Warwickshire · England
Bath re-enamelling & resurfacing in High Cross, Warwickshire
Full bath re-enamelling and resurfacing for homes and businesses in High Cross and across Warwickshire. Free, fixed quotes from your photos.
- Resurfacing from £350
- A roll-top that is seen better days
- An old resurfacing that is failing
What happens on the day
Arrival times are agreed in advance. On site, it takes the best part of a day in most cases. The room is left tidy.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- The new finish is sprayed on in several coats and left to cure.
Preparing for the visit
- Keep children and pets away from the room on the day
- Mention any earlier repairs or resurfacing
- Move bottles, mats and clutter away from the area
Get a quote
Getting a quote takes a couple of minutes: photograph the damage, then the entire bath, include your postcode and send them over. What comes back is a fixed quote, not a guess.
Read more
Bath re-enamelling in High Cross, done in place
Cast iron, steel, acrylic, roll-top and period baths can all be resurfaced. The finish is sprayed on in several coats over a bonding primer, once the bath has been cleaned, repaired and prepared. We work on pressed steel baths, acrylic baths and Victorian roll-tops, and people most frequently call us about a bath that stays dull however much you clean it and brown or grey marks that don’t clean off.
Every repair comes with our one-year guarantee, wherever you are in Warwickshire.
- Area
- High Cross (CV35)
- Region
- Warwickshire
- Guarantee
- One year on every repair
- Quote
- From £350. Free and fixed, from your pictures
- Telephone
- 0345 017 0787
- Updated
- 23 October 2026
When we’d advise against a repair
Before booking, it’s worth knowing the limits:
- A bath that is rusted through
- Problems we can’t see until an old finish comes off
- Plumbing leaks, which need a plumber
If in doubt, send photos and we’ll say what we think before you book.
Materials we repair
- Acrylic baths
- Basins & shower trays
- Pressed steel baths
- Cast iron baths
- Victorian roll-tops
DIY repairs versus a professional job
A kit can be fine for a tiny mark out of sight. For damage in plain view, cracks, holes or rust, or coloured finishes, a professional repair is worth it.
DIY kits are sold for most surfaces, and they can make a small mark look better. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
High Cross and the surrounding area
High Cross is about 6 miles west of Warwick, in Warwickshire. We agree a date that works for you, and we will give you an arrival time in advance, so there’s no waiting around. High Cross is one of 324 places in Warwickshire where we work. You can also see our page for Birmingham, about 14 miles away.
Our visits in CV35 work the same way as everywhere else we cover. Whether you live on Back Lane, High Cross Lane and Narrow Lane or anywhere nearby, a technician can come to you. Close by, we cover Finwood (1 mile north-west), Lowsonford (1 mile west), Rowington (1 mile north), Rookery (1 mile south-west) and Bushwood (1 mile north-west). We also work in nearby towns such as Warwick (6 miles east), Royal Leamington Spa (8 miles east), Stratford-upon-Avon (8 miles south), Bedworth (15 miles north-east), Leamington Spa (7 miles east) and Kenilworth (6 miles north-east).
Around High Cross
Our clients here include homes close to St Luke and Fleur De Lys Public House and the streets around them. The nearest railway station is Hatton station, about 1.8 miles south-east. A little further out are Baddesley Clinton (2.3 miles north) and St Michael's Hospital (5 miles east). Open spaces near High Cross include Henley Sidings.
Also near High Cross
Also in High Cross
How we price bath re-enamelling
Resurfacing from £350. You’ll know the full cost before booking. We take into account:
- How much damage there is
- Where the damage is and how we get to it
- The material
- The colour and finish to match
It helps to know what pushes a price up or down: access, material, the extent of the damage and whether we can do several items together. Photos let us give you a fixed figure.
How to get a fixed quote
Two or three clear photos are typically enough. Try to include:
- A picture taken from further back
- Any earlier repairs or coatings
- Good light, ideally daylight, without flash glare
- A close-up of the damage, in focus
Call 0345 017 0787 or use the quote form. With a clear picture of the damage and one of the entire bath, we can price the job without visiting.
Landlords, agents and businesses in High Cross
We carry out planned and one-off repairs for housing associations and facilities teams. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
Builders, developers and site managers book us for snagging repairs, putting right damage done during fitting so nothing needs replacing. We are CHAS, Constructionline and SafeContractor accredited.
Should you replace it?
Getting a cast iron bath out is hard work: it’s very heavy, may need breaking up, and the replacement can be costly. Re-enamelling avoids all of it. Resurfacing from £350, with every job priced individually. What it costs depends on the type and amount of damage, what it’s made of and how many jobs we combine into one visit. You get a fixed price from your photos, so there are no surprises on the day.
Why High Cross clients choose us
- Colour mixed on the day to match
- We’ll tell you if it’s not worth repairing
- Technicians who travel to you, UK-wide
- Everything repaired in place
Read our full price list or resurfacing vs replacement cost guide.
Common problems we fix in High Cross
Previous coatings can fail too, lifting by the plughole or blistering. Failing coatings are stripped back before we resurface.
Signs it’s time to call us include:
- A coloured bath you want in white
- A period or roll-top bath worth keeping
- Brown or grey marks that do not clean off
- An old resurfacing that’s failing
What your quote should include
- If travel is included in the price
- What happens if the damage is worse than the pictures show
- How the colour is matched
- A fixed quote, and whether VAT is included
High Cross: your questions answered
Can you redo someone else’s repair?
Yes, we often do. It can add a little time, which we include in the quote.
Do you resurface freestanding baths?
Yes. Inside and out if you’d like.
How soon can you come?
That depends on our diary for your area. We will offer you dates when we send your quote.
Is there a call-out fee?
We don’t add a call-out fee. The fixed price covers the visit and the work.
How do I book?
Just pictures, your postcode and a contact number. On the day, we only need access to the room.
Will there be fumes?
Yes, while we’re applying the finish. We set up ventilation and the smell fades as it cures.
I’m a tenant. Can you help?
We can work for tenants, landlords or agents. Get your landlord’s agreement first.
Do you work for landlords and businesses?
Yes. We work for landlords, agents, builders and businesses as well as householders across Warwickshire.
Different materials, different repairs
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we pay close attention there.
Acrylic
Acrylic feels warm and is light, but it relies on good support. Repairs to cracks are reinforced from the back.
About our accreditations · Every repair comes with a one-year guarantee.
