Cambridgeshire · England
Bath Re-enamelling for Pampisford homes
Bath re-enamelling for Pampisford, without a refit. Get a fixed quote from your photos, then book a visit.
- Resurfacing from £350
- A bath in a colour that no longer suits
- Worn patches where water runs and sits
Materials and what they mean for the repair
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Steel often rusts by the plughole, so we check it carefully.
Acrylic
Acrylic baths can be resurfaced too, with a coating system suited to acrylic. The bath needs to be firm and well supported for the finish to last.
How we handle bath re-enamelling in Pampisford
We clean, repair and prime the bath before spraying the new finish. Most of the work, and most of the durability, is in the preparation, and we take our time over it. If you’re dealing with a bath that stays dull however much you clean it and a peeling or bubbling previous coating, we can help.
All our work is covered by our one-year guarantee.
- Area
- Pampisford (CB22)
- County
- Cambridgeshire
- Guarantee
- 12 months on all our work
- Quote
- From £350. Free and fixed, from your pictures
- Telephone
- 0345 017 0787
- Updated
- 23 October 2026
Also near Pampisford
Other services in Pampisford
Repairing versus replacing in Pampisford
A refit takes several trades and several days. Re-enamelling takes one technician and usually one day, and the bath can be used the day after. Our bath re-enamelling starts from £350. Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Photos let us give you the exact figure.
Why us?
- Free fixed quotes from pictures
- CHAS, Constructionline and SafeContractor accredited
- We leave the room as we found it
- A year’s guarantee on all work
See our prices page and bath cost comparison.
What we do, step by step
Here’s how a visit typically runs: we arrive at the agreed slot, sheet and mask the area around the job, carry out the work and tidy away. Allow a full day from start to finish. Before we go, we’ll explain when it can be used and what to avoid for the first few days.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- We key the bath and apply a bonding primer.
- Several coats of finish are sprayed on, then it cures until the day after.
Getting ready for the visit
- Move bottles, mats and clutter away from the area
- Mention any earlier repairs or resurfacing
- Point us to the nearest place to park
How to get a price
No survey visit is needed: we price from photos. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and you’ll get a fixed figure back.
Read more
Covering Pampisford
Pampisford is about 7 miles north of Saffron Walden, in Cambridgeshire. Our work suits any type of property, from flats and terraces to detached houses and new builds, plus businesses and rented homes. Pampisford is one of 371 places in Cambridgeshire where we work. Our jobs stretch from Pampisford to London (about 44 miles away).
Our visits in CB22 work the same way as everywhere else we cover. You’ll find streets such as High Street, Church Lane and Town Lane, and we cover them all. If you’re just outside Pampisford, we cover Hanley Grange (1 mile south), Sawston (1 mile north-west), Whittlesford (2 miles west), Stapleford (3 miles north-west) and Little Shelford (3 miles north-west). Within a short drive, we also cover Cambridge (7 miles north), Newmarket (13 miles north-east), Royston (10 miles south-west), Cambourne (13 miles north-west), King's Hedges (8 miles north) and Arbury (8 miles north).
What’s near Pampisford
Around Pampisford, we work in homes near The Chequers pub, The Icknield Primary School and Sawston Village College. For rail, the closest station is Whittlesford Parkway station, about 1 mile south-west of the centre. A little further out are Royal Papworth Hospital (4.7 miles north-west) and American Air Museum (2.9 miles south-west). Open spaces near Pampisford include Little Trees Hill and Beechwoods nature reserve.
What a repair can’t fix
A repair is not right for every job, including:
- A bath split right through the body
- Holes rusted through the metal
- Anything hidden under an old coating, until we remove it
If in doubt, send pictures and we will say what we think before you book.
Materials we work on in Pampisford
- Pressed steel baths
- Acrylic baths
- Cast iron baths
- Basins & shower trays
- Victorian roll-tops
Common questions in Pampisford
Is it OK to have pets in the house?
Just keep them out of the work area. We’ll let you know when it’s safe to use again.
How long does re-enamelling last?
A well-prepared finish lasts a long time if it’s looked after. Avoid abrasive cleaners and suction mats.
What information do you need?
Use the quote form or ring 0345 017 0787.
Can I get a quote without a visit?
In nearly every case. We only ask to see it in person if the photos cannot show what we need.
Are you accredited?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
Is it messy?
We protect the room with dust sheets and masking first, and tidy up before we leave.
Does re-enamelling smell?
There is some smell while the coating is applied, which is why we ventilate the bathroom. It fades as the coating cures.
Can you fix a peeling bath coating?
In most cases. The old coating comes off before we resurface it. Tell us about it when you ask for a quote.
Work for landlords and builders
Rental properties take more wear, and replacing things at every changeover adds up. Repairing between tenants keeps the property presentable for less.
We also carry out snagging repairs for builders and developers, fixing chips and scratches before handover so nothing needs replacing. We are CHAS, Constructionline and SafeContractor accredited.
Should I try a DIY kit first?
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
You can buy a DIY kit for most repairs, and they can tidy up a tiny mark. The trouble is colour and preparation: kits come in a few standard shades, and without proper cleaning and keying the filler frequently lifts.
Looking after it afterwards
Simple care helps the repair last. Our advice:
- Dry the bath after use to stop limescale
- Get any chip repaired quickly
- Stick to gentle, non-abrasive cleaners
- Do not leave bottles, razors or sponges standing on the surface
Rinse away dyes, oils and bath bombs straight after use, because they can mark the finish. Fix dripping taps quickly.
Avoid scrubbing a dull bath with abrasive cleaners. It just wears the enamel further.
How we price bath re-enamelling
Prices start from £350. You won’t pay by the hour. The price depends on:
- Any earlier repairs that need removing first
- The colour and finish to match
- Whether we combine several jobs
- How easy the damage is to reach
No two jobs are quite the same, so we price each one individually. What’s damaged, how badly and how easy it is to reach all make a difference, and combining jobs on one visit brings the cost down.
Send photos for a quote
It only takes a minute to photograph the damage, and it saves a visit. Try to send:
- Any details about the material
- Details of any past repairs
- A picture taken from further back
- Natural light rather than flash
Email us a picture of the damage and one of the whole item, with your CB22 postcode, and we will come back with a fixed quote.
About our accreditations · Every repair comes with a one-year guarantee.
