Lancashire · England
Bath re-enamelling & resurfacing in Forton, Lancashire
Bath re-enamelling in Forton without the cost of replacing. Send us pictures for a fixed quote, then we come to you.
- Resurfacing from £350
- A peeling or bubbling previous coating
- A bath that stays dull however much you clean it
Your questions about bath re-enamelling in Forton
Will you leave a mess?
No. The work area is masked and covered, and we leave the room clean.
How long does re-enamelling take?
Most baths are done in a day, ready the day after. We give you timings with the quote.
It’s been repaired before. Can you still fix it?
In most cases. We remove the old repair before doing a new one, so let us know about it.
I rent my home. Can I book you?
Yes. Check with your landlord; we can send the quote to them too.
What happens next?
You get a fixed quote and available dates. If anything’s unclear, we will ask for another photo.
Is repairing better than replacing?
Normally, when the rest is in good condition. A repair avoids removal and making good. We’ll tell you honestly if replacement makes more sense.
Are you a vetted contractor?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
Can pets and children be at home?
On the day, the room should be kept clear of pets and children.
Bath re-enamelling in Forton without replacing anything
Re-enamelling is a one-day job for most baths, with the bath ready to use the following day. Taps, tiles, panels and plumbing all stay in place. Typical jobs include lots of chips and rust spots and brown or grey marks that don’t clean off, in cast iron baths, Victorian roll-tops and basins & shower trays.
You get a one-year guarantee, the same in Forton as everywhere else we work.
- Area
- Forton (PR3)
- County
- Lancashire
- Guarantee
- A year, on every repair
- Quote
- From £350. Fixed and free, based on pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
How it works
On the day itself, there’s little for you to do. Let us in and show us the room, and we will get on with it. The job generally runs to the best part of a day, including clearing up.
- The bathroom is protected and ventilation set up.
- Old sealant is cut out and the bath is deep cleaned.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- The new finish is sprayed on in several coats and left to cure.
Preparing for the visit
- Clear toiletries, mats and anything else from around the area
- Keep pets and children out of the room while we work
- Let us know about parking or access
Ask for a price
Upload pictures of the damage and a wider shot of the entire item, and tell us you are in Forton, and we’ll come back with a fixed quote.
Advice
Prices and what affects them
Resurfacing from £350. We do not charge extra for travel to Forton. The price depends on:
- Unusual colours or finishes
- Any earlier repairs that need removing first
- The type of damage
- How easy the damage is to reach
Rather than charging by the hour, we price the whole job up front. It depends on the damage, the material and access.
Quotes from your pictures
We price nearly every job from photos. This is what to send:
- A close-up of the damage, in focus
- A picture taken from further back
- The material, if you know it
- Your postcode, so we can check dates
Pricing is simple: snap the damage close up and then the entire item, send them to us with your postcode, and you will get a fixed quote back. There is no charge for the quote and you are under no obligation.
Forton and nearby
Forton is about 7 miles south of Lancaster, in Lancashire. Across the PR3 area, a technician comes to you. Forton is one of 482 places in Lancashire we cover. You can also see our page for Liverpool, about 38 miles away.
All of PR3 is within our area. Streets in the area include Preston Lancaster Road, Umpire Drive and Whinney Brow Lane. Close by, we cover Hollins Lane (1 mile east), Shireshead (1 mile east), Potters Brook (1 mile north), Bay Horse (1 mile north) and Scorton (2 miles south-east). Further out, we also cover Preston (13 miles south), Lancaster (7 miles north), Morecambe (8 miles north), Fulwood (12 miles south), Fleetwood (11 miles west) and Thornton (11 miles south-west).
Landmarks near Forton
In Forton, that means homes near Forton Primary School and St James' Church, among other places. A little further out are Greenhalgh Castle (3.8 miles south). Open spaces near Forton include Winmarleigh and Cockerham Moss and Nicky Nook.
Should I try a DIY kit first?
The difference between a kit and a professional repair is mostly in the preparation and colour. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
DIY kits are sold for most surfaces, and they can make a small mark look better. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
Work for landlords and builders
For developers and builders, we fix damage before handover. We can visit several plots in one trip to keep costs down.
We carry out planned and one-off repairs for housing associations and facilities teams. A repair avoids taking out and refitting, which matters when someone is living in the home.
What we are called out for in Forton
In hard water areas, limescale and the cleaning it needs wear enamel faster, and abrasive cleaners do the most damage.
It’s worth getting a quote if you see:
- A roll-top that is seen better days
- A peeling or bubbling previous coating
- Chips and rust in more than one place
- Enamel that is lost its shine and feels rough
What your quote should include
- What the guarantee covers, and for how long
- When it can be used again
- How to care for the finish
- Whether the colour is mixed to match
Towns and villages near Forton
Other services in Forton
When we’d advise against a repair
A repair isn’t right for every job, for example:
- An acrylic bath that flexes badly underfoot
- Anything hidden under an old coating, until we remove it
- Leaks from fittings rather than the bath
If in doubt, send pictures and we will say what we think before booking.
Materials we repair
- Pressed steel baths
- Basins & shower trays
- Acrylic baths
- Victorian roll-tops
- Cast iron baths
Repairing versus replacing in Forton
A refit takes several trades and several days. Re-enamelling takes one technician and typically one day, and the bath can be used the day after. Our bath re-enamelling starts from £350. A few things move the price: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Photos let us give you a fixed figure.
Why choose Surface Doctor in Forton
- Repair technicians who travel to you, UK-wide
- One price list for the entire UK
- Most jobs done in one visit
- A year’s guarantee on all work
Take a look at our prices page and resurfacing vs replacement cost guide.
Repairs by material
Cast iron
Re-enamelling suits cast iron baths perfectly. They’re built to last, and only the surface wears, so resurfacing gives them a new life.
Pressed steel
Under the enamel of a steel bath is thin metal. Exposed steel rusts quickly, so the metal is treated and sealed before the repair.
About our accreditations · Every repair comes with a one-year guarantee.
