking after it afterwards
How the surface is treated afterwards matters. Here’s what we suggest:
- Wash away dyes and oils after use
- Avoid suction-cup mats
- Do not leave a chip unrepaired
- Store bottles off the bath
Dry the bath after use if possible, especially in hard water areas, and rinse off any bath products.
The longer worn enamel is left, the rougher it gets, and any rust spreads underneath. Acting earlier keeps the preparation simpler.
Your questions about bath re-enamelling in Burgois
What happens next?
You get a fixed quote and available dates. If we need another angle, we’ll ask.
Are you a vetted contractor?
Yes, including CHAS, Constructionline and SafeContractor. The full list is on our accreditations page.
What happens if you find more damage?
The price is fixed for what the pictures show. Anything extra is discussed before we begin.
Are there extra charges for Burgois?
We do not add a call-out fee. The fixed price covers the visit and the work.
I’m a tenant. Can you help?
Of course. Check with your landlord; we can send the quote to them too.
Will it make a mess?
No. The work area is masked and covered, and we take our waste away with us.
What do you need from me?
Just pictures, your postcode and a contact number. On the day, access to the room.
Can pets and children be at home?
Keep pets and children away from the work area on the day, mainly so nothing gets touched before it has cured.
When to call us in Burgois
In hard water areas, limescale and the cleaning it needs wear enamel faster, and abrasive cleaners do the most damage.
Look out for these signs:
- Several chips and rust patches
- A dull, rough surface that won’t come clean
- Thin, worn enamel in places
- A coloured bath you want in white
Questions to ask before booking
- How to look after the finish
- Who will actually do the work
- The length of the guarantee and what it covers
- What protection goes down before work starts
When a repair is not the answer
We will not take on work that will not last, so these are the limits:
- Problems we can’t see until an old finish comes off
- Leaks from fittings rather than the bath
- An acrylic bath that flexes badly underfoot
Not sure? Send pictures and we’ll give you a straight answer.
Materials we repair
- Pressed steel baths
- Basins & shower trays
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
Can I fix it myself?
It’s tempting to reach for a kit, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is generally the cheaper route.
You can buy a DIY kit for most repairs, and they can tidy up a tiny mark. The trouble is colour and preparation: they come in a handful of shades, and if the surface is not prepared the repair won’t last.
Also in Burgois
Repair or replace in Burgois?
A replacement often means several trades over several days. Re-enamelling is one technician, typically one day, and the bath is usable the day after. Our bath re-enamelling starts from £350. Every job is a little different, so each one is priced on its own. The size and type of damage, the material and access all make a difference, and combining jobs on one visit brings the cost down.
What you get with us
- Dust sheets down, tidy finish
- Repair technicians who travel to you, UK-wide
- No need to remove anything
- A year’s guarantee on all work
See our full price list or resurfacing vs replacement cost guide.
About our accreditations · Every repair comes with a one-year guarantee.
