Worcestershire · England
Bath Re-enamelling in Kyre
Full bath re-enamelling and resurfacing for homes and businesses in Kyre and across Worcestershire. Send pictures for a free, fixed quote.
- Resurfacing from £350
- Staining under the taps and around the waste
- A bath in a colour that no longer suits
Aftercare tips
How the surface is treated afterwards matters:
- Have chips seen to early
- Wipe the bath dry after use in hard water areas
- Keep toiletries on a shelf rather than in the bath
- Keep suction mats out of the bath
Treat the new finish gently at first: let it cure fully, then use mild cleaners only. After that, no abrasives and no suction mats.
Avoid scrubbing a dull bath with abrasive cleaners. It just wears the enamel further and makes resurfacing more work.
Bath re-enamelling in Kyre without replacing anything
When a bath is structurally fine but worn out on the surface, re-enamelling is typically the most cost-effective option. It avoids removal, plumbing and re-tiling. Whether it’s staining under the taps and around the waste and enamel that’s lost its shine and feels rough, we can normally put it right.
You are covered for a year from the day of the repair. If anything isn’t right, ring us and we’ll come back.
- Location
- Kyre (WR15)
- Region
- Worcestershire
- Warranty
- One year on every repair
- Quote
- From £350. Free, fixed quote from pictures
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Common problems we fix in Kyre
The gloss on enamel is thin, and every scrub with an abrasive cleaner takes a little away. After years of use, the surface becomes porous and stains easily.
If you can see any of these, send us a picture:
- A coloured bath you want in white
- Staining under the taps and around the waste
- A peeling or bubbling previous coating
- Worn patches where water runs and sits
Before you book anyone
- What protection goes down before work starts
- How long it needs to cure
- Whether the price covers travel
- What preparation is included
Towns and villages near Kyre
Also in Kyre
What we do, step by step
Visits start with a quick look at the job together, so you know exactly what we’re doing. After that, protection goes down around the work area and we start. Allow the best part of a day.
- First we look the bath over and confirm the finish.
- Everything around the bath is masked and covered.
- We degrease the bath, fix any damage and key the surface.
- Primer and finish coats are applied.
- We remove the masking, tidy up and give you the curing time.
Preparing for the visit
- Point us to the nearest place to park
- Let the surface dry out before the visit
- Tell us about any previous repairs or coatings
Get a quote
Most clients in Kyre get their price from pictures. Tell us what happened and where you are, and we’ll reply with a fixed quote and the earliest dates we have.
Advice
Prices and what affects them
Resurfacing from £350. Prices are worked out job by job. What matters most is:
- Where the damage is and how we get to it
- What kind of damage it is
- Previous DIY repairs that have to come out
- The material and finish
It helps to know what pushes a price up or down: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Send pictures and you’ll get a fixed figure.
Quotes from your pictures
It only takes a minute to photograph the damage. Please include:
- A photo taken from further back
- Any details about the material
- A close-up of the damage, in focus
- A coin or ruler next to the damage for scale
To get a price, send a couple of pictures through our quote form or ring us. We will tell you honestly whether it can be repaired.
Should I try a DIY kit first?
A kit can be fine for a tiny mark out of sight. For damage in plain view, cracks, holes or rust, or coloured finishes, a professional repair is worth it.
DIY kits are sold for most surfaces, and they can make a small mark look better. Where they fall down is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler often lifts.
FAQs for Kyre
Is there a smell?
Some odour is normal while we spray, so we ventilate the room. It fades as the coating cures.
What if the damage is worse than the photos show?
We stop, show you and agree any change before carrying on. Nothing extra is done without your say-so.
How long is the bath unusable?
One day for most baths, ready the day after. We’ll confirm timings when we quote.
Can a failed resurfacing be redone?
Yes. Removing the old finish takes extra time, which we include in the price.
Are there extra charges for Kyre?
Travel is included in the price, and we charge the same wherever you are.
How durable is a resurfaced bath?
It depends on preparation, use and care. With good preparation and gentle cleaning it lasts a long time, and our work is guaranteed for a year.
Will the bath be moved?
Not at all. Everything is done in your bathroom, with the room protected and ventilated.
Can you repair something that’s been repaired before?
Usually, yes. We remove the old repair before doing a new one, so let us know about it.
Kyre and nearby
Kyre is about 9 miles east of Leominster, in Worcestershire. We agree a date that works for you, and we’ll give you an arrival time in advance, so you’re not left waiting in all day. Kyre is one of 376 towns and villages in Worcestershire where we work. You can also see our page for Birmingham, about 31 miles away.
Every address in WR15 is covered. Nearby, we also work in Nineveh (1 mile north), Bank Street (1 mile south-east), Bockleton (2 miles south-west), Oldwood (3 miles north-west) and Grendon Green (4 miles south-west). Within a short drive, we also cover Worcester (15 miles east), Kidderminster (15 miles north-east), Great Malvern (14 miles south-east), Stourport-on-Severn (12 miles north-east), Bewdley (12 miles north-east) and Malvern (15 miles south-east).
Around Kyre
Locally, our jobs take us to homes close to Church of St Mary, among other places. Further afield, we also cover the area around Bromyard Community Hospital (5.9 miles south) and Laysters Motte (3.6 miles west). The countryside around Kyre includes Page's Pasture.
Work for landlords and builders
For anyone letting property in or around Kyre, we’ll quote for several properties at once. Just send pictures for each address and we’ll come back with a combined price.
For developers and builders, we fix damage before handover, so there’s no need to replace a damaged item at the last minute. We can visit several plots in one trip to keep costs down.
Honest limits
We will always be straight with you, so here’s what a repair cannot fix:
- A bath that’s rusted through
- Acrylic that moves when you stand in it
- A bath split right through the body
If in doubt, send photos and we will say what we think before booking.
Materials we work on in Kyre
- Acrylic baths
- Pressed steel baths
- Cast iron baths
- Victorian roll-tops
- Basins & shower trays
Why repair rather than replace?
A new bath means a plumber, lifting out the old bath, re-tiling or making good the walls and days without a bathroom. Re-enamelling gives the bath a new finish without moving it. Our bath re-enamelling starts from £350. Compared with replacing, a repair is typically a fraction of the price, because there is no removal, plumbing or making good. The quote lists exactly what you’re paying for.
Why book with us
- Fixed prices from your pictures
- A year’s guarantee on all work
- Everything repaired in place
- We come to you, anywhere in the UK
Read our full price list and bath cost comparison.
About our accreditations · Every repair comes with a one-year guarantee.
